Buscar en el registro

TRYING TO UNPLUG GYPSUM HOPPER BY BEATING ON HOPPER WITH BAR AND SPRAINED LOWER BACK.

WHILE USING A 4" GRINDER TO CLEAN HANDRAIL, EMPLOYEE LOST CONTROL OF GRINDER. THE WHEEL CUT THROUGH HIS GLOVE CAUSING A HALF-INCH LACERATION ON HIS RIGHT HAND BETWEEN THE THUMB AND FOREFINGER. GRINDER WAS PROPERLY GUARDED, SWITCH WAS OF NON-LOCKING TYPE.

EMPLOYEE WAS REMOVING A HANG UP FROM THE PRIMARY JAW CRUSHER USING A ROCK WEDGE. THE WEDGE KICKED BACK DRIVING THE WEDGE HANDLE INTO THE OPERATOR'S CHIN CAUSING A LACERATION REQUIRING MEDICAL ATTENTION.

EMPLOYEE WAS GRINDING WELDS WITH THE HOPPER FOR THE NEW PRIMARY CRUSHER. HE WAS USING A 12' STEPLADDER. THE LADDER WAS NOT PULLED OUT AND STANDING ON ITS SHOES NOR WAS IT TIED OFF. THE EMPLOYE E HAS BEEN TRAINDED WEEKLY AND DAILY SAFETY MEETINGS. THE EMPLOYEE FELL APPROX. 8', LANDING ON HIS RIGHT SIDE AT THE BOTTOM OF THE HOPPER.

IRONWORKER COMPLAINING OF CRAMPS IN LEG (LEFT) FROM MOVING FROM ONE PIECE OF IRON TO ANOTHER CLUTCHING BEAMS WITH INNER THIGH TIGHTENING BOLT. EE STATES HAS BRUISE ON THIGH. DR. SAID LIMITED L IMBING FOR COUPLE OF DAYS.

EE WAS HITTING A PIN ON THE STAMLER CHAIN WITH A SLEDGE HAMMER. ANOTHER EE LEANED DOWN. WE THINK HE DID THIS TO HOLD THE CHAIN. WHEN EE HIT THE PIN, HAMMER BOUNCED OFF THE PIN HITTING THE OTHE R EE IN THE FACE.

FORKLIFT PLANTING MY RIGHT FOOT AND IT ROLLED OVER BREAKING A BONE IN THE FOOT.

HOLDING ON TO WINCH LINE, HIS LEFT INDEX FINGER BECAME TRAPPED BETWEEN WINCH LINE AND VEHICLE BUMPER.

EMPLOYEE WAS PLACING PALLETS ONTO BAG ELEVATOR, HE STEPPED ON THE PALLET ROLLER AND FELL. HE CUT HIS LEG ON THE EDGE OF THE ROLLER, RIGHT LEG . REQUIRE 10 STITCHES, NO LOST TIME.

EE STATED HE AND TWO OTHERS WERE MANUALLY PLACING A PART OF A GEAR. THE GEAR SLIPPED WHEN THEY PUT IT DOWN PINCHING HIS RIGHT MIDDLE FINGER.

EE WAS ASCENDING ACCESS LADDER TO THE CRANE. HE WAS CARRYING TOOLS AND DID NOT MAINTAIN A MINIMUM OF THREE POINT CONTACT WITH THE LADDER.

PUSHING RODS IN TO CLOSE SILO. LAST ONE WENT IN EASIER THAN THE REST AND EE'S HAND HIT SILO CUTTING FINGER (3 STITCHES).

EMPLOYEE WAS ATTEMPTING TO CLEAR A FAULT SIGNAL AND MOVED HER LEFT HAND INTO THE TRAVEL PATH OF THE TABLE WHICH WAS IN THE UP POSITION. THE FAULT WAS RESET AND THE TABLE DROPPED TO THE DOWN PO SITION, TRAPPING HER LEFT FOREARM. THE ARM WAS NOT BROKEN, ONLY BRUISED. THERE WAS A LACERATION THAT DID NOT REQUIRE STITCHES.

WALKING ACROSS THE PLANT HEADING TOWARDS CRUSHER STEPPED ON A PIECE OF COAL BREAKING HIS FIBULA.

CONST LABORS MOVING METAL FORMS GOT FINGER BETWEEN TWO FORMS PINCHED MIDDLE FINGER.

EE WAS ATTEMPTING TO REMOVE A LARGE ROCK FROM THE ROCK FEEDER. WHILE ATTEMPTING THIS TASK, THE ROCK SHIFTED CAUSING THE EE TO SHIFT HIS WEIGHT TO HIS RIGHT ARM TO KEEP EE FROM FALLING DOWN. TH IS ACTION CAUSED THE EMPLOYEE TO INJURE HIS SHOULDER.

EE WAS GRINDING & A PIECE OF METAL STRUCK A PIPE & FLEW BEHIND HIS GLASSES STRIKING HIM IN THE EYE

775D HAUL TRUCK WAS DRIVEN OFF OF ELEVATED CURVEIN QUARRY RESULTING IN MINOR LACERATIONS AND BRUISING.

WALKING DOWN THE STAIRS AND SLIPPED ON MATERIAL, CAUGHT HIMSELF W/THE ELBOWS AND SLID TO THE BO TTOM SPRAINING HIS LEFT SHOULDER.

USING 4# SLEDGEHAMMER TO HIT IRON ORE HOPPER REPETITIVELY AND STRAINED HAND. RESTRICTED DUTY.

SHOVLING ON BURNER FLOOR AND STRAINED LEFT ARM.

INSTALLING CONVEYOR BELT ON #3 F.M. AND STRAINEDRIGHT SHOULDER.

EE WAS CLOSING THE DOOR OF THE HAMMERMILL WITH A YALE 1 1/2 TON COME ALONG WHEN THE DOOR SLIPPED OUT OF ALIGAMENT. HE RE-ATTACHED THE COME ALONG TO REALIGN THE DOOR. EE WAS WONDERING IT AN AWK WARD POSTION WITH THE COME ALONG WHILE WORKING TUHE COME ALONG. RIGHT ARM GREW TIRED AND HE SWITCHED TO HIS LEFT. HE STRAINED WITH HIS LEFT ARM AND FELT THE INJURY OCCUR.

SLIDING MOTOR OFF OF A PAD & BAR SLIPPED. HE SPRAINED RIGHT ELBOW RESULTING IN RESTRICTED DUTY.

EE WAS IN CLINKER COOLER DUST COLLECTOR HELPING 2 OTHER EES PULL A SCREW BACK TOGETHER USING A COMEALONG. HE WAS KNEELING ON ONE KNEE PULLING THE COMEALONG WHEN HE FELT A "POP" & THEN BACK PAI N.

EE WAS IN CLINKER COOLER DUST COLLECTOR TO REMOVER SCREW. ONE EE ASKED THE CONSOLE TO CUT BACK ON F26 FAN. WHEN THEY DID THE DUST IMMEDIATLY BEGAN TO SETTLE GETTING INTO EE EYES.

REMOVING METAL PLATE FROM TOP OF #3 FINISH MILL AND STRAINED LOWER BACK.

EE WAS CLEANING OUT THE BOTTOM OF THE TURN HEAD WHEN HANDLE ON THE BY PASS GATE RELEASED AND HITHIM IN THE CHEST AREA BRUISING HIS RIBS.

WORKING ON WICH TRUCK AND TURNED AROUND AND HIT RIGHT ELBOW ON BUMPER. RESTRICTED DUTY.

WORKING ON RAW MILL HE STARTED FEELING DIZZY DUE TO NATURAL GAS EXPOSURE.

EE WAS PULLING A STEEL CABLE UP TO A PLATFORM WHEN HE SUDDENLY STRAINED HIS LOWER BACK.

WHILE WALKING DOWN THE STAIRS FROM THE KILN FIRING PLATFORM TO THE PRODUCTION CONFERENCE ROOM, EE MISSED HIS FOOTING AND TRIPPED ON THE BOTTOM STAIR STEP.

EE WAS SITTING ON A STEEL PLATE SECURED BY A CHAIN HOIST. THE HOIST SLIPPED, CAUSING HIM TO FALLDOWN INTO A CHUTE. HE RECEIVED 2 STITCHES IN HISRIGHT KNEE.

MANITOWOC 300 VICON CRANE SET SECTION OF SHORING ON TOP OF ANOTHER SECTION MAKING IT 2 FRAMES HIGH, SCAFFOLD WAS PINNED TOGETHER AND STRAPS DROPPED TO OUTSIDE OF SHORING AFTER BEING UNHOOKED O N FEEDER END. COWORKER THEN SIGNALLED THE CRANE OPERATOR TO HOIST UP THE STRAPS. WHEN THE OPER. PULLED UP THE HOISTLINE LEVER, THE BOOM RAISED TOO, CAUSING THE STRAPS TO SWING CATCHING THE LE

EE WAS WELDING IN THE JAW FEEDER. HE WAS UNAWARETHAT HIS WELDING HOOD WAS FAULTY, THUS CAUSING HIS EYE INJURY.

WHILE PUTTING GRAPHITE ON THE #4 ROLLER TO GET THE KILN TO DRAG DOWNHILL, THE EMPLOYEE TRIPPED OVER A STOOL ON THE KILN CATWALK.

WHEN REMOVING COOLER HATCH TO CLEAN COMPARTMENT FELT SHARP PAIN IN LEFT WRIST.

CLEANING AROUND FEED CONVEYOR WHEN HE SLIPPED. WHEN HE TRIED TO CATCH HIMSELF, HIS RIGHT HAND WAS PULLED INTO CONVEYOR ROLLER.

ADJUSTING ROLLSON COAL MILL AND STRAINED RT. SHOULDER.

EE STEPPED ON MUD WHILE WALKING ON CATWALK SLIPPED & FELL 7'8" HE HIT HIS HEAD ON THE GROUND CAUSING A LACERATION OF ABOUT 11/4" LONG. THIS REAUIRIED SUTURES EE STEPPED OVER A HAND RAIL TO AN AREA NOT DESIGNED FOR HUMAN TRAFFICE

EE WAS WORKING INSIDE BAGHOUSE & DUST BLEW INTO HIS EYES.

EE WAS ATTEMPTING TO CLEAR OFF A BELT. THE EE GRABBED A LARGE STONE ATTEMPTING TO REMOVE IT FROM THE CONVEYOR, THE ROCK SHIFTED FALLING ON THE EE LEG.

WALKING OUT OF MILL BUILDING HE SLIPPED ON A CLINKER BALL AND FELL CAUSING A BRUISED BACK.

WHEN STEPPED OFF LADDER TWISTED LEFT ANKLE WHEN HE STEPPED ON 1 1/2 TON COME ALONG WENT TO MD FOR X RAY 3-8-01, UNKNOWN AT THIS TIME IF TREATMENT WILL BE NECESSARY.

PICKING UP A SPRING HE SPRAINED HIS BACK.

WHEN CLIMBING STEPS ON LOADER, FEET SLIPPED ON WET STEPS AND SLID BACKWARDS.

WALKING DOWN STAIRS AT KILN HE SLIPPED AND FELL CAUSING SHOULDER CONTUSIONS.

EE WAS PUTTING STEEL IN RACK WHEN HER RIGHT HANDWAS CAUGHT BETWEEN 2 PIECES OF STEEL. MEDICAL TREATMENT FIRT RECEIVED ON 2/22/01.

WAS CUTTING OFF REARING WITH CUTTING TORCH, STOPPED CUTTING, STOOD BACK. ANOTHER EE STRUCK BEAMING WITH HAMMER TO KNOCK OFF BEARING. A PIECE OF HOT SLAG STRUCK FACE CUTTING TORCH HAMMER.

OPERATOR WAS LOADING IN A MUCK PILE, AS HE WAS BACKING UP FROM THE PILE A ROCK WENT UNDER THE BUCKET. WHEN THE LOADER CAME OFF THE ROCK IT CAUSED THE MACHINE TO SHIFT FROM SIDE TO SIDE. THIS CAUSED THE OPERATOR TO STRIKE HIS HEAD AGAINST AMETAL BOX INSIDE THE CAB OF THE LOADER.