American Gilsonite Company · Struck against stationary object
EMPL WAS CARRYING A VENT PIPE TO WORK AREA WHEN HE STRUCK HIS HEAD ON A LOW TIMBER CAUSING HIM TO SRAIN HIS NECK AND BACK
E-30 Mine Metal/Non-Metal
American Gilsonite Company
· Underground
Controlled by
Chevron Corporation
Uintah County,
UT
·
Abandoned
MSHA Mine ID: 4201781
MSHA record for E-30 Mine (mine ID 4201781). Fatalities, non-fatal incidents grouped by year, current operator and controller, and mine context.
Watch this mine
Email me when a new MSHA incident is filed at E-30 Mine.
- Fatalities
- 0
- Total incidents
- 13
- Years on record
- 1983–1988
- Latest incident
- Nov 1988
No fatalities recorded at this mine.
Reportable incidents
13 on file1988 · 3 incidents
American Gilsonite Company · Fall onto or against objects
MINER WAS STARTING THE HEEL, MINING ON THE BOTTOM. HE LOST HIS BALNCE AND GRABBED TUGGER CABLE PULLED HIS FINGER INTO THE PULL BACK PULLEY, CUTTING LEFT LITTLE FINGER.
American Gilsonite Company · Struck by falling object
MINER WAS CUTTING ORE ON BOTTOM OF SLOPE WHEN A LUMP OF ORE CAME DOWN HITTING HIM IN THE FACE AND CUTTING HIS UPPER LEFT LIP.
1987 · 3 incidents
American Gilsonite Company · Struck by... (Not Elsewhere Classified)
EMPLOYEE WAS MI3ING GILSONITE WHEN A ROCK CAME LOOSE STRIKING HIM ON THE HAND. EMPLOYEE HAS A BROKEN BONE IN RIGHT HAND.
American Gilsonite Company · Struck by rolling or sliding object
AS THE EMPLOYEE3WAS MINING ON TOP OF THE SLOPE, A PIECE OF ORE ROLLED DOWN THE SLOPE STRIKING HIM IN THE KNEE.
January 9, 1987
UT · Metal/Non-Metal
ledgeman/hand, quarry man
FALL OF FACE/RIB/PILLAR/SIDE/HIGHWALL
American Gilsonite Company · Struck by falling object
MINER CUTTING H3TCH IN WALL TO PUT TIMBER ON LOOSE ROCK. ROCK CAME LOOSE FROM THE WALL HITTING EMPLOYEE ON THE LEFT HIP.
1986 · 1 incident
American Gilsonite Company · Struck by flying object
EMPLOYEE WAS CU7TING TIMBER HITCH IN RIB WITH A CHIPPING HAMMER AND A MOIL THE END OF THE MOIL BBROKE OFF STRIKING HIS RT KNEE
1985 · 2 incidents
American Gilsonite Company · Accident type, without injuries
THE E-30 MINE HAD BEEN EQUIPPED WITH AN ORE HOISTING BUCKET UPON LEAVING THE MINE AT THE END OTSHIFT TWO MINERS WERE TRAPPED IN THE BUCKET WHEN IT WAS BEING HOISTED DURING HOISTING THE BUC KET TIPPED AND ONE EDGE CAUGHT ON THE SHAFT WALL CAUSING THE BUCKET TO WEDGE BETWEEN THE SHAFT WALLS FOUR GUIDE RAILS WERE DAMAGED
American Gilsonite Company · Caught in, under or between a moving and a stationary object
MINER SAID HE RAISED CAGE UP IN SHAFT & STOPPED IT ABOUT 20 FT. ABOVE HIM. HE THEN OPENED AIRLIFT ELBOW & STARTED CLEANING IT. THE HOISTMAN & TWO ELECTRCIANS IN HOISTHOUSE SAID THEY THOUGHT IT WAS RELEASED, SO ELECTRICIANS HAD HOISTMAN LOWER CAGE TO BOTTOM TO CHECK & RESET LIMIT SWITCH. MINER WAS PINNED BETWEEN AIRLIFT & CAGE FOR ABOUT 5 MINUTES BEFORE FREEING HIMSELF.
1983 · 4 incidents
American Gilsonite Company · Struck by... (Not Elsewhere Classified)
CUTTING TIMBER HITCH WHEN THE MOIL & HAMMER SLIPPED RUNNING THE END OF MOIL THRU LITTLE FINGER.
American Gilsonite Company · Fall from scaffolds, walkways, platforms
BUILDING FLOOR WHEN BOARD SLIPPED AND HE FELL 12\ TO THE SLOPE.THEN ROLLED ABOUT 80\ DOWN 45DEGREE SLOPE.
American Gilsonite Company · Struck by... (Not Elsewhere Classified)
MINER WAS CUTTING A HITCH WITH A CHIPPING HAMMER WHEN THE MOIL SLIPPED AND CUT HIS LEFT PALM.
American Gilsonite Company · Struck by falling object
CUTTING ORE ON THE SLOPE WITH A CHIPPING HAMMER
For insurers, brokers, and safety consultants
The full compliance file on E-30 Mine
A dated report covering the 26-year penalty trail, line-item violation pattern, contest and docket posture, rate-normalized peer benchmark, and full fatality history. Delivered as a PDF with the underlying data as CSV.