No 1a Mine Coal

HEARING LOSS 3

HEARING LOSS. 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS. 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

HEARING LOSS 3

EMPLOYEE WAS UN5OADING STONE HEAD IN TOP FLOOR OF FILTER BLDG WHEN HE WENT TO SET BARRELL UP. THE BARRELL SLIPPED IN CHAIN AND CAUGHT HANDS.

EMPLOYEE BENT O5ER TO PICK UP BELT CHAIN. SLIPPED AND FELL TWISTED BACK.

18'SLAB AND 2 P3LLARS HAD BEEN PULLED AND NO FALL HAD OCCURRED.CREW WAS SETTING BREAKER AND TURN TIMBERS TO MINE NEXT BLOCK.WHEN MASSIVE FALL OCCURRED.CONCUSSION THREW I.NAME AGAINST SCOOP.

18'SLAB AND 2 P3LLARS HAD BEEN MINED OUT AND NO FALL OCCURRED.CREW WAS SETTING BREAKER AND TURN TIMBERS WHEN MASSIVE FALL OCCURRED AND CONCUSSION THREW I.NAME AGAINST MINER.

EMPLOYEE WAS RE1LACING CONVEYOR SHAFT IN A 12 CM JOY MINER SHAFT FELL ON EMPLOYEES FINGER

ROOF FALL-NO.4 6NIT-1 RT. PILLAR SECTION (016) IN THE NO.53 PILLAR. FALL MEASURED 20 FT WIDE, 40 FT LONG, AND 6'-12' HIGH.

ROCK FELL ON C6TTER HEADS WHILE EMP WAS OPERATING MINER CAUSING MINER BOOM TO HIT MINE ROOF THE FORCE OF THE MINER RAISING UP THREW EMP UP HITTTING HIS HEAD ON CANOPY

ROOF FALL-NO.4 6NIT,#12 PILLAR, APPROX. 30 FT OUTBY SPAD 4835. 20 FT WIDE, 70 FT LONG, 5 FT THICK.

EMPLOYEE HAD FI3ISHED PULLING 60 RAILS WITH SCOOP. HE WAS STANDING BEHIND SCOOP WHILE ANOTHER EMPLOYEE WAS USING A BAR TO MOVE RAILS OUT OF WAY END OF RAIL FLIPPED AROUND AND HIS HIS FOOT.

ICK.

ROOF FALL INBY SPAD 4657 NO.4 TRACK ENTRY ON (39XXXX NO.2 UNIT (013-0) 55 FT LONG, 20 FT WIDE, APPROX. 10 FT THICK.

RIDING IN TRACK JEEP WHICH RAN INTO A WRECKED MOTOR EMPLOYEE HIT HIS SHOULDER AGAINST THE JEEP.

STANDING ON TOP OF SCOOP TAKING BATTERY LID OFF TO WATER CELLS. LID SLIPPED AND CAUGHT MAN\S HAND IN THE HANDLE, BREAKING FINGER LOST TIME BEGAN 8-20-85.

PILLAR FALL -#5 PILLAR ON 4 UNIT (COVERED 4 UNIT MINER) 30FT WIDE 6FT THICK LENGTH UNKNOWN

ROOF FALL - 1ST WEST MAINS, 2 UNIT, 2 ENTRY - FACE AREA. 20\ X 20\ X APPROX. 9\

PUTTING BOLT IN RIB HOLE GLUE CONTAINER BURSTED AND GLUE SQUIRTED IN MANS EYES

ROOF FALL (INTENTIONAL)-FACE OF NO.3 ENTRY, NO.2 UNIT; 12 FT HIGH, 22 FT LONG, 20 FT WIDE.

EMPLOYEE WAS WALKING FROM MOTOR TO ROCK DUSTER MOTOR STEPPED IN A HALL USED TO DRUM BELT HEAD AND SPRAINED HIS ANKLE.

EMPLOYEE WAS PUTTING A ROOF BOLT IN HOLE, WHEN A PIECE OF ROCK FELL OFF FACE AREA AND HIT MAN S RIGHT HIP AND PELVIC AREA.

FALL OF ROOF-- 2ND NORTWEST MAINS RETURN, 40FR. OUTBY SPAD 2202, 40FT. LONG 20FT.WIDE, 6FT.THICK.

EMPL STANDING NEAR REAR OF BOLT MACHINE WATCHING ROOF FOR OPERATOR.PIECE OF ROCK FELL FROM BETWEEN BOLTS AND MASHED MANS ARM AGAINST TOP OF MACHINE.

G BOLTS IN HOLES IN HIGH TOP. OPERATOR RAISED HEAD AND CAUGHT I. NAME\S FOOT BETWEEN DRILL BOOM AND FRAME OF MACHINE.

EMPLOYEE WAS RUNNING MOTOR. MOTOR WRECKED AND THREW I NAME AGAINST BACK SUPPORT BAR.

FALL OF ROOF END OF TRACK ON #3 UNIT 40\LONG X 20\WIDE X 6-10\HIGH.4\ RESIN BOLTS BEING USED-WILL BE USING 6\BOLTS.

WHILE DRILLING ROOF BOLT HOLE EMPLOYEE CAUGHT HIS THUMB IN PINCH POINT ON OPERATORS CANOPY

EMPLOYEE WAS CHECKING POWER CURRENT ON BOLTER BREAKER, HAD TESTER TURNED TO 250 MA DC INSTEAD OF 1000 AC VOLTS WHICH IN TURN GROUNDED BREAKER AND BLEW UP ARCED IN MAN FACE.

FALL OF ROOF-NO 2 UNIT NO ENTRY 2CROSSCUTS OUTBY FACE AT INTERSECTION OF CROSSCUT APPROX. 20FT X6FT.

WHILE PULLING ON BELT EMPLOYEE STEPPED ON A PIECE OF WET BELT FELL AND IN THE PROCESS STRAINED HIS LOW BACK.

WHILE TAKING UP CENTER LINES EMP STEPPED OFF BOLTER STEPPED ON A ROCK AND TURNED HIS ANKLE

EMP WAS HELPING SET HEADERS AFTER ROOF JACK WAS SET TIGHT AGAINST HEADER EMP STEPPED OUT FROM UNDER IT TWISTED HIS BODY AND SPRAINED HIS HIP

EMPLOYEE WAS RECOVERING SUPPLIES AND WHILE DRAGGING BRATTICE, HE STEPPED ON A ROCK WHICH CAUSED HIM TO STUMBLE AND FALL ON HIS HAND.

ROOF FALL NO 1 UNIT FACE AREA ON 3 ENTRY 30X6X20

ROOF FALL NO 3 UNIT 1 ENTRY RT OFF 2ND SW MAINS 140 FT OUTBY FACE 90X20X6

EMPLOYEE WAS SWINGING DRILL HEAD ON ROOF BOLTER TO DRILL A HOLE. DRILL HEAD DROPPED AND HIT MAN\S FOOT.

ROOF FALL NO 2 SW MAINS APPROX 1000 FT OUTBY FACE 1 BREAK THRU INBY SPAD 1387 FALL OCCURRED IN NO 2 AND NO 3 ENTRIES EACH FALL APPROX 20X20X10 COVERED BELTLINE

PUTTING CONVEYOR CHAIN ON MINER FOOTSHAFT.HE PRYED SLACK WITH SLATE BAR,SPRING TENSION PULLED CHAIN BACK AND CAUGHT FINGER BETWEEN CHAIN AND MINER.

A ROOF FALL OCCURRED 1600 FT OUTBY FACE OF NO. 2 UNIT NO. 2 ENTRY, 40\ OUTBY SPAD 3504 APPROX 60FT LONG 20 FT WIDE 10 FT HIGH.

EMPLOYEE ALONG WITH ANOTHER EMPLOYEE WAS LIFTING RAILS AND IN THE PROCESS FELT PAIN IN HIS LOWER BACK.

FALL OF ROOF 3 UNIT BELT ENTRY 1 BREAKTHROUGH INBY TAILPIECE APPROX 65FTX18FTX0-4FT

EMPLOYEE WAS TRAMMING BOLTER AND STOPPED TO LOWER CANOPY HIS LEFT FOREARM WAS PINCHED BETWEEN THE TWO PIPE* S THAT HOLD THE CANOPY UP PIN WAS NOT PROPERLY ALIGNED IN THE CORRECT HOLES

EMPLOYEE WAS PUTTING BREAKER IN (BREAKER HAD WATER IN IT DUE TO RAINY WEATHER), BREAKER BLEW UP AND CAUSED MAN TO RECEIVE ELECTRICAL BURNS TO HIS LEFT ARM.

ASSISTING IN MOVING BOLTER.WHEN OPERATOR STARTED REELING UP CABLE,EMPL STRUCK BY CABLE,KNOCKED DOWN ON MINE FLOOR AND STRUCK HEAD ON ROCK.

FALL OF ROOF-#5 ENTRY 1 X-CUT INBYSURVEY STATION 301 30\LONG X 20\WIDE X 4\THICK.

ROOF FALL DISCOVERED AT 300 PM ON 7 26 83 FALL OF ROOF 2 NO WEST MAINS RETURN 1 BREAKTHRDU INBY SPAD 2152 APPROX 70X20X8

FALL OF ROOF- ONE X-CUT INBY STATION #2133 2ND NW MAINS RETURN 2 ENTRY 2\-18\ THICK 60\ LONG 20\ WIDE.

EMPLOYEE WAS AT OPEN END OF RAIL THROWING IT OVER WITH A BAR WHILE RAIL WAS BEING BENT WITH HYDRAULIC RAIL BENDER RAIL SUDDENLY SPRUNG BACK STRIKING HIM ON THE ANKLE

RIDING IN ONE SIDE OF TANDEM MOTOR.MOTOR WENT THROUGH TRAP DOOR,CAUGHT FINGER BETWEEN DOOR AND MOTOR.

A FALL OCCURRED ON NO.2 UNIT IN THE FACE OF NO.6 ENTRY BACK THROUGH THE LAST CROSSCUT--ABOUT 40" LONG, 6\ HIGH AND WIDTH OF THE ENTRY.