Stockbridge Quarry Metal/Non-Metal

Employee was lifting a 992G loader shank into the loader bucket. The employee went to release the shank and felt a pop in lower back.

Employee lost footing while tramming manlift causing EE's foot to come off safety deadman switch. The machine stopped abruptly causing the employee to fall and striking EE's right shin on the kick rail.

Employee struck EE's left lower back on a conveyor support frame. Employee received bruising on EE's back.

As technician was torqueing wheel fasteners on the RRO of a 777 haul truck, the torque wrench shifted causing the wrench to crush the technicians left hand between the wrench and the wheel hub.

As employee was loading a jack plate back onto truck it slipped out of employee's hands smashing the middle finger on right hand

An employee was injured while using a torch to cut the nut off the back of a sand screw flight. The hot nut burned a hole through employee's pant leg which then allowed the nut to fall down into employee's boot causing a third degree burn to the right foot.

The employee was attempting to throw a flop gate, when a piece of metal fell from the chute striking the employee in the left forearm causing a laceration.

EE was removing old lip shroud from loader bucket using a pneumatic wrench. While holding the worn bolt head with gloved hand the bolt spun causing laceration to left index finger.

Slipped off the bottom step on the truck, fell into a hole at the shot, fractured right fibula.

Employee was cutting out a damaged profile on the screen deck with a torch. The employee lost his balance and fell onto the piece he cut off.

EMPLOYEE WAS STEMMING HOLES WITH A 5 GALLON BUCKET AND SPRAINED HIS BACK LIFTING THE BUCKET.

EE WAS CHANGING THE ENGINE BELT TENSIONER ON THE KOMATSU PIT LOADER WHEN INJURED.THE EE WAS PRYING THE TENSIONER BACK TO PUT THE BELT BACK ON, THE PRY BAR SLIPPED OFF AND THE EE'S HAND WAS PIN CHED BETWEEN THE TENSIONER PULLEY & FAN GUARD.

COOLING CONTAINER WAS NOT FLUSHED OR EMPTIED BEFORE PUTTING ON CRANE. THEN COOLING FLUID IGNITED AND STARTED TO BURN. AFTER USING TWO EXTINGUISHERS, FLAME STILL WAS BURNING. FINALLY IT WAS PUT OUT WITH DIRT AND MUD. BEFORE DOING SO, EE BREATHED SMOKE AND TOXIC FUMES IN HER LUNGS. DUE TO SMOKE INHALATION, THROAT AND LUNGS WERE BURNT. SHE WAS HOSPITALIZED.

EE OPENED DOOR TO GET OUT OF TRUCK WHICH WAS ON INCLINE. DOOR SLAMMED BACK ON RIGHT 5TH FINGER CAUSING LACERATION AND FRACTURE.

EE WAS DESCENDING LADDER ON HAUL TRUCK. HE LOST HIS BALANCE AND FELL.

WHILE EXITING DOZER D-30, OPERATOR SLIPPED AND FELL STRAINING HIS LEFT SHOULDER.

OPERATING OFF ROAD TRUCK WITH DEFECTIVE SHOCKS, HIT BUMP IN HARD ROAD AND INJURED BACK SOMEHOW.

EE STATES: I WAS PUTTING A FUNNEL ON CHUTE AND IT SPRANG LOOSE AND HIT MY FRONT TOOTH.

EE WAS LOADING A SCREEN LIP ON BACK OF THE WELDING TRUCK WITH ANOTHER EE. EE WAS PUSHING HIS END OF THE SCREEN ON THE TRUCK WHEN HE PINCHED HIS FINGER BETWEEN THE LIP OF THE SCREEN AND THE STE P OF THE WELDING TRUCK.

EMPLOYEE WAS PLACING YOKE ON INPUT SHAFT OF TRANS ON EC# 7992. HIS LEFT HAND WAS PLACED UNDER THE YOKE FOR SUPPORT. HIS RIGHT HAND WAS HOLDING SIDE OF YOKE W/ RIGHT THUMB WAS IN CAPHOLE. YOKE SLIPPED AND WHEN HE TRIED TO CATCH IT HIS RIGHT THUMB WAS CUT.

EE WAS APPROACHING THE DRILL CONTRLS WHEN HE\WASSTRUCK ON THE TIP OF THE NOSE WITH A VERY SMALL PIECE OF STEEL. THE SOURCE OF THE STEEL IS UNKNOWN.

TIRE FELL WHILE EE WAS ATTEMPTING TO CHANGE TIREON HAUL TRUCK.

EMPLOYEE WAS USING A CRESCENT WRENCH AND TIE ROD SEPARATOR TO REMOVE PINS FROM A MOWER CARRIAGE. TOOL BROKE AND POPPED HIM IN THE MOUTH. GASH IN UPPER LIP RESULTED FROM TOOL.

SOMETIME DURING THE DAY ON 7-20-95 THE INJURED GOT SMALL PIECE OF METAL IN LEFT EYE. HE IS NOT SURE WHEN IT MICHT HAVE HAPPENED.

DROPBALL OPERATOR WAS ASSISTING IN REPLACING THE HOIST CABLE ON THE LINK BELT DROPBALL CRANE WHEN HE FELL OFF THE TOP OF THE HOUSING RESULTING IN LACERATIONS AND CONTUSIONS.

EE A SERVICEMAN WITH 41/2 YRS EXPERIENCE WAS ATTEMPTINT TO START A RIMPULL HAUL TRUCK HE WAS USING THE STEERING ROD AS A STOP TO REACH THAT FITTING WITH THE AIR HOSE WHILE DISMOUNTING THE TRUC K HE STOPPED INTO A RUT CAUSED BY RAIN THE NIGHTBEFORE AS HE CAME DOWN HIS RT ANKLE TURNED UNDERNEATH HIM HE RECEIVED MEDICAL ATTENTION FOR THE SPRAIN

A CLASS A PERPAIRMAN WITH 16 YRS EXPERIENCE WAS STANDING ON THE WORK PLATFORM OF #3 TOWER BYT HE7' SHORT HEAD CONE CRUSHER. WHILE LIFTING HT EBOWL LOCK ARM WITH HIS RIGHT HAND AND ATTEMPTING TO SET THE BOLT WITH HIS LEFT HAND, THE CRUSHER JUMPED BACK AND CAUGHT HIS LEFT THUMB BETWEENTHE BOLT AND THE LIFTING LUG.

EMPLOYEE, A UTILITYMAN, WAS HOLDING A WRENCH WHILE TIGHTENING BOLTS ON THE #4 CRUSHER. ANOTHER EMPLOYEE WAS HITTING THE WRENCH WITH A HAMMER WHEN THE WRENCH JUMPED OFF, STRIKING THE EMPLOYEE'S LEFT INDEX FINGER. EMPLOYEE THOUGHT FINGER WAS ONLY BRUISED & DID NOT GO TOTHE DOCTOR UNTIL JAN '94 WHEN FRACTURE WAS DIAGNOSED.

EE WAS CLIMBING DOWN OFF #2 SCREEN IN PLANT. WHEN HIS FOOT TOUCHED FLOOR HE TURNED HIS ANKLE. INJURY WAS DIAGNOSED AS A SPRAIN.

EMPLOYEE WAS HOLDING UP REDIUS ARM ON 65T DAR TRUCK. WHEN IT SLIPPED IN HIS HAND AND STRAINED HIS LEFT THUMB.

54736YEE OU T OF POSITION & OVER EXERTED HIS SHOULDER & NECK

OPERATOR WAS TURNING HIS HAUL TRUCK WHEN HE STRAINED HIS RT SHOULDER

FOREIGN MATTER BLEW IN THE EMPLOYEES RIGHT EYE AND HE IRRITATED IT BY RUBBING.THE FOREIGN MATTER WAS EMBEDDED AND HAD TO BE REMOVED.

INJURED INJURED HIS NECK WHEN HE HIT HHIS HEAD ON THE COUNTERWEIGHT OF A FMC DROPBALL.THE INJURED HAD FINISHED INSPECTING THE ROLLERS AND THOUGHT HE HAD CLEARED THE MACHINE WHEN HE RAISED UP S TRIKING THE COUNTERWEIGHT WITH HIS HARD HAT.HE HAD SURGERY FOR TWO HERNIATED DISCS.

UNLOADING PALLET OF RUBBER SCREEEN PANELS WHEN ASSISTANT SHOVED LOAD ONTO RIGHT HAND PINCHING ALL 4 FINGERS RESULTING IN 30 STITCHES.

WORKING 175C LOADER CYLINDER. EMPLOYEE HAD CYLINDER PROPPED UP WITH 2X4 BOARD. BOARD KICKED OUT FROM UNDER CYLINDER AND IT FELL, LANDING ON EMPLOYEE'S TOP SIDE LEFT HAND.

CHANGING SCREENS ON RAIL TOWER,STRAINED MUSLCE IN BACK.

CLEAN-UP ELEVATED AREA AROUND RADIAL STACKER TRAVEL WAY. OPERATOR BACKED BACKHOE OFF CONCRETE SLAB ONTO SOFT SAND WITH BUCKET FULLY LOADED AND APPROX. 3/4 RAISED. MACHINE STARTED TO TIP OVER -OPERATOR JUMPED OFF AND THEN TRUNED BACK AND TRIED TO RETURN TO MACHINE. MACHINE TIPPED OVER AND R.O.P. CAB CAUGHT HIS ANKLE. COMPOUND BREAK ON ANKLE.

MOVING BOOM ON HYDRAULIC YARD CRANE.

WHILE HAMMERING IN SCREEN PANELS HIT FINGER ON SPRAY BARS CRACKED BONE

EMPLOYEE STRAIN9D A MUSCLE IN HIS UPPER LEFT FOREARM WHILE SHOVELING. EMPLOYEE DID NOT SEEK MEDICAL ATTENTION UNTIL 2-8-88.

EMPLOYEE WAS AT7EMPTING TO CHECK A CIRCUIT USING A MULTIMETER HIS LEADS CONTACTED A 2300 VOLT COIXX CIRCUIT CAUSING THE LEADS TO SHORT OUT. EMPLOYEE SUFFERED BURNS TO BOTH HANDS AND FLASH BURN TO HIS EYES. 3

EMPLOYEE & ONE 2THER WERE UNDER CONVEYOR PUSHING UP ON CONVERYOR WITH THEIR BACKS (ON HANDSX & KNEES) TWO OTHER EMPLOYEES WERE REMOVING A RETURN ROLLER ONE OF THE EMPLOYEES LOST HIS GRIP ON TH E ROLLER & IT F9LL STRIKING I.NAME LEFT HAND LACERATING & FRACTURING HIS MIDDLE RING & LITTLE FINGER

OVER HEATED WHI5E WAITING FOR WATER TRUCK TO FILL UP PASSED OUT-HEAT EXHAUSTION

EMP WAS REPLACI3G DRAG CABLE ON DRAGLINE HEMADE A LOOP IN THE CABLE AND PLACED THE LOOSE END IN THE WEDGE SOCKET OF THE DRAG DRUM. HE THEN BENT OVER TO GET MORE SLACK IN THE CABLE THE END OF T HE CABLE CAME O6T WHIPPED AROUND AND STRUCK HIS R EAR CAUSING A LACERATION, 10 SUTURES

EMPLOYEE WAS HO5DING A BAR WHILE ANOTHER EMPLOYE WAS HITTING IT WITH AN 8 LB SLEDGE HAMMER THE HAMMER HIT A GLANCING BLOW CAUSING THE BAR TO GO SIDEWAYS THE INJUREDS HAND HIT THE MOTOR CASE H E WAS HELPING R9MOVE SHEAVE FROM MOTOR

EMPLOYEE WAS RE4OVING SHEAVE TO REPLACE SEAL ON SHAFTR SHEAVE IS ON A VERTICAL SHAFT THEREFORE EMPLOYEE HAD TO PLACE HIS HAND & WRFENCH UNDER THE SHEAVE IT CAME LOOSE SOONER THAN EXPECTED & ST RUCK HIS LEFT F2REARM CAUSING A LACERATION REQUIRFING STITCHES(THE SHEAVE WAS NOT SECURED)

EE WAS IN THE P9OCESS OF LIFTING GUARD & DUE TO CLOSE CLEARANCE HE DID NOT POSITION HIS HAND EXACTLY IN THE CORRECT POSITION. AS THE GUARD WAS MOVED IN AN UPWARD MOTION HE MASHED HIS FINGER B ETWEEN THE GUAR8 & AN ELECTRIC MOTOR ONT HE TOP DECK OF THE R/R BINS.

EMPLOYEE WAS TI1HTENING ALLEN HEAD BOLTGS BY STRIKING ALLEN WRENCH WITH HAMMER ALLEN WRENCH SPRUNG OUT OF BOLT & STRUCK EMPLOYEE ON LEFT INDEX FINGER FRACTURED & LACERATED LEFT INDEX FINGER

OPERATOR ATTEMP7ED TO UNCLOG CHUTE WITH A IRON BAR BAR SLIPPED FROM THE OPERATORS HAND CAUSING HIS HAND TO COME INTO CONTACT WITH THE SIDE OF THE CHUTE THUS LACERATING HIS LEFT HAND ABOVE THE THUMB 3

EMPLOYEE WAS ATTEMPTING TO REMOVE CHOKER CABLE FROM BRIDGE POLE LOST HIS GRIP AND FELL TO THE GROUND

EMPLOYEE WAS STANDING ON CAB PROTECTOR OF HAUL TRUCK IN AN ATTEMPT TO UNCLOG A BIN. WHEN THE MATERIAL BROKE LOOSE FROM THE BIN, IT THREW THE INJURED EMPLOYEE TO THE GROUND

PIECE OF DROPBALL FLYROCK FLEW THROUGH AIR STRIKING PIPE HANDRAIL OUTSIDE OPERATOR CAB.GLANCED INTO CAB HITTING EMPL IN LEFT TESTICLE. SURGICALLY REMOVED ON 3-1-83.