Apex LandfillMetal/Nonmetal

The operator was climbing down a ladder on a 980XE CAT loader. Operator misjudged the last step and fell backwards to the ground approximately 3'. Operator sustained a left wrist fracture.

The Driver backed up to dump at the dump site, he lifted the bed to dump and the berm gave way and truck went over the berm backwards, when the driver was removed from the cab he complained of back pain. EMS Transported Miner to the hospital.

Clearing 30"" rock from feeder and got foot smashed between the rock and track hoe bucket in efforts to remove rock.

EE was stepping out of lube truck # 172160 and stepped on a rock twisting his ankle.

While exiting equipment he lost hand hold and slip tripped.

Repairing a conveyor belt and the board in which was supporting the belt slipped and caused EE to fall 5-6' on the ground.

Employee was getting out of Bulk truck. As he went to get down he lost his grip and fell to the ground. Employee went to emergency room and was told he was ok. Still suffering from pain 3 days later he went to doctor who found a fractured rib. Doctor released him to work. Still in pain 2 weeks later he went to doctor on 1-29-08 and was told to take a week off.

EE gasses up a air compressor at start of his shift. spitting some gas while fueling on his right hand. after fueling up air compressor. He went over to tother area to start a project, which required to use a torch. When he struck the starter to light the cutting torch a spark hit his right hand, causing it to burn his hand that the fuel spilled on. He went to umc burn right

Employee was lifting up grizzly bar and it slipped and pinched his pinky finger on right hand.

Climbing off loader, slip & fall on the ladder, hurt back.

THE APPRENTICE WAS CHECKING THE SCREEN DECK, WHEN HE SLIPPED AND TWISTED HIS RIGHT ANKLE. IN RESULT, BREAKING THE ANKLE.

EE WAS REPAIRING EQUIPMENT (WELDING) THE FLASH OF THE WELDING WAS BRIGHT AND GAVE HIM A FLASH BURN ON THE EYES. THE WELDING SHIELD LENS WAS OLD.

EMPLOYEE GOT ON THE LAND CONVEYER TO GREASE THE HEAD PULLEY, WHEN HE WAS DONE GREASING, HE TRIPPED TO GET OFF AND SLIPPED OFF THE BELT FRAME, WHEN HE HIT THE GROUND HIS LEFT KNEE GAVE OUT.