Leach PitMetal/Nonmetal

Employee had just climbed up a ladder to a catwalk to start a engine. They climbed down and as they got the ground it was muddy so it caused them to slip and land awkwardly on their leg.

EE was at a fuel station away from pit filling up transfer tank on work truck. Ground conditions were wet from rainstorm previous night. EE turned to pump and at the same time the nozzle started to fall from tank. EE tried to grab nozzle before it fell and in the process slipped on the wet ground resulting in fall, hurting ankle. ER doctor informed EE that it was a sprain.

Employee was standing on a steel plate and leaning over to work on conveyer. The steel plate slid out from underneath EE causing EE to fall onto the conveyer.

Sunny day with light winds. 55 degress

EE was going to assist another EE get a rock loose from a conveyor belt. EE tripped over an air hose and fell hitting EE's left hand on a PVC pipe.

Injured employee & another employee were removing gearbox on conveyor. Injured employee had gearbox in hand, turned to set it down when he felt pain in lower back. The other employee said he heard a pop.

EE was loading things into his pickup outside the scale house. He slipped on loose rocks. He fell with his right leg under him. His right foot was under his right hip.

He was hooking a water hose to fill up the water truck tank. He felt a sting or bite on the inside of his left wrist. It started turning red so he was taken to the ER for a spider bite.

slipped on step

He stepped up on the conveyor frame that was about 4 ft high. The conveyor was not working because the generator was down and locked out. When he stepped up he was looking at his co-worker, then fell backwards. He was dazed and confused afterwords. He did not know for sure if he fell or if he passed out.

EE was doing maintenance a shaker screen.While greasing the driveshaft he discovered one grease fittings was not accessible.He rolled the v-belt drive with his left hand to gain access to the fitting,by doing this he pinched his left index & middle finger in between the belt and drive sheave causing an open fracture on both fingers.

He was running the Front End Loader to load trucks with aggregate. His back started hurting and became worse. His back had been bothering him for several weeks and he said it just got worse.

EE was running a skid loader. He stopped it with the bucket up to scratch his leg. He put his foot outside of the cab of the loader. He moved his right foot that was controling the bucket lever and it fell on his left foot.

Shoveling aggregate, felt strain in right shoulder and lower back

HE WAS TRYING TO PUT LEGGING ON BELT. GOT FINGERCAUGHT BETWEEN PRY BAR AND FRAME CRUSHER.

EE WAS WALKING ALONG & TRIPPED & FELL. COULD FIND NO OBSTRUCTIONS TO CAUSE THE FALL.