Email me when a new MSHA incident is filed at Hazen Mine.
| Quarter | Hours worked | Citations | S&S | Per 1M hrs |
|---|---|---|---|---|
| 2024 Q4 | 230 | 0 | 0 | 0.0 |
| 2024 Q2 | 1,477 | 0 | 0 | 0.0 |
| 2024 Q1 | 3,673 | 9 | 5 | 2450.3 |
| 2023 Q4 | 9,647 | 0 | 0 | 0.0 |
| 2023 Q3 | 14,013 | 0 | 0 | 0.0 |
| 2023 Q2 | 8,948 | 0 | 0 | 0.0 |
| 2023 Q1 | 9,676 | 0 | 0 | 0.0 |
| 2022 Q4 | 8,590 | 4 | 0 | 465.7 |
Supervisor was changing out chemical at wash plant and got it into place. It wasn't square on the stand so they had employees rig chain around top of cage and tried to square it up. The cage broke and two employees tried to stop it and one got a cut on their finger that required 2 stitches and the other got a severe wrist sprain. Neither will miss a scheduled day of work.
Got a finger caught between pulley and belt when attempting to change drive belts.
Flame detector, detected the igniter sparking & opened up the main gas valve. When the valve opened up, it filled the Plenum with gas. Then when the Pilot light lit, it caused a hard ignition and caused damage to the I-beams that support the floor plates.
Miner was shoveling loose sand with a standard square shovel when EE strained EE's shoulder.
Dryer lifted off of the pedestal, caused damage to the internal floor support I-beams. This was caused from too much gas inside of the dryer prior to ignition. Engineer was called to look at the dryer. No major indication of what specifically caused the over gas condition. Troubleshot all gas components, air systems and all systems checked good. Dryer started up per design.
Employee was placing a metal plate under jack of generator that was supported by a chain. A twist in the chain caused it bounce as it straightened pinching employees finger between jack and metal plate. Right middle finger