Cada lesión y muerte que la MSHA tiene registrada. Filtra por estado, año, sector, clasificación, experiencia o cualquier palabra clave de la narrativa del investigador.
Envíame un correo cuando un nuevo incidente coincida con estos filtros. Un correo de confirmación; cancela la suscripción cuando quieras.
Operator was loading trucks steadily throughout the day when EE starting getting unbearable neck/back pain. Suspected cause was twisting and jarring from forklift.
Employee was operating haul truck near the new pond when a light vehicle pulled out in front of EE causing EE to lock up the brakes resulting in aggravation of the lower back.
The operator was pushing material and constructing a ditch with a dozer in order to convey water away from the dig face. At the end of shift the operator reported to the pit lead that neck was sore when they tried turning head. Employee could not pinpoint a single event or time that caused the soreness.
While going down the stairs in Robo 2 the operator lost footing and rolled ankle.
Employee was enlarging a 9/16" hole in a stainless steel transition for a slide gate when the drill bit, bit on the edge of the hole and the drill twisted in the employees hand, twisting EE's wrist. Employee was fine but woke up the next morning with minor swelling.
Two employees thought they had a piece of pipe secured when the pipe started to roll off of the compressor. Once employee reached out to stop the pipe from rolling and did keep it from falling off of the compressor. The next day the employee woke up with a sore shoulder and suspected that EE had aggravated an old injury.
Employee was hanging a bulk bag and missed the hook, causing right hand to make contact with the steel bracket. Currently a strain/sprain requiring immobilization.
Lab Technician slipped and fell while walking up to/reaching to open the door of the Ambulance Barn. Diagnosed with a fracture to the left wrist.
Employee was working in the lab sink cabinet underneath changing the sink faucet. They twisted to wrench off a water supply hose and felt a twinge in left hip. It didn't feel like much. Finished the job in about 45min total but the job took over 2 hours while waiting on parts. Injury resulted in need to have back and hips aligned by a chiropractor.
Employee had descended into a trench (approximately 3 feet deep X 6 feet wide) at the water pond area of the mine and was climbing up the other side when they felt a pop in their right calf muscle. The employee was later diagnosed with a partial tear to the calf muscle.
While standing at the counter in the lunch room the employee turned and felt EE's knee pop. The employee called a few hours later to report the pain.
Operator was trying to align a chute and sliding collar in place, pushed too forcefully, and felt a pain in right arm/elbow. Iced and cared for. Did not fully improve over the course of a month. Results now show partially torn biceps muscle.
Employee slipped on a step while performing maintenance on a palletizer. Footing was not secure, access step is narrow, rushing/frustration, some talc on the surface from bag that broke. Sprained knee with possibly more damage - waiting on MRIs - out of work.
2 employees were manually rolling pellet mill die to test roller tightness when IE pinched the left middle finger between the pellet mill die and the roller resulting in a severe laceration requiring 3 stitches.
Employee was prying bearing housing off with pry bar on a rotary and was exerting a lot of force when pry bar slipped and they felt their right wrist pop and there was an immediate sharp pain.
Operator reports pain in neck and shoulder. Can't identify incident causing pain but says pain gets better when not at work, operating the forklift exacerbates the pain. Felt tingling in neck 3/8/19. Employee was seen at the local clinic and prescribed physical therapy. The case was diagnosed as an occupational illness 5/7/19.
When loosening bolt socket came off and thumb hit sidewall of housing between ratchet handle and the side wall. Thumb is sore and swelled some ice and Ibuprofen was used at home. Thumb is sore and has some limited range from stiffness and swelling but has a limited range of motion at this time.
Two employees were holding a magnet and began lowering it to the ground. Employee #1 released sooner than employee #2. The left index finger of employee #2 was pinched between the magnet and the concrete floor. On 2/22 Employee #2 requested to be seen by a physician who diagnosed a fingertip fracture, along the side of the nail wall and a hematoma beneath the fingernail.
Moving a steel beam - beam rolled into ankle
Employee was turning the pellet mill with a crowbar when it slipped and employee stumbled, twisting right ankle and putting excessive weight on it. Sprained ankle.
Operator sustained a fracture to right big toe when a Skidsteer Loader Bucket slipped while the employee was in the process of training coworker on the bucket change out procedure. The bucket which dislodged from the hydraulic lift assembly, dropped approximately 6 inches striking the employee across the steel toe of work boot.
Employee was repairing a broken wooden pallet with a hammer and nails. Employee missed the nail and struck their left thumb with the hammer, resulting in a cut, bruise, swelling, and hairline or "turf" fracture.
On 9/28/18 employee reported left shoulder pain. On 9/11/18 Employee felt tweak in shoulder after attempting to lift the outside ring for pellet die into place. Employee did not report immediately as EE thought it was just a minor strain or bursitis that would improve. Pain got worse over time. Employee was seen at the clinic on 10/3 and was put on restricted duty.
A Third Party finished product truck driver for trucking company sustained sunburns to both eyes as a result of locked out workers deflecting sunlight with a hand held mirror into the truck drivers eyes.
Employee lacerated the base of right middle finger while removing an oil pan adapter plate from a surface mine hydraulic shovel.
Operator was performing general housekeeping (sweeping) when EE felt a pull/bee sting burning sensation in EE's left shoulder. Mobility of arm was impacted.
Employee reports lung sensitivity to chemical and requested Dr visit. Initially seen and released to full duty 6/15/18. EE sought full work restriction 6/18/18 which was granted by Physicians Assistant for 5 days 6/18 - 6/22. Employee resigned/retired effective 6/20/18.
Employee was assisting two other maintenance employees in guiding the tail end of a bucket elevator conveyor belt through the shop by sliding it while the forklift pulled the opposite end of the belt to position it for a crane lift. When IP bent over to guide the tail end of the belt around a workbench by sliding it on the floor, IP felt a tearing sensation in left groin.
Employee alleges that employee strained left shoulder on 3/21/18 barring wet material from feed system. Incident was not reported to the company until 04/09/18. Employee provided doctor's note on 4/09/18 stating need for light duty.
Utility operator strained right on 3/16/2018 using a sledge hammer and placing rail car vibrators. Operator initially denied medical treatment but did seek medical attention on 5/10/18 followed by acupuncture on 5/10/18. Treatment continues without restrictions
Employee slipped on ice exiting a front end loader. The employee reported the event but did not seek medical attention until 11/7/17. The employee has had 2 chiropractic adjustments with no time loss or work restrictions.
Employee reports numbness in both wrists, initial diagnoses by PA is bi-lateral carpal tunnel syndrome. Further testing to be completed to confirm diagnoses and determine course of treatment.
Employee was manually handling mill parts when employee strained employee's Left Biceps muscle
Individual had a piece of metal fall and hit hardhat. It then cut the back of EE's neck. Six stitches. No lost time.
Moving a Rol-a-Lift to trailer to be picked up, the piston was unsecured, lifted up and pinched the employee's right index finger. Deep laceration, finger tip fractured, and part of finger tip partially amputated, but re-attached and expected to heal.
Two middle fingers were caught between derailer and railroad track when switching derailer to closed position. Employee sustained a cut to third finger which required two sutures and the fourth finger sustained a hairline fracture. In accordance to company policy, the employee underwent drug and alcohol testing which yielded a failed result.
Employee was assisting maintenance in the rebuild of a piece of processing equipment, EE jammed left middle finger while positioning a component. The injury was diagnosed as a fracture.
Employee strained right biceps muscle lifting a 10 HP Motor on 2/17/16. The employee sought medical attention and received an MRI on 2/22/16 at which time EE was diagnosed with a muscle tear. On 2/29 the employee was seen by an orthopedist who determined that surgery was not required. The employee is restricted from climbing and issued 6 weeks of physical therapy
While pushing off & away from a rail car EE reports feeling a pop in left wrist. Preliminary x-rays show no fracture however a splint was prescribed as a precaution. Follow-up med. exams may be necessary to rule out fracture. EE was released & continues to work w/restrictions. Update: Further exam revealed ruptured tendon requiring surgery on 2/9/16. EE restricted from work 2 wks.
Operator was performing pre-use inspection on Telehandler. EE was exiting the cab while holding the steering wheel and door handle bar, lost EE's footing, and caught self with EE's right arm that was still holding on to the steering wheel. When EE did, EE put all EE's weight on EE's right arm/shoulder.
Employe diagnosed with bi-lateral carpal tunnel syndrome. Employee has not missed work or been restricted, however surgery is pending workers compensation approval
Employee reports feeling a pop in his keft wrist while extracting a spring loaded truck dock barricade in place.
Finishing work at the cone crusher, operator lifted his leg up onto the platform, pushed himself upwards, and felt his knee twist. Operator iced the knee until he was able to walk on his own. Employee returned to work the next day. Employee made an appointment with his regular physician. On 2/26/15, the employee was told that he had torn a muscle and would need surgery to fix it.
Employee diagnosed with Noise Induced Hearing Loss requiring the use of hearing aids
Employee strained right shoulder while assisting in demolition and reconstruction of a packaging line palletizing unit.
Employee strained intercostal muscle of his left chest area while attempting to lift the cover of a product transfer conveyor
Lifting siding sheet with pulley and rope. Was almost to top. EE had his hand over the edge. His finger got caught between the sheet and a piece of steel.
Employee reports backing into a stationary roof support pole while operating a forklift. The employee reported neck and shoulder pain but denied medical attention at the time of the event. The employee request a medical evaluation on 7/8/14 as the pain persisted. The employee was diagnosed with a right shoulder (rotator cuff) strain and prescribed physical therapy.
Employee slipped on a flat surface, grabbed loader ladder to break fall, strained right shoulder. No medical treatment sought until 4/21/14, Physical Therapy Prescribed following 4/21/14 medical examination.
Left long finger was pinched between the Pellet Mill die and the compaction rollers which are located inside the die. The system was locked out and the employee was manually rotating the die while another employee adjusted the compaction rollers. Sutures were required.