Buscar en el registro

While positioned on a ladder, EE was cutting a section of a 8" X 8" X 1/2" tube to fit it in place. When EE turned EE's body, EE made contact with the hot tube with EE's shoulder.

Employee was opening the can of welding rod and the lid cut their left hand.

Employee pinched right middle finger between plate and wear liner, amputating the top portion of the finger midway on the nail bed, above the top knuckle.

2 employees were moving a wire cable reel in preparation to pull cable for a new service when one employee lost balance/footing and fell backwards. As they fell backwards, they landed on their rights side, mostly on their right elbow. Employee continued the shift/work as the supervisor and only felt like they bruised their elbow.

EE was removing a wear pad when it fell landing on EE's thumb.

Employee was performing maintenance on the 992K loader bucket. While EE was swapping out the bucket teeth, EE sustained an injury to EE's left middle finger.

While replacing an HSI crusher lift cylinder, the component shifted, pinning the employee's finger against the crusher wall. The employee sustained an open fracture of the left middle distal phalanx. Treatment included stitches, a splint, and medication with work restrictions.

Employee was removing the bucket on the skid steer when it fell landing on EE's foot.

While removing belts from a screen, a motor fell onto the left ring finger of the repairman, resulting in a 2cm laceration that required four stitches.

EE was attempting to move a rock that weighed approximately 40 lbs. from the catwalk. When they swung the rock, it did not clear the middle handrail and pinched the tip of their left ring finger between the handrail and the rock.

Employee was gripping a screen by putting EE's fingers through the openings to lift it. As EE was picking it up, it caught against another screen as EE pulled up, it came loose dropping and pinching EE's finger between the two. Employee sustained a cut to a finger on EE's left hand and received six stitches.

IW was dismounting the adjustment ring with EE's right hand on the top locking post when the feed cone swung and pinched EE's right middle finger between the locking post and feed cone, resulting in a fracture and laceration to EE's right middle finger.

The employee was changing the jaw cylinder when a bolt fell landing on their pinky finger.

TYCO MACHINE EMPLOYEE WAS INSTALLING BELTS ON ROCK CRUSHER AND PINCHED RT HAND PINKY FINGER.

Employee was assembling a smudge pot heater when they felt something snap in their left hand. They sought medical attention February 11, 2026 and was diagnosed with a sagittal band rupture. Employee is currently on restricted duty.

Employee alleged that EE wiped EE's eye and inadvertently transferred something from EE's glove into EE's eye.

While welding the employee noticed irritation to one eye and realized EE had something in EE's eye.

Employee was attempting to remove a screen from the lower deck, when the screen became stuck. The employee chipped out some frozen material and EE attempted to remove the screen again. As the screen came loose, the employee jolted backwards and hit EE's head on a crossmember in the screen. The employee decided to seek out medical attention on 12/17/25.

Employee was working in a 5-man team to screw bowl of crusher in place. While exerting force with EE's arms EE's right shoulder was strained.

Employee was changing springs on the 8x20 screen. Employee was trying to remove the spring when the chain broke allowing the spring to pinch a finger.

While removing a guard on a motor to measure a sheave, employee smashed left finger.

Employee felt pain in neck and shoulder when they manually closed a rail car door on October 20, 2025. They sought medical attention on January 29, 2026 and was prescribed physical therapy.

EE was assigned to drain and refill the jaw crusher oiler, as EE was holding the bucket in place, EE felt EE's lower back give out.

Removing an umbrella stand from the back of the service truck. Set stand down on uneven ground, Stand fell striking EE's gloved Right inner thumb and palm. Suspected fracture confirmed by Ortho on 9-24-2025.

ON 9/26/2025, EMPLOYEE RECEIVED MEDICAL TREATMENT FOR (L) KNEE AND WAS PLACE ON RESTRICTED DUTY WHICH CANNOT BE ACCOMODATED. THE EMPLOYEE REPORTED NUMBNESS TO THE BACK OF THE KNEE AND EE WAS DIAGNOSED WITH (L) KNEE DERANGEMENT. NOTE: EE REPORTED THE NUMBNESS LATE.

In the process of moving a pallet of rollers, one of them shifted and fell off the pallet. As the employee was attempting to get the roller back in position for the backhoe, it landed on EE's foot. EE sought medical treatment on August 18, 2025 and was diagnosed with a fracture and released to full duty.

Employee was cutting metal when EE tried moving a piece EE felt pain in EE's arm.

EE was shoveling material off of C-15 when they felt a pain in lower back. Did not seek medical treatment until 7/15/2025.

Employee was working with another employee trying to remove a pin holding the hydraulic cylinder on a rock hammer. The employee requested to seek medical attention on August 6, 2025

Wiped sweat from face with a paper towel, right eye became irritated

EE had an adjuster drop 3-4" on EE's hand fracturing EE's left pinky finger

Employee was helping remove a panel from a screen when the screen panel jerked their arm down and over extending upper arm causing pain in shoulder. The incident occurred on 6/11/2025 but the employee's shoulder became worse over time and they had to receive surgery on 6/23/2025.

EE was working on loader seat and got hand pinned between scissor frame.

On 05-29-25 employee alleges a strain to the left lower back when operating a CAT 769D haul truck. EE states that the initial left lower back strain occurred on 05-28-25. While the employee was attempting to move a pallet with a pallet jack. On 05-30-25 employee was treated by a MD for a strain to the left lower back, resulting in modified work activity.

On Wednesday 5/14/2025, fixed maintenance employees were working on reinforcing a stacking conveyor, when the stacker failed. This resulted in a conveyor beam striking an employee on the right leg. Diagnosed with right leg contusion/abrasion, was prescribed medication and placed on restricted duty.

Employee was lowering fork units to the ground and when it fell to the ground the other employee's finger that was in the expanded metal got bent and dragged causing a minor fracture to the tip of the finger.

EE was hosing off pad under feeder when a rock fell out of a hole and struck EE in the shoulder.

Employee was assisting loading VSI hammers from a pallet to a loader bucket. Employee moved 1 hammer (118 lbs.) and complained of back and leg pain.

Employee felt a pop in EE's knee when EE was climbing up to check shims on a hazemag. EE worked full duty until EE had surgery on March 7th for a meniscal tear.

Employee was washing out the sand screw when EE lost control of the hose. The hose struck EE in the left eye.

EE was pushing a roller and felt pain/pop in right shoulder.

On 2/6/25, employee was working in the top deck of the wash screen, when employee stood up and hit head on the spray bar. Did not seek medical treatment until 2/11/25.

Employee was putting a steering cylinder on the back of a service truck when it slipped, fracturing EE's finger.

Employee went to pick up a piece of pipe and strained their back.

12-30-24 a fuel truck/lube oper was fueling excavator, slipped on grease, & fell into excavator. Point of contact of injury was left side.1-2-25 rec'd treatment w/no job restrictions/days off. 1-9-25 went to follow up w/no changes in instructions. 1-23-25 XRay showed fractured rib. EE hasn't missed any work & has no restrictions. But this makes the injury reportable.

Quality control technician was adjusting the forks on a Gradall forklift & placed right hand between the back of the fork and the back of the attachment, resulting in a laceration to the right ring finger and small finger.

Employee reported that they were removing rocks from a catwalk in November and later alleged soreness in their left hamstring. Employee thought they would be fine, but approximately a month later, was still feeling pain in the left hamstring and sought medical attention on 12/09/2024. On 12/09/2024, management was made aware of employee being prescribed physical therapy.

EE was placing a track pad when EE felt a slight strain in their neck.

Employee was clearing rocks under the standard crusher when a large rock striking the employee's right pinky and ring finger.

While opening a gate valve, the data plate/tag between the hand wheel and the nut, cut through the employee's glove resulting in a laceration to their right thumb. Their thumb was bandaged and employee was issued restrictions.