RiverBend Materials Turner South Metal/Non-Metal

WHILE USING A HIGH PRESSURE HOSE TO CLEAR A CLOG, FROM AN UNLOAD HIS FOOT SLIPPED. HE DID NOT FALL BUT TWISTED . HE HEARD A "POP" AND PAIN PROGRESSED TO SEVERE. POSSIBLE TORN TENDON IN LEG.

Employee was working on a screen and twisted his knee.

ADJUSTING TAIL PULLEY ON #1 FEEDER WITH A WRENCH AND THE WRENCH SLIPPED OFF THE NUT THE FORCE USED MADE FACE HIT I BEAM THAT IS PART OF THE WALL.

THERE WAS A FULL LOAD ON STOCK PILE TRUCK. EMPLOYEE WAS GOING TO TURN RIGHT. HE HIT SOME BUMPS ON THE DIRT ROAD AND THE TRUCK FLIPPED OVER.

I WAS DOING SOME CUTTING AND GRINDING I WAS WEARING SAFET7Y GLASSES AND STILL GOT A PIECE OF METAL IN MY EYE.

WORKING ON AND INSPECTING FEEDER, EMPLOYEE SLIPPED. MOVED HAND TO STEADY HIMSELF. GLOVE CAME INTO CONTACT WITH ROLLER AND PULLED HIS HAND INTO BELT AND ROLLER.

WHILE TIGHTENING A LARGE BOLT ON FEEDER #1 EMPLOYEE WAS LIFTING HARD AND FELT HIS BACK STRAIN.

CLIMBING UP ON IMPACT CRUSHER, USING LEFT LEG TO PUSH MYSELF UP. I STRAINED THE INSIDE OF LEFT KNEE AND HIP.

POWER TRAILER HAS A LOW AREA-EE WALKED INTO IT WITH HIS HEAD-HE WAS WEARING A HARD HAT. NECK & LEFT SHOULDER & ARM.

WHILE CLEANING MATERIAL OFF THE INSID EOF THE 1/4-0 SILO SOME MATERIAL BORKE LOOSE & BURIED HIS RIGHT LEG, PUTTING SIDE PRESURE ON HIS KNEE.

WHILE LAYING ON A FLATBOAT SO HE COULD SEE TO WELD DOWN & WNDER THE AREA TO BE WELDED HE WAS CHIPPING AWAY THE SLAG. A PIECE OF METAL FELL INT HIS RIGHT EYE.

SLIPPED INSIDE ROCK BUNKER AND FELL ON LEFT SHOULDER EE WAS CHECKING ON A CHAIN ON A CONVEYOR BELT INSIDE THE CRUSHER BLDG.

EE WAS CUTTING A CONVEYOR BELT IN A VERY CLOSE AREA THE UTILITY KNIFE SLIPPED AND CUT HIS LEFT KNEE REQUIRING STITCHES.

EMP WAS STANDING ON THE EDGE OF THE CONVEYOR TRYING TO UNPLUG A CHUTE. IT WAS WET AND MUDDY AND HIS FEET SLIPPED OUT FROM UNDER HIM AND HE FELL LANDING ON A 1/4" PLATE EDGE ON HIS CHEST.

EMP WAS USING A RAZOR KNIFE TO PEEL BACK THE RUBBER COATING ON AN ELECTRICAL WIRE AND THE KNIFE SLIPPED AND HE CUT HIMSELF.

STEPPED DOWN FROM THE CRANE AND STEPPED ON A SLIPPERY 2X12 AND MY FEET SLIPPED OUT FROM UNDER ME AND I LANDED A STRADDLE A 6" METAL OUTRIGGER ON THE CRANE AND LANDED ON MY BOTTOM.

A PIPE THAT WAS GOING TO BE THE MAIN WATER SUPPLY TO THE PIT WAS BEING FLARED WITH A BELLING TOOL SO THAT IT COULD BE JOINED TO ANOTHER ONE OF THE SAME SIZE. THE BELLING TOOL WAS BEING STRUCK BY ANOTHER WORKMAN. PIECES OF METAL SHATTERED AND HIT EE IN THE LEFT HAND.

HE WENT TO CHECK ON THE START UP OF THE ROCK SCREENING EQUIPMENT, WHILE STANDING ON THE CATWALK NEXT TO THE SCREENING EQUIPMENT THE SUPPLY CONVEYOR COLLAPSED. THINKING HE MIGHT BE SAFER SOMEWH ERE ELSE HE JUMPED APPROX. 20 FT AND LANDED ON ROCK COVERED GROUND. FALL CAUSED BACK INJURY, VETTABREA WAS CRUSHED.

SIGN DISPLAYING HARD HAT AREA ONLY WAS PLACED PARTIALLY ON WALKING BRIDGE THAT LEADS FROM PARKING AREA. ID DN'T SEE SIGN WHICH IS NORMALLY LOCATED ELSEWHERE & I TRIPPED ON IT & FELL TWISTING K NEE.

I NAME WAS INSTALLING A NEW SPRING ON THE SCALPER SPRING WEIGHT 50# AS IT WAS BEING INSTALLED IT FELL OUT OF PLACE BUT HE CAUGHT IT & IT CAUGT HIS RING FINGER ON HIS LEFT HAND BETWEEN THE SPRI NG & A BEAM

HAD FINISHED INSTALLING SOME BELTS ON A SCREEN AND WAS IN THE PROCESS OF TIGHTNING THENUTS THAT HOLD THE MOTOR IN PLACE THE NUT ON THE BOLT HE WAS PULLING ON STRIPPED AND CAUSED THE WORKMAN TO PULL A NECK MUSCLE

EMPL TIGHTENING BOLT QTR-TURN AT TIME,CONTINUED UNTIL WRIST SNAPPED SENDING SHARP PAIN THROUGH HIS ARM.

LOOKING IN BONE YARD FOR PIECE OF STEEL WHEN HE SLIPPED & FELL ON RIGHT KNEE. COUPLE OF MONTHS LATER HE WAS RUNNING & LEFT FOOT STRUCK PIECE OF METAL WHICH IN TURN FLIPPED ANOTHER PIECE OF MET AL & FLIPPED PIECE STRUCK RIGHT KNEE.

WORKING ON THE CRUSHER DOING SOME WELDING ON THE FIRST SCALPER A SPARK FROM THE WELDING AREA BURNED THRU THE HOSE AND THE GAS IGNITED ABOUT 4 IN BEHIND WHERE I WAS HOLDING THE TORCH AND THE F LAME BURNED INSIDE OF MY GLOVE BURNING MY LEFT INDEX FINGER

DRIVING DUMP TRUCK STOCKPILING GRAVEL. I TURNED TO LOOK OVER MY SHOULDER AS I WAS BACKING UP & PULLED MUSCLES IN MY LEFT SHOULDER.

THE INJURED WAS3OPERATING A SCRAPER OVER AROUGH ROAD AND HIT A HOLE WHICH BOUNCED HIM AROUND AND HURT THE AREA ABOUT THE KIDNEYS.

HE WAS TAKING A3PATCH FOR THE SAND CLASSIFIER UP THE LADDER IN HIS LEFT HAND AS HE CLIMBED HE LOST HIS GRIP ON THE RAIL AND SLIPPED DOWN THE LADDER ABOUT 4 FT AND FELL AGAINST A GUARDRAIL STR IKING HIS RIBS 3

HE WAS TAKING A3BREAK. HE WENT TO THE LABORATORY BUILDING TO GET A SOFT DRINK FROM THE VENDING MACHINE. AS HE WAS LEAVING HE HAD A HEART ATTACJ AND FELL TO THE FLOOR.

HE WAS PUTTING 5WAY THE STEAM CLEANER THE MACHINE WAS TURNED OFF AND THE HOSE AND ELEC CORD PUT AWAY. AS HE DISCONNECTED THE SUCTION HOSE THAT HXX GOES FROM THE STEAM MACHINE TO THE CONTAINENT OF STEAM SOAP,3THE HOSE FLIPPED SENDING SOAP INTO HIS EYES.

HE WAS TRYING T2 ADJUST A CONVEYOR BELT. THE CHAIN ON THE COME ALONG HE WAS USING WAS ATTACHED TO THE END OF THE SHAFT. THE SHAFT WAS VERY SHORT AND THE CHAIN SLIPPED OFF CAUSING THE COME AL ONG TO STRICK H3S HAND AS IT CAME OFF.

INJURED THE BAL5S OF BOTH FEET WHEN HE WAS PRESSING THE PEDALS ON THE SHOVEL.

CUTTING TORCH FELL WHICH ACTIVATED THE AIR HANDLE, IN TURN BLOWING AIR WITH DUST & SAND INTO EYES.

THE WORKMAN WAS TIGHTENING BOLTS ON THE CRUSHJER THE WRENCH HE WAS USING SLIPPED OFF THE BOLT AND HE FELL BACKWARDS ONTO THE STEEL PLATFORM

STEPPED BACKWARDS WHILE INSIDE THE SHOP AND CAUGHT MY HEEL ON A BATTERY THAT WAS ON THE FLOOR BEHIND ME ASI WAS FALLING BACK I TURNED TO THE LEFT AND PUT MY LEFT HAND OUT TO CATCH MYSELF AND I N DOING SO PUT TO MUCH STRAIN ON THE WRIST AND IT BROKE

RUNNING TO SHOP TO GET A HAMMER & TRIPPED & TURNED HIS ANKLE.