Fawndale Rock & Asphalt Metal/Non-Metal

Climbing up a ladder to access the control shed. After stepping off of the ladder, he turned & hit his left elbow on a safety chain ring. He then felt faint, cat down & passed out 1 - 5 minutes. Reported incident 6 hours later to foreman. Went to Redding Occupational Medical Clinic. Returned to work that night. No lost time.

Employee reached around an employee that was using a 4 1/2" grinder and grabbed the metal he was cutting. Pinched the grinding wheel and it jumped and cut his left forearm. Note: Employee was also dehydrated which led to the hospital stay.

worker was climbing off 8x20 screen deck and hit forehead on a bolt.

Employee was grinding and welding on 1/18/10. Does not know specifically when metal got into his eye. Went home and noticed eye irritation and went to Eye Doctor after-hours. Notified Employer of injury on 1/19/10.

Employee was carrying bags of ANFO to drill holes on a quarry bench. He indicated the next morning that his lower back was sore but that the condition may be due to a previous injury with another employer.

Employees was walking near screen plant bag house and slipped in mud

Employee was operating an excavator with equipped with a hammer when he observed a hydraulic line tangled around the "thumb". He stepped on the side of the hammer to reach the line and slipped causing an ankle sprain.

Worker was walking backwards and tripped into a crusher mantle liner lying upside down on the ground and sustained injury to his ribs, upper back and neck.

Miner was removing cutting edges from a CAT 988B loader and lacerated left middle finger on sharp edge on a bolt.

EE WAS WORKING ON CRUSHER

EE WAS REMOVING A LARGE ROCK LODGED IN FEED HOPPER. MATERIAL ABOVE CAME LOOSE AND A SMALL PIECE OF ROCK GOT INTO EMPLOYEE'S EYE.

EMPLOYEE WAS REMOVING GUARD TO REPLACE BEARING ON HEAD PULLEY. WHILE LIFTING OPEN TOP PORTION OF GUARD, EMPLOYEE'S RIGHT HAND SLIPPED & BOTTOMOF GUARD CAUGHT EMPLOYEE'S LEFT THUMB BETWEEN GUARD AND FRAME MEMBER.

WORKER CLIMBED UNDER HANDRAIL TO CONNECT A COME-A-LONG TO THE END OF A CONVEYOR BELT THAT WAS B EING INSTALLED. AS HE WAS SITTING ON THE CONVEYOR FRAME HE LOST HIS BALANCE AND FELL TO THE GROU ND.

WORKER WAS HOLDING A LARGE WRENCH ON A NUT WHILE ANOTHER WORKER TIGHTENED THE BOLT WITH AN AIR IMPACT GUN. WHEN THE BOLT TIGHTENED ON THE NUT IT CAUSED THE NUT TO TURN AND THE WORKERS HAND WAS CAUGHT BETWEEN THE WRENCH AND A STEEL BEAM.