Buscar en el registro

A manual slide gate closed too quickly on a miners right hand. The impact caused a fracture and a laceration requiring 8 stitches.

The employee was attempting to determine the cause of vibration alarms, and while feeling for vibration, their hand was able to enter the guarded area, which resulted in right pinky finger making contact with fan blades, resulting in the avulsion of the distal end of their finger. The employee did not lose the whole finger, but the flesh on the tip of their finger.

Miner was switching railcars, drove a buggy between a car being pushed and another parked, and was struck, causing EE's leg to be entrapped between the dash and seat.

Employee was sick from being dehydrated.

The mine site was thawing out from a recent cold weather spell that allowed for the roads and pads to thaw. This created an increased instances of thick mud around the mine.

Sunny, incident occurred indoors with full lighting. The injured party suffered burns to both hands (non-life threatening) while installing a ground inside an MCC. The ground wire recoiled due to line memory and rebounded once let go into the adjacent bus bar creating the arc.

Employee was exiting truck when EE rolled EE's right ankle while putting foot on ground.

IP was climbing down a ladder, grabbed a swing gate for support, the swing gate broke loose and the IP lost their grip and fell less than 3 feet. The fall resulted in a sprain to the right foot and ankle.

Miners working to clear out a clogged screw conveyor, miner didn't follow the company Lock out/tag out policy and caught their finger in the upstream screw causing an amputation of the left hand ring finger distal phalanges.

IP was directing vehicle traffic and tripped on a concrete ledge resulting in a sprained ankle.

The employee used their right hand to wipe clean the underside of the trough, in doing so the employee's middle finger proceeded to enter through the hole and contact the rotating screw conveyor.

The EE was cleaning out of the bottom door on the bucket elevator. The top door was held open with a bungee cord, the bungee cord let go and the door closed on their thumb.

EE was using a sledge hammer to straighten door frame. hammer glanced off frame and thumb and handle struck the corner of the frame.

Employee strained left arm performing housekeeping.

Employee's left middle finger was caught between two fully stacked pallets on a roller belt, resulting in a contusion to the left middle finger.

Employee twisted left ankle on a rock. EE's ankle proceeded to swell and become weak and painful.

EE was fitting a piece of angle iron when their left thumb got crushed between the iron and coworkers foot.

Employee was digging out a screw and lacerated right hand receiving stitches.

Employee felt shoulder strain when opening a hatch on top of a bulk semi trailer.

Employee strained ankle walking into work.

Employee was removing a boom pin from a scaler and felt discomfort in EE's left bicep.

Employee felt strain to left leg knee when descending staircase. Employee has had a prior injury to this knee in high school.

Miner was working in man lift when EE accidently switched the lift into high gear. The lift hit a large, hidden rock and jolted several times. The miner's lanyard shortened with each jolt and EE could not dislodge EE's foot from the dead man's switch. EE sprained EE's right ankle.

Pinched finger between rope and handrail, pulling finger apart requiring 11 stitches in finger. Return to work next day on light duty at office.

773 haul truck went over the edge of a 20' high stockpile. The truck driver suffered a minor laceration to the head and was taken to the hospital where EE was administered 6 staples to close the wound.

Employee sat the wagon down on the track, the motor revved up and took off uncontrollably and hit the car. Shuttle wagon maintenance repair, arrived on site and did an inspection/functions test and was unable to find anything wrong with the wagon.

One employee shot another employee. Investigation pending.

Employee was driving man lift across track 3 crossing; man lift bounced EE up causing EE to strike EE's leg on the man lift tray under the controls. Employee suffered a break to tibia, fibula and bone was jammed up under kneecap.

employee was cutting hose to move truck, was attempting to cut hose with safety knife when it slipped and cut hand

Swapping bucket tips from bucket to another. Struck bucket retainer lock with hammer and chard of metal broke off striking employee in right knee.

Employee strained lower back lifting a motor with a coworker. This was a two person lift.

Employee was in breakroom before EE's shift started and was opening a container with personal knife and accidentally lacerated EE's wrist.

Bulkloader was leaving scale house, stepped on rock and rolled ankle.

Employee tripped on a metal bar causing them to fall into guard and fracture left hand.

employee was sitting on top of the trailer tank and went to pull themselves up when they felt a burning in left hip.

Employee was crossing tracks in Shuttle wagon and brakes stop working. The shuttlewagon to hit tracks hard causing EE to bounce in seat, jamming EE's back.

Employee noticed a sump pump was not working. When they walked out to the pump they slipped, twisted ankle and landed hard on back. Employee went to ER for eval. and xrays. No broken bones. On 09/29/20 employee complained that ankle was still hurting. We took them to Ortho & They found a break in the femur above the ankle, put them in a boot.

Equipment operator was using a pry bar to clear jam at crusher when bar slipped and they smashed finger requiring 14 stitches.

An operator was descending down a set of stairs located at the back of the warehouse. The operator missed/ slipped on the last two steps resulting in a fall. The operator claimed to have no injuries but was sent to the local medical facility for a proper diagnosis. The employee indicated that they were using the handrail at the time of the incident & there were no witnesses.

The employee was walking on sloped concrete near plant 32 truck loading when employee slipped and fell. There was a thin layer of slurry type material that has washed there from the 1" of rain we got overnight. As employee fell employee tried to catch self with right hand. Employee's right ring finger was bent during the fall and resulted in a fractured finger.

The employee was working on a hub assembly of a cage mill. While trying to turn the hub and shaft employee's hand slipped. The rough worn surface had a sharp edge that cut through employee's glove causing a laceration on the palm near right thumb. It required 4 stitches with no restrictions. The employee removed own stitches on 5-25-2020.

Miner dismounted dozer to go to the restroom, when mounting dozer miner's foot slipped off the step causing the miner to catch self with the left arm.

Employee pulled a groin muscle trying to adjust a bulk bag on a pallet as EE was beginning to fill. EE felt a sharp pain. EE was taken to the local ER where EE was diagnosed with a strained left groin. EE has been placed on light duty for one week.

Employee pulled up in a back hoe to address EE's union rep. When EE went to climb over a one foot wall EE's foot slipped and EE fell, straining EE's shoulder.

Contractor was cleaning and picked up heater to move it. While moving the heater, two elements burned out and heater started sparkling. Contractor threw heater down, ran away and twisted EE's wrist.

An operator was walking to the break room. EE stepped in a hole (grass was grown over the hole) and EE rolled ankle. It was diagnosed as a fracture.

An operator lacerated and fractured finger while closing a Victaulic valve using a hammer. The operator missed the valve handle with the hammer striking the tank with the hammer. After the hammer head struck the tank the travel of the handle continued pinning the operator pinky finger between tank and the hammer handle. Operator removed glove to find the finger lacerated.

Employee was laying down a water pump that weighed 86 lbs. As they were laying the pump down their right hand ring finger was smashed fracturing a bone in the finger.

Employee was assisting in removing material from the "short" belt. While doing so, employee felt a pain in lower left leg. Employee reported the injury the following day. Diagnosis strain on 6/25, no treatment, and returned to full duty. Recheck on 6/26/19, prescribed physical therapy which classifies it as medical treatment.