Belt Foreman, Maintenance Foreman, Maintenance Supervisor fatality
On 7/29/16, employee and co-worker were re-welding guards over the drive shaft of the turbine pump located on the surface above the #3 Shaft. Shortly after welding was completed, an ignition occurred in the #3 Shaft and employee received significant burns and lacerations. The investigation of this event is on-going. Employee died from the injuries on 8/4/16.
- Classification
- IGNITION OR EXPLOSION OF GAS OR DUST
- Accident type
- Contact with hot objects or substances
- Activity at time
- Welding Or Cutting
- Subunit / location
- SURFACE AT UNDERGROUND
- Source of injury
- FLAME,FIRE,SMOKE,NEC
- Nature of injury
- BURN OR SCALD (HEAT)
- Total mining experience
- 40 years
- Experience at this mine
- 0.27 years
- Experience in this job
- 18 years
- Mine type
- Underground
- Sector
- Coal
- July 31, 2019 · KenAmerican Resources Inc · KY · Welder (Shop)
FMC employees were attempting to seal the hoist shaft at the Bremen Portal at Ken American Paradise Mine No. 9. Steel beams were welded in place metal decking was secured covering the shaft. Methane accumulated in the shaft and caused a series of two explosions 4-5 seconds apart. The second explosion killed FMC…
- May 9, 2018 · Lhoist North America of Alabama, LLC · AL · Dryer Operator, Kiln Operator, Dry Plant Operator, Fluid Operator, Bed Dryer Operator
The injured miner & the supervisor were attempting to light the #2 kiln's gas flame. While the miner was holding a flare attached to a metal pole at the end of the gas pipe, the supervisor turned on the gas. In the process of lighting, the gas ignited & blew back through the front of the kiln causing burns to the…
- June 18, 2014 · Heidelberg Materials Southeast Agg., LLC · SC · Outside Foreman, Leadman
The employee was present while two contract workers were performing a repair on a centrifugal water pump. During the repair, an explosion occurred. Heat may have been applied during the repair. The employee suffered fatal injuries.