Buscar en el registro

EE WAS HELPING TO REMOVE CONCAVES FROM GYRATORY CRUSHER WHEN HIS LEG BECAME PINNED BETWEEN THE MAIN FROME AND CONCAVE. HE LOST HIS BALANCE AND TWISTED HIS ANKLE.

INJURES EMPLOYEE WAS USING UTILITY KNIFE TO INSTALL POLY-DECK SECTIONS ON VIBRATING SCREEN AND CUT THE TOP OF LEFT HAND. HE WAS NOT WEARING GLOVES.

EE REPORTED A HEARING LOSS IN BOTH EARS TO THE TARMAC CORPORATE RISK MANAGER. OUR WORKERS COMPENSATION CARRIER DETERMINED THE CLAIM WAS VALID.

INJURED EE WAS DISMOUNTING FROM A TRACK DOZER AND STEPPED ON A ROCK OR FROZEN GROUND AND AGGRAVATED A PREVIOUSLY BRUISED HEEL.

EE AND CONTRACTOR WERE INSTALLING BOLTS INTO MAIN FRAME OF CONE CRUSHER BOLTS WERE 3"X60". APPROX. 100 LBS AS THE BOLT WAS PLACED INTO FRAME HOLE, THE INJURED EE TRIED TO ALIGN THE BOLT. THE C ONTRACTOR LOST HIS GRIP, AND THE BOLT DROPPED INTO HOLE CATCHING EE'S HANDS.

EE WAS HELPING TO CARRY A SECTION OF 1/2' SCREEN CLOTH ONTO SCREENING TOWER. HE FELT DISCOMFORT IN HIS BACK LATER DURING THE SHIFT.

EE WAS MOUNTING WATER TRUCK AND HIS FOOT SLIPPED ON A STEP AND HE STRUCK AND BRUISED HIS KNEE.

EMPLOYEE WAS TIGHTENING WEDGE BOLTS ON CONE CRUSHER #1 WHEN THE WEDGE FLEW UP STRIKING EMPLOYEE IN THE NOSE.

EE WAS DRIVING WATER TRUCK DOWN INCLINED HAUL ROAD TO DELIVER SUPPLY OF WATER TO ROCK DRILL IN PIT. THE BRAKES DID NOT SLOW THE VEHICLE SUFFICIENTLY TO MAKE A LEFT TURN. EE CONTINUED DRIVING V EHICLE ON HAUL ROAD AND DROVE THROUGH BERM FALLIING APPROX 40' TO QUARRY FLOOR. EE WAS WEARING SEAT BELT.

EE WAS HELPING COWORKER PLACE GEASE DRUM ONTO BACK OF FUEL TRUCK. HIS HAND WAS CAUGHT BETWEEN THE GREASE DRUM AND TRUCK BED. HE WAS NOT WEARING WORK GLOVES.

EE WAS AT THE NO18 BELT CONVEYRO (SHUTTLE BELT)TO DETERMINE THE CAUSE OF THE CONVEYOR BELT RUBBING ON THE FRAME. EE TRAVELED BEYOND THE PROTECTIVE RAILING TO JOG THE BELT HE INADVERTENTLYPLACE D HIS FOOT ON THE SHUTTLE TRACK & THE SHUTTLE TRAVELED OVER HIS FOOT. EE WAS WEARING SAFETY STEEL TOE BOOTS

EE & COWORKERS WERE CHANGING THE BEARINGS ON A BLT CONVEYOR HEAD PULLEY. AS EE REMOVED THE FINALFEW BOLTS THE PULLY DROPPED DOWN & CAUGHT HIS FINGER BETWEEN THE PULLEY & THE BEARING HOUSING. T HE COMALONG WAS NOT PROPERLY POSITIONED TO SUPPORT THE WEIGHT OF THE PULLEY WHEN THE FINAL BOLTSWERE REMOVED

EE WAS PLACING DRILL AUGERS INTO PICKUP TRUCK BED. THEY WERE MUDDY AND AS HE WAS LOWERING AN AUGER INTO THE TRUCK BED, HE LOST HIS GRIP AND CAUGHT HIS FINGER BETWEEN TWO AUGERS. HE WAS WEARING WORK GLOVES. EE WAS DOING EXPLORATION DRILLING.

EMPLOYEE WAS HELPING CO-WORKER REMOVE ROCK SCREENS FROM DECK AREA SO THEY COULD RETREIVE A WATERHOSE LAYING UNDERNEATH THE SCREENS. AS THE CO-WORKER LET GO OF THE SCREENS TO PICK UP THE HOSE, THE INJURED EMPLOYEE LOST HIS BALANCE AND THE SCREENS FELL ONTO HIM.

INJURED EMPLOYEE WAS REPOSITIONING SCREW JACK STABLIZERS ON THE PORTABLE CRUSHING PLANT. THE 4' BAR USED TO SCREW THE JACKS UPWARD SLIPPED OUT OF THE HOLE AND THE END OF THE BAR STRUCK THE RIG HT SIDE OF HIS HEAD. HE WAS WEARING HARD HAT PROTECTION.

EE WAS FILLING WATER TRUCK AT THE PUMP HOUSE. AS HE ATTEMPTED TO TURN ON THE WATER HE WAS STUNG SEVERAL TIMES ABOUT HIS HEAD AND BODY. HE HAD AN ALLERGIC REACTION.

EMPLOYEE WAS PREPARING TO SPLICE A RUBBER CONVEYOR BELT AND CUT HIMSELF WITH A KNIFE AS HE WAS TRIMMING THE BELT.

EE WAS REMOVING FASTENERS TO REPLACE SCREEN DECKS AND STRUCK HIS HAND AGAINST THE SIDE OF VIBRATING SCREEN. HE WAS NOT WEARING WORK GLOVES.

EE WAS USING CUTTING TORCH TO "WASH" AND REMOVE TRAMP IRON FROM CONE CRUSHER. A PORTION OF THE TRAMP IRON WAS EJECTED FROM THE CRUSHER AND STRUCK THE EE IN THE LEG.

EE AND COWORKER WERE REMOVING LARGE ROCKS FROM THE TRUCK DUMP AREA OF GYRATORY CRUSHER. AS THEY WERE ROLLING INTO GYRATORY FEED BOX, EE'S FINGERWAS CAUGHT BETWEEN 2 ROCKS. EE WAS WEARING WORK GLOVES.

EMPLOYEE AND CO-WORKER HAD HOOKED A CHAIN ONTO A CHUTE BEING USED WITH A PROATABLE SCALPING SCREEN. AS THE INJURED EMPLOYEE WAS PULLING ON THE CHAIN TO MOVE THE CHUTE INTO POSITION, HE FELT DI SCOMFORT IN HIS LOWER BACK.

EMPLOYEE WAS HELPING TO REPAIR SWING CLUTCH ON DROPBALL CRANE. AS HE WAS USING PRYBAR TO ASSIST IN REMOVING BOLTS, IT SLIPPED AND STRUCK HIS FOREHEAD. EMPLOYEE WAS WEARING HARDHAT AND SAFETY G LASSES.

INJURED EMPLOYEE AND CO-WORKER WERE REPLACING SKIRTBOARD ON #21 BELY CONVEYOR. EMPLOYEE WAS USING UTILITY KNIFE TO CUT SLOTS INTO RUBBER KNIFE AND HIS FOREARM.

EE AND CO WORKERS WERE REPLACING A TAKE UP PULLEY ON BELT CONVEYOR. AS THE CRANE WAS LIFTING PULLEY, EE S HAND WAS CAUGHT BETWEEN THE PULLEY AND CONVEYOR FRAME.

EE WAS OPERATING A 35 TON HAUL TRUCKAND PREPARING TO DUMP AT A STOCKPILE LOCATED AT THE PRIMARY CRUSHER. BEFORE HE COULD BEGIN BACKING, THE BRAKING SYSTEM FAILED AND THE STRUCK THE PIT WALL AT THE END OF THERAMP. EE WAS WERAING A SEAT BELT.

EE WAS TIGHTENING TENSION BOLT ON THE NUMBER 2D VIBRATING SCREEN. WHILE APPLYING PRESSURE ON THE HAND WRENCH, THE BOLT HEAD BROKE AND HIS THUMB WAS CAUGHT BETWEEN WRENCH AND MOTOR GUARD.

EE WAS USING KNIFE TO WHITTLE WOODEN HAMMER HANDLE.

EE AND COWORKERS WERE INSTALLING A LINER INTO VIBRATING SCREEN DECK. THE EE INJURED HIS BACK WHILE TRYING TO POSITION THE LINER. HE WAS WEARING A LUMBAR SUPPORT BELT.

EE WAS WALKING PAST A WELDING TRUCK AND WAS STRUCK IN THE FACE BY A SECTION OF ANGLE IRON THAT WAS EXTENDING BEYOND THE TAILGATE.

EE WAS HELPING ANOTHER EE ADJUST THE CRUSHER. WHILE REMOVING A BOLT IN THE ADJUST RING, THE BOLT GOT STUCK IN THE HOLE. EE TRIED TO PRY IT OUT WITH A CROWBAR AND THE BAR SLIPPED AND MASHED HIS FINGER AGAINST THE CRUSHER.

EE CLIMBED THE LADDER OF HIS LOADER AND BENT OVER TO OPEN THE DOOR AND PULLED A MUSCLE IN HIS BACK..

EE WAS RESTING A RIECE OF RUBBER HOSE ON HIS LEG& CUTTING THE DAMAGED END WITH A RAZOR KNIFE. THE KNIFE WENT THROUGH THE RUBBER & CUT HIS LEG.

EE WAS PRYING WITH A STEEL BAR. THE BAR SLIPPED AND MASHED HIS FINGER BETWEEN THE BAR AND ANOTHER PIECE OF STEEL.

EE WAS TRYING TO PRY A ROCK LOOSE FROM A CHUTE AND FELT SOMETHING PULL IN HIS ARM

EMP WAS LIFTING A SCREEN AND WHILE LIFTING IT, THE SCREEN ROLLED BACK DOWN CAUSING A WIRE TO CUTTHE EMP'S OUTSIDE UPPER ARM. THE CUT WAS APPROX.1 1/2" LONG AND REQUIRED A BUTTERFLY STITCH AND TETANUS SHOT.

EMPLOYEE SPRAYED THE SEAT IN HIS LOADER WIHT SILICONE LUBRICANT TO KEEP IT FROM SQUEAKING. THE FUMES FROM THE SPRAY CAUSED IRRITATION IN RIGHT EYE.

EMPLOYEE WAS TRYING TO OPEN BIN DOOR. THE HANDLE TO THE MANUAL DOOR HAD JAMMED AGAINST THE SIDE OF BIN. AS THE DOOR OPENED, THE HANDLE CAUGHT HIS HAND AGAINST THE BIN.

A ROCK FELL FROM A BIN HE WAS WELDING ON AND HIT HIM IN THE KNEE, BRUISING HIS KNEE.

WHILE REMOVING BOLTS FROM FRONT IDLER, YOKE MASHED LEFT INDEX FINGER.

THIS TRUCK WAS CONVERTED OVER TO A WATER TRUCK. THE WIRING HARNESS CAUGHT ON FIR. EE USED A DRY CHEMICAL FIR EXTINGUISHER TO PUT IT OUT. THE WIND BLEW SOME OF THE CHEMICAL BACK INTO HIS FACE. HE HAD AND ALLERGIC REACTION TO THE DRY CHEMICAL--DERMATITIS IN FACE.

NEW EE WAS BEING TRAINED TO DRIVE A HAUL TRUCK, A ROCK WAS IN THE ROAD. THE DRIVER AND TRAINEE GOT OUT OF THE TRUCK TO PICK UP THE ROCK. WHEN HE BENT OVER, SOMETHING PULLED IN HIS BACK. HE WAS IN A GREAT DEAL OF PAIN AND AN AMBULANCE WAS CALLED TO TAKE HIM TO THE HOSPITAL.

EE SLIPPED OFF BACKHOE TRACKS AND FELL BETWEEN TIRES OF MOVING FRONT END LOADER. REAR TIER OF LOADER STRUCK HIS HAND.

EMPLOYEE WAS REMOVING A LARGE ROCK FROM THE 4 1/4' CRUSHER WHEN ANOTHER ROCK FELL FROM SYNTRON STRIKING HIS HAND.

EE WAS CLEARING ROCK JAM FROM DISCHARGE BOX AT 2 SYNTRON. A ROCK FELL CATCHING FINGER AGAINST BOOK.

EMPLOYEE WAS TIGHTENING HEAD ON CRUSHER. ANOTHER EMPLOYEE WAS OPERATING THE HYDRAULIC CONTROLS. AS THE JACK RETRACTED, THE EMPLOYEE'S FINGER WAS CAUGHT BETWEEN THE RAM HEAD & THE JACKS BODY. I T BROKE THE BONE IN HIS RIGHT FINGER IN 3 PLACES

LIFTING ROLLERS, PULLED MUSCLE IN RIGHT SHOULDER.

EMPLOYEE WAS USING KNIFE TO CUT PLASTIC TIES TAHT SECURED THE STRAP ON HIS WELDING GOGGLES TO HIS HARDHAT. HE CUT HIS THUMB.

HE WAS PULLING PUNCH PLATES ONTO THE SHAKER SCREEN & STRAINED HIS BACK.

EMPLOYEE WAS USING HIGH PRESSURE HOSE TO WASH OFF SPILLAGE FROM CONCRETE PAD. A ROCK FELL FROM AN UNKNOWN LOCATION (POSSIBLY A BELT CONVEYOR APPROX. 15' ABOVE) AND STRUCK HIS HAND.

EMPLOYEE WAS WASHING SPILLAGE FROM UNDER BELT CONVEYOR USING HIGH PRESSURE WATER HOSE. HE COULDN'T CONTROL THE HOSE AND IT STRUCK HIM IN THE MOUTH.