Buscar en el registro

INJ WAS USING A DRILL PRESS WHILE WEARING GLOVESTHE GLOVE BECAME CAUGHT BY THE BIT AS HE TRIED TO DRILL A HOLE IN A RUBBBER WASHER FOR N-1 FLUME.

THE INJ WAS REPLACING DECK PLATE. HE WAS HOLDINGTHE PLATE AS HIS PARTNER CUT THE PLATE. DURING THIS TIME HE FELT SMALL SLAG PARTICLES HIT HIS FACE. THE NEXT DAY HE WENT TO THE DR TO HAVE THE SLAG REMOVED FROM HIS EYE. THE SLAG LEFT A RUST RING IN HIS EYE THAT HAD TO BE DRILLED OUT WITH A BURR.

THE INJURED WAS CHANGING A RETURN ROLL ON P-6 CONVEYOR. THE OLD ROLL HAD BEEN REMOVED AND THE NEW ROLL WAS BEING PULLED INTO POSITION. THE INJURED LOST HIS GRIP O THE RETURN ROLL AND HIS FINGE R WAS PINCHED BETWEEN THE PILLOW BLOCK AND THE FLOOR.

THE INJ WAS DRIVING A 150TON CAT TRK & HIT A POTHOLE IN THE ROAD. THIS CAUSED HIS BACK TO HURT SLIGHTLY THE NEXT AM HIS BACK HURT MORE & HEW WAS SENT TO DR. THE INJURY BECAME LOST TIME ON 3/16/00

THE INJURED WAS STRUCK IN THE MOUTH WITH A WELDING CABLE AS HE PULLED IT OVER A HANDRAIL.

THE INJURED WAS REMOVING A 77 POUND COUPLING HEAD FROM A REDUCER OUTPUT SHAFT. AS THE COUPLING CAME OFF THE SHAFT, IT FELL TO THE FLOOR. AS THE COUPLING FELL, IT STRUCK AN ANGLE AND RICOSHETTE D TOWARD THE INJURED, STRIKING HIM ON THE LEFT FOOT. BECAME LOST TIME ON 3/1/00.

THE INJURED PICKED UP A 104 POUND PIPE BRACE AND TURNED TO SET IT IN PLACE WHEN HE FELT BACK PAIN. HE WENT TO THE CHIROPRACTOR ON 02/24/00.

ON 2/21/00, THE INJURED REMOVED A SMALL SLIVER FROM HIS FINGER. ON 2/26/00, HE WENT TO THE DR BECAUSE THE FINGER WAS INFECTED. THE INJURY BECAME LOST TIME ON 3/2/00, BECAUSE HE REACTED TO THE MEDICATION AND BECAME VERY ILL.

THE INJURED SLIPPED ON ICE AND FELL ON HIS BACK, STRIKING HIS HEAD ON THE GROUND. ON 2-17-00, THE INJURED BEGAN TO LOSE TIME FROM WORK.

THE INJURED WAS WELDING ON THE SECOND FLOOR OF THE MILL WHEN A CLOUD OF DUST AND DIRT ENTERED HIS WELDING MUG FROM THE BACK. THERE WAS ANOTHER EE WORKING CLOSE BEHIND THE INJURED. THE RUST PAR TICLE WAS REMOVED FROM HIS EYE ON 1/21/00.

THE INJURED WAS CHANGING A HOSE ON THE 563 BACKHOE. THE 3/4 INCH END WRENCH SLIPPED OFF THE OILY HEAD AND PINCHED HIS FINGER BETWEEN THE STEEL SLEAVE OF THE HOSE AND WRENCH. THE BLOOD UNDER TH E FINGERNAIL WAS REMOVED BY A DR.

INJURED WAS STANDING ON THE FRAMEWORK OF H-2 TAIL PULLEY TIGHTENING A WEAR PLATE BOLT ON 202 SCREEN CHUTE. AS HE DID THIS HE SLIPPED AND STRUCK HIS RIBS ON A WATER PIPE ELBOW. HE GRACTURED TWO RIBS. THIS WAS DETERMINED ON 1-24-00, AFTER GOING TO SEE THE DOCTOR.

INJURED WAS PULLING A PIPE WITH A 2" CABLE AND A FRONT END LOADER. AS THE INJURED DISCONNECTED THE CABLE FROM THE LOADER, IT FLIPPED UP AND STRUCK THE INJURED IN THE NOSE.

INJURED BURNED OFF CS-1 MOTOR MOUNT BOLTS AND LAID THE LIT TORCH ACROSS HIS LEFT FOREARM WHILE HE HAMMERED THE BOLTS OUT. AS HE DID THIS THE LIT TORCH SLID DOWN HIS ARM AND BURNED HIS LEFT HAN D.

THE INJURED BURNED OUT A RETURN ROLLER BRACKET AND USED A GRINDER TO REMOVE THE SLAG. WHEN HE FINISHED HE FELT SOMETHING IN HIS LEFT EYE. ON 11/8/99, HE WENT TO THE DOCTOR AND HAD A SMALL PART ICLE REMOVED FROM HIS EYE. DOCTOR GAVE HIM A PRESCRIPTION EYE MEDICATION.

THE INJURED WAS REPAIRING WORN STEPS BY L-1 CONVEYOR. HE CUT LOOSE A BAD STEP & SET IT ON THE FLOOR AS HE TWISTED. WHEN HE DID THIS HE FELT A PULL IN HIS BACK. THE NEXT DAY HIS BACK HURT AND ON 9/20/99 THIS CASE BECAME LOST TIME.

INJURED WAS INSTALLING WEAR PLATES IN CHUTES. AFTER THE JOB WAS DONE THE INJURED HAD A SORE BACK.

INJURED WAS HELPING TO INSTALL THE DOME ON THE PRIMARY CRUSHER. AS HE TWISTED AND BENT OVER TO PICK UP A 15 LB AIR GRINDER, HE FELT PAIN IN HIS BACK. HE WAS TREATED BY A CHIROPRACTOR.

INJURED WAS GOING TO HOOK A WEARPLATE TO THE OVERHEAD CRANE AND NOTICED THE CRANE BLOCK WAS HANGING CROOKED. AS HE TRIED TO STRAIGHTEN THE BLOCK IT ROLLED AND PINCHED HIS INDEX FINGER.

INJ WAS USING A PRY BAR TO OPEN A 20" WATER VALVE IN THE PUMPHOUSE AS HE APPLIED PRESSURE TO OPEN THE VALVE, THE BAR SLIPPED & CUT HIS THUMB

INJURED TRIED TO CHECK THE HEAD PULLEY INSIDE THE CRUSHER CHUTE FOR STONE. SHE CLIMBED ONTO THE MIDRAIL OF A HANDRAIL TO LOOK INTO THE CHUTE AND SLIPPED. SHE STRUCK HER NECK ON THE CHUTE AND B EAM. SHE SAW A CHIROPRACTOR FOR TREATMENT.

THE INJ WAS DOING A SAFETY INSPECITON IN THE SHOP. AS HE WALKED THRU THE SOWEST DOOR TO LEAVE THE SHOP, HE STRUCK HIS HEAD ON THE DOOR CLOSINGCYLINDER ON 10/6/99 THIS INJURY BECAME RESTRICTE D WORK AND ON 10/12/99 THE CASE BECAME LOST TIME

THE EMPLOYEE WAS INSTALLING A RETURN ROLL ON AN RC-11 CONVEYOR. AS HE PREPARED TO INSTALL THE RETURN ROLL ONTO THE HANGER, IT HUNG-UP AND THEN DROPPED INTO THE SLOT, PINCHING THE EMPLOYEE'S RI GHT MIDDLE FINGER.

INJURED WAS TIGHTENING THE MOTOR BOLTS DOWN ON THE TELSMITH CRUSHER IN THE MILL SCREENHOUSE. SUDDENLY THE WRENCH SLIPPED OFF THE NUT AND THE INJURED STRUCK HIS RIGHT ELBOW ON A HANDRAIL POST. HE RECEIVED A CORTISONE SHOT ON 7-16-99.

INJURED CLIMBED ONTO NT-2 CONVEYOR TO ATTACH A SPLASH GUARD ON RC-10 CONVEYOR. AS HE DID THIS HE STRUCK HIS HEAD ON A STRUCTURAL I BEAM AND JAMMED HIS NECK. ON 8-2-99, HE BEGAN TO LOSE TIME BE CAUSE HE NEEDED SURGERY ON HIS NECK.

INJURED WAS GRINDING THE RINGS ON THE 20 INCH FRESH WATER PUMP MOTOR IN THE MAIN PUMP HOUSE. WITH A SMALL STICK STONE GRINDER HE REACHED AROUND THE GUARD WITH THE MOTOR RUNNING. AS HE TOUCH ED THE RING WITH STONE THE STICK CAME BACK AND STUCK HIS PALM WHICH CAUSED A LACERATION.

INJURED WAS UNLOADING A TRUCK OF SUPPLIES AND HAD TO RELEASE A CHAIN BINDER BY PULLING UP ON THE HANDLE. WHEN THE BINDER BROKE LOOSE THE HANDLE HIT HIM IN THE RIGHT KNEE. BECAME LOST TIME O N 3-16-99.

INJURED WAS USING A SLEDGE HAMMER TO LOOSEN THE POCKET STOPS ON 66 DRILL. THE NEXT DAY THE INJURED REPORTED THAT HE HAD PAIN IN HIS RIGHT SIDE STOMACH AREA.

THE INJ MOVED A TORCH SET FROM ONE LOCATION TO ANOTHER. ABOUT 1 HALF HOUR AFTER THIS HIS BACK BECAME SORE. BECAME LT ON 2/17/99

INJ WAS CLIMBING ON P-2 BOOM XBRACING WHEN HE FELT HIS RIGHT KNEE GIVE OUT. HE WENT TO THE DR ON 2/12/99 BECAME T ON 2/15/99

THE INJURED STRAINED HIS CHEST AS HE MOVED A HEAVY CHUTE GATE THROUGH L-3 TUNNEL. INJURY BECAME LOST TIME ON 2/22/99.

INJURED WAS WORKING ON THE #680 CAT LOADER WHEN HE STRUCK THE MIRROR BRACKET WITH HIS HARD HAT. THIS CAUSED A NECK STRAIN TO THE INJURED.

INJURED WAS CHIPPING SLAG WITH AN AIR CHIPPER WHEN HE FELT SOMETHING IN HIS RIGHT EYE. THE DR. REMOVED A FOREIGN BODY FROM HIS EYE AND GAVE HIM AN ANTIBIOTIC OINTMENT.

CLEANING UP SCRAP STEEL FROM FLOOR, WHEN HE EXPERIENCED BACK STRAIN.

INJURED WAS BURNING OUT CHUTES WITH A TORCH AND RECEIVED SEVERAL SMALL BURNS ON HIS LEFT FOREARM. ON 1-10-99, THE INJURED'S LEFT ARM BECAME INFECTED.

INJURED WAS IN THE PROCESS OF GOING HOME AT THE END OF THE SHIFT. AS HE WAS GOING DOWN THE WOODEN STEPS AT THE S&T TRAILER, HE SLIPPED AND BRUISED HIS RIGHT KNEECAP.

THE INJ PARKED THE PU TRUCK AS HE WAS DRIVING BY THE MILL OFFICE. AS HE GOT OUTOF THE PU TRUCKHE FELT PAIN IN HIS LOWER BACK

THE INJURED WAS HAULING G-2 PRODUCT TO THE QUARRY FOR PLANT USE. THE LOADER OPERAQTOR NOTICED THE INJURED STANDING OUTSIDE THE CAB UNDER THE TRUCK CANOPY. IT IS BELIEVED THE INJURED WAS WALKIN G BACK TO THE CAB WHEN HE LOST HIS BALANCE AND FELL/JUMPED OFF THE TRUCK 12.5 FEET TO THE GROUND. THE LOADER OPERATOR NOTICED WHAT HAD HAPPENED AND CALLED HELP.

INJURED WAS WORKING ON 539 DOZER SIDE FRAMES. HE WAS KNEELING AND THEN STOOD UP AND STRUCK HIS LEFT KNEE ON THE SIDE FRAME. HIS KNEE SWELLED UP SEVERAL DAYS LATER AND HE WAS SENT TO THE DR. ON 10-14-98. LOST TIME ON 10-15-98.

THE INJURED WAS HELPING THE WELDER REPAIR 401 SSCREEN IN THE MILL BUILDING. A STEEL PATCH HAD TOBE WELDED ON THE SCREEN. THE INJURED HELD THE PLATE IN PLACE WITH A PRY BAR AS IT WAS WELDED TO THE SCREEN. AFTER THE PATCH WAS ATTACHED TO THE SCREEN THE INJURED REMOVED THE PRY BAR AND AN ELECTRIC ARC OCCURRED CAUSING A BURN TO THE INJURED'S FINGER.

INJURED WAS REMOVING THE P-5 BELT SCRAPER WHEN IT FELL AND PINCHED HIS LEFT THUMB CAUSING AN 11 SUTURE LACERATION.

INJURED WAS KNOCKING ANGLE BARS OFF RAIL WITH A 6 POUND SLEDGE HAMMER WHEN HE FELT A SHARP PAIN IN HIS LEFT SHOULDER. THE DOCTOR GAVE HIM AN INJECTION IN THE LEFT SHOULDER.

CAUGHT HIS HAND BETWEEN THE TRANSMISSION HOUSING AND THE LIFTING SLING, CAUSING A FRACTURE TO HIS SMALL FINGER--RIGHT HAND.

A FOUR FOOT PRY BAR SLIPPED OUT FROM HIS HAND AND HIS TOE WAS HIT WITH THE BAR BEHIND STEEL TOE.

REPLACING MASTER LINK ON LEFT TRACK ON 541 DOZER WHEN THE LINK SLIPPED AWAY PINCHING EMPLOYEE'S FINGER (FRACTURE) LOSS TIME JULY 10, 1998

FIRE AND OR STRUCTUREAL DAMAGE TO THE MILL SCREEN HOUSE, MILL ELECTRICAL SUBSTATION, P-DRIVE, PRIMARY SCREENING STATION, P6 CONVEYOR AND GALLEY.FIRE AND STRUCTUREAL MILL NORTH SIDE WITH P-6 GA LLEY RESTING ON MILL 8TH FLOOR ROOF, CS-2 GALLERY AND THE PRIMARY SCREENING STATION ROOF.

EE WAS CLEANING A SWITCH WITH SOME HI TECK CLEANER, AS HE SPRAYED SOME OF THE CLEANER BOUNCED BACK HITTING THE UNDERSIDE OF HIS HARD HAT BRIM AND FELL INTO HIS EYES.

EE WAS IN THE PROCESS OF CLIMBING UP LADDER OF 6 TRUCK CAT AS HE WAS CLIMBING HE FELT PAIN IN HIS LEFT LEG.

EMPLOYEE WAS TORQUING THE TRACK ROLLER BOLTS UNDER DOZER 541, THEY WERE USING A 18-1 TORQUE MULTIPLIER. EMPLOYEE FELT LOWER BACK STRAIN. HE SAW A CHIROPRACTOR.

EE WAS USING A PIPE WRENCH TO TAKE END OFF OF A CYLINDER FROM A 762 GRADER WHEN THE WRENCH SLIPPED CAUSING LEFT SHOULDER PAIN. HE SAW A DR. ON 6-30-98 AND STARTED THERAPY.