Mine #2: 20 reportable incidents Coal

ROCK FALL OCCURRED IN THE NO. 5 ENTRY 2 BREAKS INBY SPAD NO. 832 AND EXTENDING INBY FOR 90' LONG 18' WIDE AND 5' HIGH. CRIB WERE SET TO BREAK THE FALL.

A FALL OCCURRED FROM SPAD NO.862 INBY TO THE FACE OF NO.7 HEADING FOR A DISTANCE OF 50'X18'WIDEX36"-40" THICK AND OUTBY FOR A DISTANCE OF L0' X 18' WIDE X 36"-40".

A FALL OCCURRED 2 BREAKS OUTBY SPAD #862 FOR 60 FTLONG 18 FT WIDE 36 IN X 40 IN HIGH

ROOF FALL WAS FOUND WHILE MAKING PRESHIFT IT FELL IN #8 ENTRY FROM LAST CROSS BACK FOR 2-1/2 BREAKS

WHILE BENDING R2OF BOLTS HE STRAINED HIS LOWER BACK.

WHILE LIFTING ON A MOTOR ON THE DRILL HE HURT HIS SIDE

WHILE PULLING C5BLE OF REEL, PULL MUSCLE IN LOWER BACK.

HE WAS INSTALLI3G A JUNCTION BOX IN THE HIGHLINE AND STARTED TO TIGHTEN THE BOLT WHICH HELD THE LID ON WHEN HIS WRENCH SLIPPED AND HIS HAND HIT THE SHARP EDGE OF THE BOX CUTTING HIS HAND AND T HUMB. 3

A PIECE OF META5 FLEW FROM THE HAMMER THAT WAS BEING USED TO DRIVE PIN IN CUTTER CHAIN

THE EMPLOYEE SA3D PULL A MUSCLE IN HIS LEFT ARM WHILE BENDING LONG BOLTS IN LOW TOP PUTTING UP 60 INCH PINS IN 34 INCH COAL SEAM.

WHILE STANDING 3BE SIDE A WORKMAN WHO WAS DRIVING A BEARING ON A SHAFT. A PIECE OF METAL BROKE OFF THE BEARING AND STRUCK ME IN THE LEFT HAND.

LARGE METAL PIP9 BEING USED FOR BLEADER ROLLED OFF OF BLOCK AND FELL ON LEFT THUMB REMOVING NAIL AND SPLIT IT.

WHILE SETTING 16RB CUTTER OVER HE SAT THE MACHINE ON HIS LEFT LEG.

WHILE TRAMMING 1INNER UNDER CUTTER CABLE THE BOLTER CAUGHT THE CABLE.THE OPERATOR TRIED TO AVOID CABLE AND FAILED TO SEE THE RIB AND CAUGHT HIS LEFT HAND BETWEEN PINNER AND RIB.

HIT RIGHT ELBOW3AGAINST SCOOP WHILE GETTING ON SCOOP.

HIT RT ELBOW AGAINST SCOOP WHILE GETTTING ON SCOOP