A-Mining Group II LLC. Metal/Non-Metal

Employee was using a grinder and cutting disc to cut a u bolt on a trailer. While cutting the bolt the disc broke striking employee in the wrist and chest area causing lacerations one to the wrist area and one to chest area.

EE was changing belts on dredge when the wrench slipped and EE cut EE's left arm on hose clamp

Employee was cutting an airline hose for truck #1221 with a knife and the knife went through and cut right thumb

EE was taking lug nuts off a truck and the wrench broke, causing ee to fall on right knee onto concrete.

EE was hooking a chain from the loader to the dredge. EE told the Loader Operator when EE was done and to go ahead and backup. When the Loader Operator backed up the Loader Operator backed up a hill which made the bucket come down and EE did not move out of the way and the bucket came down on EE's left foot.

Employee did not report incident to the supervisor until 7/13/17. Employee was servicing a truck when EE's arm brushed a portion underneath the truck knocking dirt loose. Some got into EE's right eye.

Employee was using a grinder in the shop with safety goggles on and a piece of foreign matter flew into right eye. The supervisor told employee to flush their eye out and seek medical treatment and they refused both saying they would get their spouse to do it at home.

EE and another employee were trying to get a side board off of a trailer. When the other employee was prying it from the tractor trailer it popped off and hit EE in the bottom right leg.

Employee was driving company truck unit #16 and got to Quincy Division on 440 Roberts Sand Rd., and pushed in the clutch with the left foot and the slave cylinder busted and the clutch slammed to the floor and his foot hit the floor.

Employee was cleaning a lid to a 5 gallon bucket with brake fluid and it hit the floor that had floor dry on it and it ignited.

Employee was carrying a 5 gal. bucket of hydraulic oil down a sandy hill and slipped. He tried to catch himself from falling and jerked his right neck and shoulder.

Employee was operating a front end loader and drove through a water covered hole.

Climbing up spud gantry on dredge and pulled muscle in left thigh.

ring finger on left hand was fractured when his hand was forced between 2 pieces of metal as he removed the cap on the sand processor plant.

He was using a grinder on a steel shaft and received a laceration to the top of his left hand when the grinder hit a rough spot and jumped back causing the grinding wheel to cut his hand. Four stitches were necessary.

He dropped two of three clutch plates on finger, causing laceration, as he was trying to line them up while repairing a 2001 Pioneer 4233 Horizontal Impactor (crusher)

he twisted right knee when his foot did not land flat on the ground as he was getting out of truck

Foreign object got in his right eye as he was cutting barrels causing corneal abrasion, swelling, and pain.

He fell from the ladder of the loader to the ground hitting his head.

Employee, a mechanic, strained the muscle on the left side of his back while repairing a backhoe.

Employee went to investigate malfunction of dredge and slipped on steps hurting right knee and right hand.

On 3/22/05 EE reported to his supervisor that on 3/14/05 while he was rolling a conveyor belt at the sand plant, his back started hurting. Then he lifted a tool box out of a company pickup truck hurting his back more. Again, on 3/21/04 he was pulling cables to hook up to the dredge, hurting his back more.

Working on drop axle air bag on dump truck not using jack stands at the time. Drop axle slid off of air jack.

GOING DOWN STEPS ON DREDGE TO CHECK THE ENGINE AND SLIPPED ON A 8" WATER PIPE AT THE BOTTOM OF STEPS AND HIT RIGHT KNEE ON DECK OF DREDGE.

WAW STRAIGHTENING THE RISER BLOCK ON THE LOWBOY TRAILER WITH THE WINCH CABLE ON TRAILER. THE CHAIN BROKE, HITTING EE ON THE BACK OF THE RIGHT SHOULDER AND BACK OF HEAD AND LOWER BACK ON RIGHT SIDE.

WORKING ON TRACTOR/TRAILER. STEPPED OVER BUMPER TOWARDS FRAME AND TIRE AND AS HE PULLED UP ON TIRE HIS LEFT KNEE TWISTED AND POPPED. DID NOT GO TO THE DOCTORS UNTIL 10/30/00 WHEN KNEE STARTED SWELLING.

REMOVING NUT/BOLT OFF THE PUMP ON THE DREDGE, WRENCH SLIPPED, EE HIT HIS KNUCKLES

COMING DOWN A SHORT THREE RUNG LADDER, IT CAM EAWAY FROM TRAILER AND HE FELL ON BOTH KNEES AGAINST THE RUN ON THE LADDER. HIS LEFT KNEE WAS SUPPOSEDLY AGAINST THE TRAILER. THERE WERE ALSO TW O SETS OF STEPS WITH HANDRAILS LEADING INTO THE TRAILER.

EMPLOYEE WAS INSTALLING AN OIL SEAL ON REAR TRAILER WHEEL. HE WAS DRIVING THE SEAL ON WITH A HAMMER, HE HIT ON OF THE TRAILER TIRES BEHIND HIM CAUSING THE HAMMER TO HIT THE BACK OF HIS LEFT HA ND BETWEEN THE THUMB AND INDEX FINGER.

EE WAS ATTEMPTING TO DUMP LOAD ON ONEVEN GROUND WITH TRUCK FACING DOWNHILL. TRAILER LAID OVER CAUSING DRIVER TOBE INJURED IN THE CAB

WHILE HE WAS WELDING A PIECE OF HOT METAL ENTERED HIS MASK AND GOT INTO HIS EYE.