Spring Branch No 1Coal

EMPLOYEE SLIPPED AND FELL BOTH FEET WENT UNDER TIRE OF ROOF BOLTER AS IT WAS MOVING, BRUISED BOTH FEET.

HE TRIED TO MOVE BULL GEAR FOR A HEAD DRIVE OUT OF SCOOP BUCKET.

THE EMPLOYEE GOT HURT ON 10/6/01 BUT DID NOT GO TO THE DR UNTIL 10/26/01. HE WAS HELPING WORK ON A FEEDER LIFTING A TAIL SHAFT ASSEMBLY WHEN HE FELT PAIN IN LOWER BACK.

CONTINUATION OF ROOF FALL REPORTED ON 8/6/01 FALL CONTINUED FROM THE NO 2 ENTRY OVER TO THE #1 ENTRY THE NEW AREA THAT FELL IS 90'LONG 8'THICK AND 18'WIDE. THE AREA HAS BEEN TIMBERED AND CRIBE D OFF.

ROOF FALL LAST OPEN CROSS CUT IN THE NO.2 ENTRY ON ACTIVE SECTION ONE CROSS CUT INBY SPAD 51 FALL 18' WIDE, 6'-7' THICK, 20'LONG. THE AREA HAS BEEN DANGERED OFF TIMBERS SET AND CRIBS BUILT.

ROOF FALL ON 003-0 SECTION FIRST LEFT PANEL OFF OF ACTIVE MAINS FALL IN #5 ENTRY 3 X CUTS OUTBY FACE FALL 25'L X 18'W X 6' THICK AREA TIMBERED AND CRIBS BUILT AND DANGERED OFF.

INJURED ROOF DRILL OPERATOR WAS ASSISTING THE OFFSIDE DRILLER IN STRAIGHTENING A BEND ROOF BOLT WHEN THE INJURED'S LEFT WRIST WAS STRUCK BY THE ROOF BOLT SPINNING.

BOLTING TOP AND PUSHED HIS THUMB OUT OF SOCKET.

EE GOT HIS FOOT ON THE TRAM PEDAL OF A MAC 8 ANDIT PULLED HIM INTO THE TOP AND RIB OF THE MINE.

TOP DETERIORATED QUITE A LOT.

ROPE SNAPPED AND BROKE EMPLOYEE'S THUMB, HE WAS PULLING ON A CABLE.

EMPLOYEE WAS OPERATING A SCOOP. SCOOP RAN OVER A ROCK AND EMPLOYEE HIT HIS HEAD ON TOP.

EMPLOYEE WAS PULLING ON A CABLE AND STRAINED HIS BACK.

HOLDING DRILL STEEL AND MASHED HAND. CAUGHT HIS HAND BETWEEN THE DRILL STEEL AND CANOPY.

EE WAS BENDING A ROOF BOLT AND HURT HIS BACK.

WHILE OPERATING RAM CAR, HE HIT A BUMP AND HIS HEAD HIT THE CANOPY, BREAKING HIS TOOTH.

EE WAS ROOF BOLTING AND A PLATE HIT HIS ARM.

ROOF BOLTING THE TOP, HE CAUGHT HIS LEFT KNEE BETWEEN THE BOOM AND THE RIB OF THE MIND.