JEFFERSON CITY MILL Metal/Non-Metal

INJURED WAS GOING DOWN A 45 DEGREE EMBANKMENT TO REMOVE A ROCK FROM THE ROADWAY THAT HAD FALLEN OFF ON A PREVIOUS TRIP WHEN HE SLIPPED AND HURT HIS RIGHT KNEE. (REQUESTED MEDICAL TREATMENT 08 -17-94).

INJURED AND CO-WORKER WERE REPAIRING PINION SHAFT ON "D" ROD MILL AND LEFT OVERHEAD CRANE POSITIONED TOO LOW RESULTING IN INJURED HITTING HIS HEAD ON THE CRANE HOOK.

INJURED WAS STANDING IN FRONT OF DISCHARGE BOX THROWING 2 1/2" GRINDING BALLS INTO MILL WHEN HE HIT HIS RING FIGNER BETWEEN BALL AND DISCHARGE BOX.

INJURED WAS REPAIRING EXHAUST FANS IN THE MILL SCREEN BUILDING AFTER TESTING THE CIRCUIT FOR SHORTS HE ENERGIZED THE STARTER A FAULT OCCURRED N THE MANUAL STARTER CAUSING IT TO EXPLODE & THE R ESULTING FLASH BURNED HIS RT ARM (INJURED REQUESTED MEDICAL TREATMENT 08-26-93)

INJURED DUMPED A DIPPER OF LIME INTO HOPPER CONVEYOR HE THEN DISMOUNTED LOADER TO PUNCH LIME ONTO CONVEYOR BELT AS HE DESCENDED LADDER HIS FOOT SLIPPED & HE FELL

A FLAT ROCK PLUGGED THE CHUT EBETWEEN #1 BELT AND THE ROBBINS SCREEN. INJURED AND CO-WORKER WERE CLEARING THE CHUTE FROM THE WALKWAY #1. INJURED WAS STANDING AT A 45 DEGREE ANGLE TO THE CONV EOYR. THE SCALING BAR WAS DRIVEN INTO THE HANG UP AND INJURED PULLED HARD ON THE BAR. APPARENTLY THE BAR CAME BACK FURTHER THAN HE EXPECTED, CAUSING HIM TO LOSE HIS BALANCE AND FALL BACKWARD

INJURED AND CO-WORKER HAD BEEN MAKING REPAIRS TO THE MILL BIN. WHEN THEY STARTED TO EXIT THE MILL BIN INJURED REPORTED TO HIS SUPERVISOR THAT HE FELT A BURNING PAIN IN HIS BACK WHEN HE CLIMBED OUT OF THE BIN.

INJURED WAS SERVICING THE BARFORD SURFACE LOADER. AS HE WAS GREASING THE BOOM, WHILE STANDING ON TOP OF THE FRONT TIRE, HE SLIPPE DON SOME GREASE TWISTING HIS RIGHT KNEE AND STRIKING IT ON TH E LOADER FRAME.

JULY 16 INJURED WAS TIGHTENING A BOLT WHILE REBUILDING ENGINE. HE DID NOT SEEK MEDICAL ATTENTION UNTIL AUGUST 13 DIAGNOSIS WAS RECEIVED FROM DR DATED 10-12-92 STATING THAT INJURED HAD SUFFERED TENDONITIS RIGHT HAND.

INJURED WAS DRILLING A 3/4" PLATE. WHIEL HANDLING THE PLATE A SMALL SLIVER WENT INTO HIS RIGHT MIDDLE FINGER. THE SLIVER WAS REMOVED AT THAT TIME. HOWEVER, ON MARCH 9, 1992, THE FINGER BEGAN T O SWELL AND LOOK INFECTED AT THE POINT WHERE THE SLIVER ENTERED THE FINGER.

INJURED AND CO WORKER WERE REMOVING A BOOM PIN. AS INJURED LOWERED THE PIN TO THE FLOOR HE FELT A PAIN IN HIS BACK. THE PAIN WENT AWAY AND HE DID NOT REPORT IT LATER THAT NIGHT HE REPORTED THE PAIN HAD GOTTEN WORSE.

INJURED WAS INSTALLING PTO ON A TRANSMISSION.AS HE LIFTED THE PTO AND TWISTED AROUND,HE FELT A PAIN IN HIS RIGHT KNEE.THE PTO WEIGHT IS APPROXIMATELY 75 LBS.

CLIMBING OVER CURB TO PUMP SLIPPED ON OIL

INJURED AND CO-WORKER WERE CHANGING A FEEDER PAN ON #3 CRUSHER FEEDER. AS THEY WERE REMOVING THE PAN, A 3" X 3" X 1/2" X 20" LONG ANGLE, WHICH SUPPORTS THE CRUSHER, FELL STRIKING INJURED ON TH E RIGHT SHOULDER.

INJURED AND CO-WORKER WERE CHANGING A HYDRAULIC HOSE ON A SURFACE FRONT END LOADER. INJURED WAS TIGHTENING A FITTING WHEN HE FELT A PAIN IN HIS BACK.

INJURED WAS REMOVING AN AIR TANK FROM AN ST-8 LOADER. AS HE AND CO WORKER LIFTED THE TANK UP ONEOF THE SIDE GUARD WELDS BROKE AND CAUSED AN 5 X 3/4 X 6 STEEL FLAT BAR TO FALL AND STRIKE INJURE D ON THE TOP OF HIS RIGHT FOOT. THE FLAT BAR FELL AND STRIKE INJURED ON THE TOP OF HIS RIGHT FOOT. THE FLAT BAR FELL WITHOUT WARNING.

INJ REPAIRING BOOM GUIDE SHELL ,CO-WORKER ACTIVATED GUIDE IN WRONG DIRECTION CAUSING SLIDE TO PINCH INJ THUMB.

INJURED, WHILE WALKING, STEPPED OFF A SMALL RIDGE IN THE FLOOR AND TWISTED ANKLE.

INJURED WAS WALKING PAST 7' CONDITIONING TANK WHEN HE SLIPPED ON SOMETHING SLICK AND FELL PULLING A MUSCLE IN LEFT LEG.

AT THE END OF THE SHIFT INJURED WAS WALKING THROUGH THE OFFICE PARKING LOT WHEN HE FELL INTO A DITCH STRICKING HIS CHEST ON A DRAINAGE PIPE.

INJURED WAS SHOVELING ROCK AND DEBRIS THAT HAD FALLEN UNDER BELT. HE WAS STANDING ON INCLINE LEVEL SHOVELING MATERIAL FROM FLOOR AND PUTTING IT ON THE BELT WHICH IS ABOUT WAIST HIGH.

INJ DRAGGING MOTOR BACK TO A-POIDMETER LIFTING MOTOR UP ON POIDMETER FRAME

INJURED REACHED TO HIS LEFT GRASPING BAR AND ROTATING TO HIS RIGHT- FELT SHARP PAIN IN HIS LOWER BACK AREA. BAR WEIGHED APPROX. 30 POUNDS. (BACK BEGAN TO BOTHER EMPLOYEE AFTER INCIDENT)

EMPL WAS DISASSEMBLING DIAMOND DRILL. HE WAS USING 2 LB HAND-HELD HAMMER. HAMMER SLIPPED & EMPL RECEIVED WOODEN SPLINTER IN LEFT THUMB.

INJURED WAS REPAIRING DRAFT DIVERTER ON HIGH PRESSURE WASHER. WHILE DRILLING OUT SHEET METAL TO INSTALL SOME SCREEWS DRILL HE WAS USING SLIPPED OFF CENTER CAUSING HIM TO STRIKE HIS LEFT THU MB ON SHARP PORTION OF METAL PLATE RESULTING IN LACERATION TO LEFT THUMB.

INJURED WAS OPERATING A CAT 988 FRONTEND LOADER DURING WINDY CONDITIONS DURING OPERATION INJURED EXPERIENCED GETTING SOME AIRBORNE PARTICLES OF AGRICULTURAL LIMESTONE BLOWN IN HIS LEFT EYE INJ URED RECEIVED MEDICAL TREATMENT CONSISTING OF PRESCRIPTION EYE DROPS FOR MINOR IRRIATION

INJ & COWORKER LIFTING PIPE ELBOW 250 LBS TO BE BOLTED INTO PLACE.WHILE POSITIONING ELBOW INTO PLACE INJ FELT MUSCLE PULL IN HIS STOMACH.INJURY THOUGHT TO BE MINOR ORIGINALLY CONTINUED TO WORK UNTIL HE UNDER WENT SURGERY ON 5-17-88 FOR HERNIA.

INJURED AND CO-WORKER WERE CLOSING RAILROAD CAR DOORS IN PREPARTION TO LOAD LIMESTONE. INJURED WAS USING A STEEL BAR TO CLOSE THE DOORS SO THEY COULD BE LATCHED AND LOCKED. INJURED INSERTED BAR INTO LATCH AND APPLIED PRESSURE TOCLOSE THE DOOR. AS HE APPILED PRESSURE, THE BAR SLIPPED CAUSING HIM TO LOSE HIS BALNACE AND FALL BACKWARD RESULTING IN A N ACUTE SPRAIN TO THIS RIGHT ANK

INJURED ORIGINA5LY PULLED MUSCLE ON 10-22-87 NEEDED NO MEDICAL TREATMENT AND LOST NO TIME HOWEVER DUE TO CONTINUED AGGRAVATION ON 11-23-87 EMPLOYEE STATED HE WANTED TO GOT TO A PHYSICIAN INJU RED AND COWORKE9 WERE MOVING C POD TO ANOTHER FEEDER WHEN HE FELT A MUSCLE PULL IN HIS LOWER BACK

INJURED WAS USI3G AN AIR HOSE TO DISLODGE WET MUCK IN A CHUTE NEAR THE HEAD OF NO 2 SECONDARY SCREEN WHEN INJURED ATTEMPTED TO CHANGE POSITIONS THE AIR HOSE GOT CAUGHT IN V BELT DRIVE BELTS & PULLEY & AROUND3HIS RT LEG & PULLED INJURED AGAINST THE V BELT GUARD PINNING HIM UNTIL HELP ARRIVED

INJURED WAS LUBRICATING THE DIPPER OF A FRONT END LOADER WHEN THE FLEXIBLE HOSE ON THE GREASE GUN RUPTURED INJECTING GREASE UNDER THE SKIN OF THE INJURED\S LEFT HAND.

INJURED WAS DESCENDING A LADDER TO THE INSIDE OF A FLOATING RIVER BARGE TO OBTAIN SAMPLES OFZINC CONCENTRATE ORE. WHILE DESCENDING THE LADDER INJURED REPORTED IT SLID TO ONE SIDE MAKING IT NEC ESSARY FOR HIM TO JUMP TO THE FLOOR OF THE BARGE. INJURED JUMPED APPROX. 7\ ANDSUSTAINED A SPRAINED RIGHT ANKLE IN THE PROCESS. THE BOTTOM OF THE LADDER WAS STABLIZIED, HOWEVER, THE TOP WAS U

INJURED AND CO-WORKER WERE ATTEMPTING TO PUT THE BARREL OF A 5" SAND PUMP THROUGH THE WINDOW OF THE MILL BASEMENT WHEN CO-WORKER ABRUPTLY PULLED THE PUMB BARREL CAUSING IT TO CHANGE DIRECTION AND CATCH INJURED MINER\S FINGER AGAINST THE FORKLIFT.