UNIVERSITY PLANT Metal/Non-Metal

EE WAS SCOOTING A SCREEN IN ON THE MIDDLE DECK OF THE HEWETT ROBINS SCREEN WHEN IT SLIPPED STRIKING HIM ON THE NOSE.

HEAT TRANSFER OIL POURED FROM #2 SILO WHEN EE WAS INVOLVED IN TURNING HOT OIL BACK ONTO SILO

EMPLOYEE TURNED ON MAIN AIR LINE. HE WENT TO CHECK HOSE AND IT BLEW OFF SPRAYING SMALL OBJECT ONHIS HANDS.

TRIPPED OVER ELECTRICAL WIRE WHICH AGGRAGATED PREEXISTING ARTHRITIC CONDTION

SHOVELING WITH A HOE, WHEN IT WAS CAUGHT IN BEAM, AND LEFT SHOULDER POPPED, CAUSING STRAIN TO LEFT SHOULDER.

EE PULLED MUSCLE IN MIDDLE OF BACK WHILE SWINGING A #12 SLEDGE HAMMER, REMOVING LINER WEDGES FROM CONE CRUSHER.

EMPLOYEE WAS LIFTING BLADE MILL SPIRALS INTO BLADE MILL WHEN HE FELT A BURNING SENSATION ON HIS RIGHT SIDE.

EE WAS INSTALLING A RETURN ROLLER ON A CONVEYOR WHEN HIS FINGER GOT SMASHED BETWEEN THE ROLLER AND THE FRAME.

EE WAS HAULING MATERIAL, SAW A LARGE BOULDER IN THE HAUL ROAD, & ATTEMPTED TO SWERVE TO MISS IT. THIS CAUSED A STRAIN IN HIS SHOULDER.

EE WAS WELDING BRACES FOR A SAFETY PLATFORM WHEN HE SLIPPED & FELL BACK ON SHAKER WALL.

EMPLOYEE WAS DISLODGING ROCKS BENEATH A RUNNING CONVEYOR WHILE THE BELT WAS RUNNING WITH THE HANDLE TO THE SHOVEL. THE HANDLE STRUCK BETWEEN THE ROCKS CAUSING IT TO FLIP OVER AND STRIKE THE EM PLOYEE IN THE ARM.

LEFT KNEE "POPPED" AS EE WAS CRAWLING OUT FROM UNDERNEATH JAW CRUSHER

HE CLAIMS LOADER "BUCKS" WHEN BRAKES ARE APPLIED. THIS RESULTED IN LOWER BACK STRAIN. LOADER IS BEING TESTED BY CATERPILLAR FOR ALLEGED PROBLEMS. PLEASE BE ADVISED THAT THE ABOVE REFERENCED CL AIM SHOULD HAVE BEEN RECORDED AS OSHA NOT MSHA. AT THE TIME OF THE ACCIDENT, HE WAS FEEDING THE CONCRETE BATCH PLANT, WHICH COMES UNDER OSHA.

TRIPPED ON A 1" PIECE OF WIRE STICKING OUT OF CONCRETE SLAB. FELL ON LEFT ARM AND SHOULDER.

WHILE LOWERING TOOTH ON CHAIN TO UNPLUG JAW CRUSHER, MATERIAL MOVED, PULLING CHAIN DOWNWARD CAUSING HAND TO HIT I BEAM, FRACTURING RIGHT THUMB.

LOST BALANCE STEPPING OFF LOADER LADDER TO CONCRETE STEP AT THE FUEL ISLAND.HIT LEFT HIP AGAINST THE LADDER.

EMPLOYEE WAS TRIMMING TABS OFF EURETHANE SCREEN PANELS WITH A RAZOR KNIFE. KNIFE SLIPPED OFF PANEL AND CUT HIS LEFT THIGH.

SEAT ON LOADER WOULD NOT ADJUST FAR ENOUGHT FORWARD FOR EMPLOYEE TO REACH BRAKE & ACCELERATOR PEDALS SO HE OPERATED THE LOADER ALLDAY LEANING FORWARD BOUNCING & VIBRATION HURT BACK & HIP BY TH E END OF THE DAY Y

SLIPPED WHILE COMING DOWN CONVEYOR WALKWAY SPUN AROUND & STRUCK LEFT KNEE ON ANGLE IRON

TRYING TO REMOVE THE DRIVE SHEAVE FROM THE NEW ASH 12 X 14 PUMP. THE EARS OF THE BUSHIN GHA DBUSTED OFF AND THE EMPLOYEE WERE USING APORT A POWER AND PULLER TO TRY TO REMOVE THE SHEAVE. ONE OF THE BOLTS ON TE PULLER BROKE SHOOTING THE BOLT END OUT AND STRIKING ELMPLOYEE IN THE RIGHT CHIN.

EMPLOYEE STEPPED ON A PIECE OF ANGLE IRON WHILE CARRYING HIS TOOLS TO THE COMPANY WORK TRUCK, HE WAS ABOUT TO USE.

EE LOST HIS FOOTING ON MATERIAL LAYING ON CONVEYOR BELT CAUSING HIM TO STUMBLE AND FALL CONVEYOR WAS LOCKED OUT.

EMPLOYEE WAS PULLING ON V-BELT AND WATCHING A FELLOW EMPLOYEE EMPLOYEE ASSISTING HIM.HIS HAND GOT TOO CLOSE THE THE PULLEY AND WAS DRAWN IN EQUIPMENT WAS DEENERGIZED AND LOCKED OUT PROPERLY.

EE WAS USING TRUCK #60609 AS A WORK PLATFORM WHILE SETTING ROTOR INTO #70048 IMPACT CRUSHER. EE WAS STEPPING FROM THE TRUCK BED TO PLATFORM ON THE CRUSHER. EE TOOK HIS EYE OFF THE PLACE WHERE HE WAS GOING TO STEP & LOOKED UP AT THE ROTOR FLYWHEEL HE WAS ABOUT TO GRAB AHOLD OF. EE FELL ABOUT 3' TO THE GROUND AND FELT A PAIN JUST ABOVE THE LEFT KNEE.

WHILE STEPPING ONTO THE JAW HE SLIPPED AND KNOCKED HIS HARD HAT OFF & HIT HIS HEAD ON CROSSBEAM.

EMPL DISLODGED A STEEL WEAR PLATE WHICH WAS BLOCKING THE CHUTE TO #72355 CONVEYOR. THE CONVEYOR WAS LEFT RUNNING TO EMPTY THE MATERIAL OUT. EMPLTRIED TO GRAB THE PIECE OF PLATE OFF THE BELT & SMASHED & TORE HIS LEFT INDEX FINGER.

EMPLOYEE WAS CHECKING HYD PRESSURE ON MAIN LIFT CIRCUIT AND WAS CLIMBIN GUP TO CAB TO START ENGINE TO CHECK PRESSURE. SLIPPED ON LADDER, CAUGHT HIMSELF ON RAIL WITH ARMS.

WHILE WORKING ON PIPE JOB AT WET PLANT, A PIECE OF DUST/METAL/RUST ENTERED RIGHT EYE. (EMPLOYEE WAS WEARING SAFETY GLASSES.)

EMPLOYEE WAS CUTTING CONDUIT AND AFTER THE CUTTER WENT THROUGH, THE CUT PIECE FLIPPED DOWN AND CUT HIS RIGHT HAND JUST ABOVE THE FINGER KNUCKLE.

EMPLOYEE WAS ATTEMPTING TO MOVE A LARGE PIECE OF ASPHALT TO THE CRUSHER WHEN IT SLIPPED OUT OF HIS HANDS AND FELL AGAINST HIS RIGHT LEG. HE SUFFERED AN ABRASION TO HIS RIGHT LEG AND A SPRAINE D RIGHT ANKLE.

DRIVING EULCID FROM PIT TO GRIZZLY ON HAUL ROAD AND STARTED HAVING BACK PAINS.

EMPLOYEE WAS WORKING ON JAW CRUSHER.HE TRIED TO GET THE PITMAN TO MOVE BACK THE TOGGLE DROPPED ONTO HIS RIGHT HAND.

TIGHTENING BOLTS ON BAR-MAC CRUSHER, EMPLOYEE WAS PULLING ON WRENCH WHEN HE STRAINED HIS LOWER BACK.

USING SLEDGE HAMMER TO ADJUST ROCK CRUSHERS AND ADJUST CONVEYOR BELTS CAUSED LUMP ON RIGHT WRIST-DIAG GANGLION CYST.

DRIVING ECLID FROM PIT TO FEEDER, FELT PAIN IN HIS UPPER BACK AND SHOULDER.

THE EE DID NOT SEEK MEDICAL TREATMENT IMMEDIATELY AND THE TREATMENT BY A PHSICIAN DID NOT COME TO THE ATTENTION OF THE CO UNTIL 9-10-90. WHILE INSTALLING V BELTS ON SCREEN, SHEAVE SLIPPED AND PULLED THREE MIDDLE FINGERS ON RIGHT HAND.

TAKING TAIL PULLEY OUT OF 1388 CONVEYOR PULLEY SLIPPED & PINNED RIGHT HAND AGAINST FRAME SMASHED RIGHT HAND

EMPLOYEE STRAINED RIGHT SHOULDER ON 5/1/90-FIRST AID TREATMENT; REINJURED SHOULDER ON 5/10/90 WHEN HE CLIMBED OVER HAND RAIL.

SWINGING KNOCKER WRENCH AND WRENCH SLIPPED HITTING EMPLOYEE IN THE STOMACH.

WHILE POUNDUNG WEDGES INTO CRUSHER SPARINED RIGHT WRIST.

ATTEMPTING TO KNOCK THE NUT LOOSE ON THE MANTLE STRAINED LEFT SHOULDER.

EMPLOYEE WAS WALKING ON CRUSHER DECK, FOOT SLIPPED ON ROCK AND RIGHT LEG FELL IN HOLE BETWEEN CRUSHER AND DECK.

EMPLOYEE MOVING LARGE ROCK OUT OF CONVEYOR ROCK HIT RIGHT FOREFINGER. HE HAD HIS GLOVES ON.

SPRAINED LEFT ARM WHILE TAKING UP CRUSHER 5-012

OPERATOR WAS ST2CKPILING MATERIAL IN EUCLID WHEN ONE WHEEL WENT OVER A LARGE ROCK CAUSING THE EMPLOYEE TO BOUNCE UP AND HIT HIS HEAD ON THE ROOF OF THE CAB.