There were some large rocks on the dumping berm. When the loader operator cleaned the rocks off the operator pushed the berm over the dump area. After the truck driver got another load the driver backed up to dump and didnt know the berm was out until the driver felt the wheel drop over the dump leading to driver tipping over the truck.
Pushing with a D11 and ran over a big rock. The dozer slammed to the ground and hurt the operators back.
EE was climbing up on EE's truck and the steps were too high. Resulting in EE losing balance and falling backwards to the ground. Hurting shoulder, neck, head, back and arm on the right side.
EE was driving a rock truck and hit a pot hole, causing it to rattle EE around the inside of the truck. Injuring EE's mid back.
While getting on the rock drill, the employee slipped on the cat walk and twisted his ankle
While putting anti freeze in the loader, the employee stepped on a loose metal plate and twisted his ankle.
Employee stepped on top of out-rigger to retrieve tool foot slipped and slid behind out rigger-employee lost balance and fell backward.
EE RAISED THE ENGINE HOOD, HAND WAS LACERATED BY METAL PART.
THE TRAILER BED WAS RAISED TO DUMP THE COAL. THE HOIST JACK BROKE AND THE TRAILER BOX TURNED OVER. THE TRACTOR DID NOT TURN OVER.
FUEL LINE BECOME LOOSE ON COAL LOADER. CAUSING LOADER TO FLASH FIRE OPERATOR EXTINGUSHED FIRE. HE SAID HE LOOKED TO SEE IF THE FIRE WAS OUT WHEN IT FLASHED FIRE. CAUSING SLIGHT BURNS TO HANDS AND ARM BELOW ELBOW.
OPERATOR STATED THAT HE WAS OPERATING THE LOADER ON A UNLEVEL COAL SEAM AND THAT IT CAUSED HIM TO PUT MORE STRAIN ON HIS LEFT LEG.
OPERATING DOZER ON STEEP SLOPE, PULLING MUSCLE IN LEFT SIDE OF CHEST. OPR DID NOT REPORT ACCIDENT UNTIL 12:30 PM - 10/30/02.
DRIVER LOST CONTROL OF VEHICLE, CAUSE UNKNOWN. NO MECHANICAL FAILURE IDENTIFIED AS OF THIS DATE.TRUCK PROCEDED AROUND 1ST CURVE AND HIT HILLSIDE IMMEDIATELY STOPPING FORWARD MOTION. DRIVER SUS TAINED BRUISES, MINOR LACERATION AND BROKEN RIB.
LADDER BROKE WHEN OPERATOR WAS GETTING OFF LOADER CAUSING HIM TO FALL.
OPERATOR STATED HE WAS TRAVELING TO FAST INTO OUTFRANCE OF 2 STOCKPILE AND HIT THE BURM CAUSING SEAT TO POP UP AND INJURED HIS NECK.
OPR. STATES HE WAS OPERATING LOADER ON DOWN SLOPE OF HAULROAD AND IT BECAME NECESSARY TO DROP BUCKET TO STOP LOADER. OPR ALSO STATED HE DID NOT REMEMBER INJURING HIMSELF.
FALL, BUMP ON HEAD - COMPLAINING OF BACK PAIN (MIDDLE BACK) - LEFT SHOULDER.
EE STATES: I WAS REPAIRING AN EMULSION HOSE ON TOP OF TRUCK. I LEANED BACK AGAINST THE SAFETY RAIL AND IT BROKE AT THE WELD SEAM. I FELL OFF THE TRUCK ONTO THE GROUND HITTING MY RIBS AND HIP.
EMPLOYEE OPERATOR WAS LOADING ROCK WITH 9920 ENDLOADER WHEN BUCKET OF LOADER HIT A ROCK, JARRINGLOADER AND OPERATOR.