MSHA record for San Juan Plant (mine ID 0401738). Fatalities, non-fatal incidents grouped by year, current operator and controller, and mine context.
Email me when a new MSHA incident is filed at San Juan Plant.
EMPL CHANGING TEETH ON BUCKET WHEN 1 TOOTH SLIPPED OFF SHANK AND LANDED ON LEFT SIDE OF LEFT BOOT BEHIND STEEL TOE.
EMPL DID NOT SEEK MEDICAL ATTENTION UNTIL 4/13/89 & DID NOT NOTIFY SUPERVISOR UNTIL 5/8/89.
EMPLOYEE WAS PUTTING A V BELT DRIVE SHIVE ON A SHAFT.
WHILE ASSISTING A WELDER EMPL LOOKED AT THE WELDING ARC FLASH BURN TO BOTH EYES
EMPLOYEE WAS TRIPPING SWITCH ON ELECTRIC BOX WHEN IT EXPLODED.
DRIVING AND LIFTING. EMP. FEELS THIS IS CUMULATIVE.
EMPLOYEE WAS BE3T OVER WELDING ON A RE-CRUSH BOX.
WHILE REPLACING3STARTER EMPLOYEE INJURED ARM & NECK
EMPLOYEE WAS RE4OVING RADIATOR CAP TO CHECK WATER ON EUCLID, THE RADIATOR UNEXPECTEDLY BLEW.
THE BOTTOM DOORS ON THE PLANT TRUCK WOULD NOT CLOSE BECAUSE 4 ROCKS WERE JAMMED BETWEEN THE UPPER HINGES HE WAS ABLE TO REMOVE 3 OF THE ROCKS HE T RIED TO REMOVE THE FOURTH ROCK BY USING A L ARGE ROCK ANDHITTING IT BACK INSIDE WHEN THE ROCK FREED THE DOOR HINGES DROPPED BREAKING THE ROCK HE WAS USING AND SMASHING HIS FINGER
WHILE ATTEMPTING TO REMOVE CLAY BALL FROM CONEYOR HE PULLED STOP CORD & ATTEMPTED TO PUSH BALL OFF BELT AT SAME TIME STOP CORD FAILED TO STOP CONVEYOR MOVING CLAY BALL PULLED HIM FOR A FEW FT STRAINING HIS LOWER BACK
ROLL OF CONVEYOR BELT WAS BEING LIFTED USING BELT BRIDLE.EMPL HAD HAND ON HOOK ATTACHED TO POLE GOING THROUGH CENTER OF BELT.BELT LOADED ONTO POLE LOPSIDED WHEN ORIG SHIPPED BY VENDOR.WHEN LOA DER LIFTED ROLL OF BELT,HOOK SHIFTED SMASHING FINGER BETWEEN HOOK AND STOP ON END OF POLE.
CONVEYOR STOPPED.EMPL WENT TO RESET ELEC BOX AND IT EXPLODED.
TAKING DEBRIS OFF CONVEYOR BELT THERE MUST HAVE BEEN SOME POISON OAK ON THE BELT