Buscar en el registro

EE WAS CLEARING A JAM WITH DIGGING BAR WHEN A ROCK HIT THE DIGGING BAR AND IT PUSHED THE SAFETY GLASSES INTO THE EE'S FACE. THIS RESULTED IN A SMALL LACERATION UNDER THE RIGHT EYE, REQUIRING T WO STITCHES.

WHILE TRIMMING HIS SAFETY GLASSES ON HIS LEFT UPPER LEG WITH A RAZOR KNIFE HE CUT HIS LEG.

WHILE USING A COME-A-LONG TO OPEN THE IMPACTOR DOOR, HE JAMMED HIS THUMB.

WRENCHING ON AN OLD GARAGE TRUCK AND PULLED SHOULDER OUT.

WHILE CUTTING A SHEET OF RUBBER WITH AN RAZOR KNIFE HE SLIPPED AND CUT HIS THUMB.

PULLING WITH PRY-BAR, BAR SLIPPED AND END STUCK IN RIGHT HAND (PALM) LACERATION, SUTURES REQUIRED.

WAS PULLING ON A "COME ALONG" TOOL & THE EYE BOLT BROKE STRIKING BACK OF LEFT ARM.

EE WAS REMOVING THE SCREEN GUARDS TO GAIN ACCESSTOT HE BELTS. THE WRENCH SLIPPED FROM HIS HAND AND HIS LEFT ARM SLID ACROSS THE SCREEN CAUSING ASMALL LACERATION WHICH REQUIRED 4 STITCHES.

USING PIPE WRENCH TO REMOVE SHAFT FROM SCREW CONVEYOR. TRYING TO TURN AND PULL SHAFT WRENCH SLIPPED, LOST BALANCE AND FELL BACKWARDS.

EE WAS TRYING TO UN-PLUG A CHUTE AT APRON CONVEYOR WITH A METAL BAR AND SMASHED HIS PINKY FINGER ON HIS RIGHT HAND.

THE EMPLOYEE WORKED A NORMAL SHIFT ON 4-19-96. WHEN HE GOT UP FOR WORK ON 4-20-96 HE FELT PAIN IN HIS LOWER BACK AND LEFT HIP. HE SAID HE CANNOT REMEMBER FEELING ANY PAIN FROM HIS JOB ON FRIDA Y. HE THINKS HE MAY OF HURT HIMSELF DIGGING.

OPENING A WELDING ROD CAN RING BROKE OFF EE THEN USED A PAIR OF PLIERS TO TAKE OFF THE LID WHEN THE LID CAME OFF IT CUT EE ACROSS THE BACK OF THETHUMB

EMPLOYEE WAS USING A 4FT LONG STEEL PRY BAR TO CLOSE LID ON A RAIL CAR WHEN EMPLOYEE PUSHED AGAINST THE BAR TO SECURE RAIL CAR LID HE STRAINED HIS LEFT GROIN AREA

EMPLOYEE WAS CUTTING OFF DAMAGED END OF SUPER SUCKER HOSE USING A POCKET KNIFE. THE POCKET KNIFESLIPPED AND PUNCTURED HIS LEFT LOWER ARM.

MECHANICAL MAINTENANCE.

REMOVING BEARING OFF OF A SHAFT AND IN THE PROCESS HAMMER MISSED THE PRY BAR HITTING HIS HAND.

WRENCH SLIPPED WHILE WORKING ON A DIESEL PUMP. STITCHES REQUIRED IN RT LITTLE FINGER.

EMPLOYEE WAS CLEANING OUT SET CEMENT IN B3 CEMENT COOLER USING PICKAX HE SMASHED HIS FINGER BETWEEN PICKAX HANDLE & COOLER HOUSING (TIGHT AREA)

EMPLOYEE WAS DOING ROUTINE MAINTENANCE ON #2 RAW MILL ROLLER. EMPLOYEE WAS USING A HAMMER TO REMOVE WEAR SHIELD ON #2 RAW MILL ROLLER. HAMMER STRUCK EMPLOYEES LEFT HAND.

EMPL STATED WASH DOWN HOSE TOOK HIS HIP SOCKET OUT.

EE WAS SCALEING FACE TO MAKE IT SAFE TO DRILL. HE WAS PRYING WITH A BAR IT SLIPPED AND HE CUT HIS LEFT INDEX FINGER ON A ROCK.

EMPL REMOVING DEBRIS FROM AN ELEVATOR USING A PRY BAR. EMPL STRUCK A FINGER OF RIGHT HAND AGAINST THE ELEVATOR HOUSING. THE HOUSING CUT EMPL HAND.

SOMEONE HAD USED WIRE BRUSH TO CLEAN A BATTERY TERMINAL.USED IT TO CLEAN A PIPE FITTING,SOME CORROSIVE MATERIAL BLEW INTO EYE.

EMPLOYEE WAS BARRING DOWN CLINKER OUT OF #4 BELT CHUTE, B3 MILL. CLINKER BROKE FREE SUDDENLY, CAUSING EMPLOYEE'S ARM TO STRIKE AGAINST SIDE OF CHUTE. EMPLOYEE FRACTURED HIS ARM WHEN HE STRUCK THE CHUTE.

WHILE CHIPPING WELDING SLAG OFF WELD A PIECE FLEW INTO EYE.

EMPLOYEE WAS USING A POCKETKNIFE TO CUT TAPE WRAPPING OFF A PIPE WHEN THE KNIFE SLIPPED AND CUT EMPLOYEE'S FINGER.

USING SLEDGE HAMMER TO TIGHTEN BOLT ON MILL AND HIT FINGER.

EMPLOYEE WAS HELPING TO FIT A PIECE OF DUCT ON SKIDS. EMPLOYEE TRIED TO ROLL THE PIPE BACK UP WITH A SLEEVER BAR AND THE PIPE STARTED TO SLOWLY ROLL. PIPE FELL ONTO EMPLOYEE'S LEG.

EMPL WENT OUT ON BEAM TO REMOVE COMEALONG. COMEALONG CAME LOOSE CAUSING EMPL TO LOOSE BALANCE & FELL APPROX FIVE FEET ONTO HANDRAIL THEN ABOUT ANOTHER 6' TO FLOOR.

EE WAS REPAIRING A TRUCK FRAME CROSSMEMBER. HE WAS USING A 3\4" DRIVE SOCKET SET TO TIGHTEN FLANGE BOLTS AND PULLED A MUSCLE IN HIS NECK. HE WENT TO KNUDSEN CHIROPRACTIC FOR X RAYS AND MAINPUL ATION.

INJURED IS A PRODUCTION SHIFT FOREMAN AND HE WAS PUSHING DOWN ON LARGE PIPE WRENCH WHEN HE FELT A PAIN IN LOWER RIBS THEY WERE UNPLUGGING A MUD SCREW HE DID NOT GO TO DR UNTIL 7-20-90 AND DIDN OT REPORT TO CO UNTIL 8-3-90.

EMPL REMOVING U-JOINT FROM DRIVELINE.HIT U-JOINT WITH HAMMER AND PIECE OF METAL LODGED IN RIGHT EYE.

INJURED WAS HOLDING A BRICK SHIM IN PLACE WHILE ANOTHER EE WAS POUNDING IT IN. THE HAMMER DEFFECTED AND STRUCK INJURE'S MIDDLE FINGER.

IN WORKING TO UNPLUG DUST SCOOP DISCHARGE PIPE HOT DUST FILLED EMPLS GLOVE.

THE CREW WAS LIFTING A NEW SECTION OF CHUTE IN POSTION. IT WAS HUNG UP AND WHEN IT WAS MOVED WITH A BAR IT MOVED SUDDENLYSTRICKING HIM IN THE LIP.

THE EMPLOYEE WAS JACKING UP THE PAC-TRAC DRILL WHEN THE JACK FLEW OUT AND STRUCK HIM.

EMPLOYEE WAS USING A 10LB SLEDGE HAMMER TO KNOCK THE ROCKS THAT WERE STUCK OUT FROM BETWEEN THE GRIZZLEY BARS.

EE WAS USING A METAL BAR AND CHAIN FOR LEVERAGE TO MOVE A GEARBOX THE PRESSURE OF PUSHING ON THE BAR PUT A STRAIN ON HIS RIGHT KNEE.

IN USING A PUNCH AND HAMMER TO DRIVE OUT BOLTS FROM THE TANK #12 DRIVE COUPLING, MISSED AND STRUCK HAND.

HAMMERING WITH SLEDGE HAMMER TO GET FLOWING HAMMER SLIPPED AND HIT HIS FINGER.

EMPLOYEE WAS USING A COMBINATION 11/4" TO LOOSEN FLANGE BOLTS ON A 6" TRANSPORT LINE ON TOP OF THE A SILOS BOX END OF THE WRENCH SLIPPED ON THE NUT & THE OPEN END OF THE WRENCH STRUCK THE EMPL OYEE THE RESULTING CUT REQUIRED 5 STITCHES

WAS CLEANING ACCUMULATED CORRISION FROM THE POST OF SHOP PICKUP AND SOME OF THE MATERIAL FLEW INTO HIS EYE.HE WAS TAKEN TO OCCUPPATIONAL HEALTH ASSOCIATES.THE EYE WAS WASHED WITH SALINE AND HE WAS GIVEN A PRESCRIPTION FOR EYE DROPS.LIMITED WORK ACTIVITY FOR ONE DAY DUE TO POSSIBLE BLURRED VISION.

EMPLOYEE WAS STRIPING INSULATING FROM ELECTRICAL WIRE WHEN HIS KNIFE SLIPPED CAUSING LACERATION TO LEFT HAND LACERATION WAS CLEANED & SUTURED & THE EMPLOYEE RETURNED TO WORK

THE EMP WA USING A HAMMER A(D HAD A SPLINTER FORM THE HANDLE LODGE IN HIS PALM. TO REMOVE THE SPLINTER THE DOCTOR LACERATED THE PALM AND REQ. 2 STICHES. TO CLOSE.

REPLACING SEPARATOR DUST COLLECTOR FAN INTO FAN HOUSING. WORKERS WERE ADJUSTING CLEARANCE BETWEEN BLADES ; WHEN THEY LOOSENED THE UNIT ON THE HUB THE FAN BLADES UNEXPECTEDLY CLOSED TOGETHER. RING FINGER, LEFT HAND WAS SHEARED AT THE FIRST KNUCKLE.

WORKING ON COVEYOR FLASHING LOOSENING BOLTS.APPLIED PRESSURE TO WRENCH WHEN SHARP PAIN OCCURRED IN BACK.

INJURED WAS REMOVING AN O-RING FROM A BOBCAT CYLINDER WITH A SMALL ICEPICK TYPE TOOL THE TOOL SLIPPED FROM THE O-RING & PUNCTURED H IS LEFT HAND AFTER 2 DAYS IT BECAME INFECTED

A PIPE WAS PUT 6NDERNEATH AIR COMPRESSOR TO USE AS A CATAPULT TO SHIFT THE AIR COMPRESSOR WHEN PRESSURE FROM LIFTING AIR COMPRESSOR CREATED STRAIN ALONG LEFT SIDE

INJURED WAS POU3DING A SKIM BETWEEN TWO BRICKS WITH A SLEDGE HAMMER. WHILE POUNDING THE HEAD OF THE HAMMER SLIPPED OFF THE SHIM AND HIS LEFT INDEX FINGER STRUCK THE METAL SHIM. INJURED WAS W EARING GLOVES B6T THE SHIM CUT THROUGH CAUSING A LACERATION WHICH REQUIRED STITCHES.

THE EMPLOYEE WA8 WORKING AT THE B2 FLUXO PUMP ATTEMPTING TO CLOSE THE INLET CHUTE WITH A SIDE BLIND.IN USING A SLEDGE HAMMER TO DRIVE THE BLIND IN, THE EMPLOYEE MISSED, STRIKING HIS RIGHT THU MBNAIL ON THE B5IND.THE NAIL WAS TORN OFF.