Buscar en el registro

WHILE USING A 4" GRINDER TO CLEAN HANDRAIL, EMPLOYEE LOST CONTROL OF GRINDER. THE WHEEL CUT THROUGH HIS GLOVE CAUSING A HALF-INCH LACERATION ON HIS RIGHT HAND BETWEEN THE THUMB AND FOREFINGER. GRINDER WAS PROPERLY GUARDED, SWITCH WAS OF NON-LOCKING TYPE.

HOLDING ON TO WINCH LINE, HIS LEFT INDEX FINGER BECAME TRAPPED BETWEEN WINCH LINE AND VEHICLE BUMPER.

EMPLOYEE WAS ATTEMPTING TO CLEAR A FAULT SIGNAL AND MOVED HER LEFT HAND INTO THE TRAVEL PATH OF THE TABLE WHICH WAS IN THE UP POSITION. THE FAULT WAS RESET AND THE TABLE DROPPED TO THE DOWN PO SITION, TRAPPING HER LEFT FOREARM. THE ARM WAS NOT BROKEN, ONLY BRUISED. THERE WAS A LACERATION THAT DID NOT REQUIRE STITCHES.

EE WAS GRINDING & A PIECE OF METAL STRUCK A PIPE & FLEW BEHIND HIS GLASSES STRIKING HIM IN THE EYE

MANITOWOC 300 VICON CRANE SET SECTION OF SHORING ON TOP OF ANOTHER SECTION MAKING IT 2 FRAMES HIGH, SCAFFOLD WAS PINNED TOGETHER AND STRAPS DROPPED TO OUTSIDE OF SHORING AFTER BEING UNHOOKED O N FEEDER END. COWORKER THEN SIGNALLED THE CRANE OPERATOR TO HOIST UP THE STRAPS. WHEN THE OPER. PULLED UP THE HOISTLINE LEVER, THE BOOM RAISED TOO, CAUSING THE STRAPS TO SWING CATCHING THE LE

WAS CUTTING OFF REARING WITH CUTTING TORCH, STOPPED CUTTING, STOOD BACK. ANOTHER EE STRUCK BEAMING WITH HAMMER TO KNOCK OFF BEARING. A PIECE OF HOT SLAG STRUCK FACE CUTTING TORCH HAMMER.

EE WALKED BY A MAN GRINDING A WELD & FELT SOMETHING HIT HIS LEFT EYE. HE SAW A DOCTOR & HAD A PIECE OF METAL REMOVED. HE STATED HE HAD HIS SAFETY GLASSES ON AT THE TIME OF THE ACCIDENT.

HE REMOVED PLUD ON KILN FEED PUM & INSERTED PIPETO LOOSEN MATERIAL. WHEN HE REMOVED THE PIPE THEKILN FEED SHOT OUT & INTO HIS EYES.

VACUUMING CEMENT OUT OF SILO STIRRED UP MATERIALAND SOME GOT IN HIS EYES. DID NOT GO TO DOCTOR UNTIL 11/20/00.

WHILE CUTTING ON DUST LINE SLAG POPPED OFF AND ENTERED LEFT EAR.

WHEN GRINDING PIECE OF STEEL STRUCK EYE WAS USING GRINDING SHIELD AND WEARING GLASSES.

HE WAS CUTTING UP SCRAP METAL AND WHILE IN PROCESS, HE CUT A PIECE OF STEEL AND IT FELL BACK AGAINST HIS LEFT ARM AND CAUSED THE ACCIDENT. SMALL CUT 1/4", SCRATCHED ARM.

EMPLOYEE USING A SELF PROPELLED WORK PLATFORM AND WORKING ABOUT 10' OFF THE GROUND AND BESIDE KILN #2, REMOVING ELECTRICAL CABLE TRAY. THE KILN HAS BEEN MODIFIED BY ADDING A DOOR ON THE SIDE T O FACILITATE BURNING TIRES. THE DOOR ON THE SIDEOF THE ROTATING KILN FAILED TO SEAL COMPLETELY WHEN CLOSED AND ALLOWED HOT DUST TO FALL ON EMPLOYEE AND HE GOT DUST IN EYES.

FLASH BURNS TO BOTH EYES.

WELDING THE OPENING FOR A PLATE ON 342 FAN DOWNCOMER SCREW. HOT FEED FLUSHED OUT OF SCREW BURNING EMPLOYEE.

OPERATOR HAD ATTEMPTED TO POSITION DRILL OVER ROCK WHERE HOLE WAS LAID OUT; HE TRIED A DIFFERENT APPROACH THAT INVOLVED SLOPED TERRAIN. AT THIS TIME, THE DRILL TIPPED OVER TO CURB (RT. HAND) SIDE WITH OPERATOR IN CAB. IMPACT OF CRASH THREW OPERATOR AGAINST INSIDE OF CAB.

WHILE CUTTING A TREE WITH A CHAINSAW, EE WAS STRUCK IN THE HEAD WITH A BRANCH.

EE WAS ATTEMPTING TO SET A CONCRTERWEIGHT ON A CONTRACTORS BACKHOE. WHILE IN THE PROCESS THE CRANE TIPPED. THE EE HAD THE CRANE IN THE TRAVEL POSITION WHICH OVERRIDES THE SAFETY DEVICES ON TH E MACHINE. ALSO THE CRANE WAS SET UP ON UNLEVEL GROUND AT AN UNLEVEL POSITION. THIS ACCIDENT CAUSED THE EE TO EE HIS WRIST.

CUTTING BOLTS OFF FLANGE AND SLAG AND HOT METAL WENT THROUGH SLEVE AND BURNT ARM.

JACK HAMMERING WHEN MATERIAL BROKE LOOSE. LOST CONTROL OF HAMMER. REACHED TO CATCH FALLING HAMMER, FELT PAIN IN BACK.

EE WAS JACKHAMMERING MUD RING FROM KILN WHEN SECTION CAME LOOSE AND STRUCK HIM IN THE LEFT SIDE OF HEAD.

EE WAS GRINDING OUT BOLTS WHEN THE GRINDER GOT AWAY FROM HIM, FLIPPED OVER AND CUT THE BACK OF HIS LEFT ARM. GRINDER WAS EQUIPPED WITH GUARD AND THE GUARD WAS FUNCTIONING WHEN THE ACCIDENT OCC URRED.

EMPLOYEE WAS CLEANING A PLUGGED FEED SPOUT ON #2 KILN WITH AN AIR LANCE. THE FEED CAME OUT OF THE SPOUT AND STRUCK HIM ON CHEST AND ARMS.

EE WAS CLEANING OUT CLINKER COOLER WITH A WATER LANCE. AS EE APPLIED WATER WITH LANCE, STEAM AND MATERIAL BLEW OUT WITH SUFFICIENT FORCE TO KNOCK HIM TO THE GROUND. STEAM AND MATERIAL BLEW UP UNDER SAFETY HOOD AND UNDER SAFETY COAT CAUSING BURNS TO EE.

WHILE TRYING TO REMOVE BOLTS ON #2 FM, IMPACT WRENCH CONTINUED TO TURN AFTER BOLT CAME OFF CAUSING A WELDING ROD HOLDING THE SOCKET TO STRIKE HIS LEG CAUSING ABRASION. EE IS DIABETIC CAUSING C ONCERN AQBOUT POSSIBLE ONSET OF INFECTION, SO DR. WAS CONSULTED.

WHILE OBSERVING A GUARD BEING SAWED WITH A JIGSAW, RUST BECAME AIRBORN AND ENTERED RIGHT EYE. WAS REMOVED FROM EYE BY DOCTOR AND RECEIVED PRESCRIPTION. NO PERMANENT DAMAGE.

WHILE CLEANING PREHEATER WITH WATER BLASTER EE ATTEMPTED TO RELOCATE POSITION, STUMBLED, DROPPING WATERBLASTER. ACTIVATED WHEN IT HIT THE FLOOR CAUSING LACERATIONS TO HIS HAND & STOMACH. OUT PATIENT SURGERY REQUIRED.

EE WAS WORKING ON DUST BUELS WHEN ONE "FLUSHED" OUT CAUSING THE HOT DUST TO BURN HIM ON HIS RIGHT SIDE AND BACK. EE JUMPED FROM THE CATWALK TO ESCAPE THE DUST & IN THE RPOCESS OF JUMPING, HIT HIS HEAD ON A SCREW WHICH CUT HIS HEAD. HE INJURED HIS RIGHT KNEE WHEN HE HIT THE GROUND.

CEMENT BAG FAILED CAUSING CEMENT DUST TO BLOW IN THE FACE OF THE EE, BEHIND SAFETY GLASSES.

ON THE 6TH FLOOR OF THE PACKHOUSE (BAG PROD. AREA) HE WAS OPERATING A MOTORIZED PALLET-JACK TRYING TO MANUEVER A PALLET INTO PLACE. WHILE IN THE REVERSE MODE, HE BACKED UP INTO A SET OF PALLET S ALREADY IN PLACE. THE MOMENTUM OF THE PALLET JACK CAUGHT HIS FEET INBETWEEN THE PLACED PALLETS AND THE LOAD ON THE JACK.

EE WAS SHIFTING A FDOZER FROM FIRST GEAR INTO REVERSE WHEN HIS BACK SPASMED.

WHILE ATTEMPTING TO REMOVE ROD AND REPLACE IT BETWEEN TWO COUPLINGS EE BROUGHT THE TWO COUPLINGS TOGETHER BY HAND CONTROL. HE MISJUDGED DISTANCE AND SMASHED FINGERS OF LEFT HAND.

LIME WAS FLOWING INTO CAB OF TRUCK THROUGHT ACCELERATOR HOLE. EMP. TURNED ON VENT WHICH CAUSED THE CAB TO FILL WITH LIME.

WHILE WELDING ON NOSE OF KILN, HOT MATERIAL CAUGHT RIGHT HAND AT BASE OF THUMB.

HANGING IRON, AIR IMPACTING BOLTS. BLEW METAL CHIPS IN LEFT EYE.

EMPLOYEE WAS PREPARING TO BE MOVED WHEN HIS HAND WAS CAUGHT BETWEEN THE CRANE AND THE OUTRIGGER PAD AS THE OUTRIGGER WAS BEING PULLED BACK INTO CRANE.

FORKLIFT "NOSE-DIVED" WITH LOAD LIFTED WHILE POSITION TO LOAD TRUCK.

CUTTING 2 X 12 BOARD. SKIL SAW JUMPED FORWARD AND CUT HIS LEFT INDEX FINGER.

EMP STARTED THE STEAM JENNY TO WASH TRUCK. WAND FLEW BACK CUTTING HIS LEG (UPPER RIGHT) REQUIRING 4 STITCHES.

EMLOYEE WHO WAS TROUBESHOOTING PROXIMITY SWITCH ON PALLETIIZER BAG TABLE. AS TABLE WAS CYCLED (LOWERED), THE LEFT HAND WAS NIPPED IN THE LOWER TRACK.

EE WAS DRILLING HOLE AT BLEND SILO PUMP HOUSE WHEN DRILL BIT BOUND UP TWISTING EE PULLING MUSCLE IN BACK.

EMP SUSTAINED INJURY WHILE DRIVING DOZER. EXACT TIME AND LOCATION CANNOT BE DETERMINED.

EE WAS OPERATING ROCK DRILL WHEN ONE TRACK LOST TRACTION AND SLIPPERY SURFACE AND TIPPED OVER EE JUMPED FROM DRILL. INITIALLY EE DID NOT REPORTA ANY INJURES, BUT HAS SUBSEQUENTLY SOUGHT MEDICA L CARE.

OPERATING CONDOR. SUDDEN STOP. STRUCK ARM AND WRIST ON CAGE.

EMPLOYEE WAS IGNITING GAS GUN IN KILN WHEN EXPLOSION OCCURRED CAUISN GFLAMES TO BACK OUT OF KILN BURNING FRON TOF EMPLOYEE'S NECK AND LEFT EYE.

EE WAS INVOLVED IN PACKING AND SHIPPING WHEN BAG OF MORTAR MIX BURST. EE GOT FOREIGN BODY IN EYE.

WORKING WITH VACUUM HOSE. IT BECAME ATTACHED TO HER RAINCOAT AND SUBSEQUENTLY TO HER PANT LEG.

ONE MAN WAS OPERATING TRENCHING MACHINE. VICTIM WAS STANDING IN FRONT OF THE MACHINE CUTTING BOOM, ON A 1' ELEVATED CONCRETE SLAB, TO OBSERVE DEPTH OF BOOM IN EART. CUTTING BOOM HIT CONDUITS B URIED ONLY 1" APPROX DEEP BELOW SURFACE, CAUSINGBOOM TO JUMP UP & OUTWARD, GRABING VICTIM'S PANT LEG & BOOT, PULLING HIM INTO THE CHAIN.

WAS JACKHAMMERING CASTABLE IN COOLER THROAT AND LARGE PIECE BROKE LOOSE, FELL DOWN, AND STRUCK LEFT HAND.

WHILE THE CRANE OEPRATOR WAS HOISTING THE BLOCK AND HOOK OUT OF THE MILL, THE TIP OF THE HOOK CAUGHT ON THE HATCH OPENING. WHEN IT CAME UNHOOKED IT HIT EMPLOYEE IN THE FACE.