Fall Line Quarry, LLC Metal/Non-Metal

Empolyee was performing cleanup in the plant near the secondary crusher when the crusher backed up causing material to overflow. The overflowing material struck the employee on the left side of his back above the belt line.

*Please see the attached document.* Customer truck left on property overnight was found completely burned the next morning. The truck had suffered mechanical problems.

Employee was replacing bolts in the grizzley bars. He was removing rocks and layed his hand on the side of feeder when a rock fell onto his hand, cutting his left index finger on the inside.

Employee was exiting the 66 crusher platform and stepped on a golf ball size rock and turned his rt. ankle. Employee sought medical treatment and became recordable on 03/24/2006.

Employee tripped and fell while holding a 50-60 drill bit. Injury result was lower lumbar strain.

Employee was on yard, working inside a screen and began experiencing dizziness. Employee was transported to hospital and given IV fluids.

Employee was painting guards when a piece of metal flew into his eye. Employee was wearing safety glasses. THe metal was removed, but the employee recieved a prescription.

EE WAS ATTEMPTING TO REPAIR A HOLE IN A ROCK CHUTE. WHILE CONDUCTING THIS TASK, WELDING SPARKS CONTACTED THE EE'S LEFT HAND CAUSING HIM TO DROP THE PLATE, & PULL HIS LEFT ARM DOWN. THIS CAUSED THE EE TO STRAIN HIS LEFT SHOULDER.

EE WAS USING A SLEDGE HAMMER TO ADJUST BOLTS ON THE PRIMARY JAW CRUSHER. WHILE SWINGING THE HAMMER THE EE FELT A SHARP PAIN IN HIS LOWER BACK.

EMPLOYEE WAS MOVING STOCKPILE WITH A LOADER WHEN A CONSUMER TRUCK PULLED IN BEHIND HIM. THE OPERATOR TURNED HIS HEAD SUDDENLY AND STRAINED HIS NECK.

EE WAS ATTEMPTING TO CLIMB UP ONTO THE JAW PITMAN TO PERF9RM MAINTENANCE ON THE SHAFT OF THE JAW PITMAN. IN DOING SO, WHILE THE EE WAS REACHING FOR A HAND HOLD HE ACQUIRED A SHARP PAIN IN HIS LOWER BACK.

EMPLOYEE WAS CHANGING BEARINGS-USED TORCH TO CUT RACE FROM SHAFT. HIT RACE WITH HAMMER AND METAL PARTICLE CUT KNEE REQUIRING STITCHES.

EE WAS PERFORMING PRESHIFT INSPECTION IN BLENDING TUNNEL ENTERED TUNNEL AND SLIPPED ON WET CONCRETE RAMP. THIS CAUSED A MUSCLE STRAIN IN HIS RIGHT THIGH.

EE WAS USING HAND OPERATED HYDRAULIC PUMP TO UNLOCK TELSMITH 665 CRUSHER. WOULD NOT UNLOCK. EE USED OPEN END WRENCH TO REMOVE FITTING AND FAILED TO RELEASE PRESSURE FROM CRUSHER. FITTING WAS U NDER 8-10,00 LBS. PSI AND STRUCK EE ON RIGHT CHEEK SEVERELY INJURING RIGHT EYE.

EMPLOYEE WAS HELPING CLEAR MATERIAL FROM CONE CRUSHER, ROCK CAME DOWN CHUTE FROM SCREEN STRIKING HIS RIGHT FOOT FRACTURING SMALL TOE. EMPLOYEE WAS WEARING STEEL TOE SAFETY BOOTS.

EMPLOYEE WAS REPLACING A SOCK FILTER ON LTHE TELESMITH 66 5 1/2' STANDARD CRUSHER. HE PUT HIS FINGERS THROUGH THE HOLES WHERE THE SOCK FILTERS GO & STARTED LIFTING THE HOLDER OUT. THE OTHER EM PLOYEE GRABBED THE HOLDER & PULLED. THE INJURED EMPLOYEES' FINGERS GOT CAUGHT BETWEEN THE OIL TANK & SOCK HOLDER. HAD TO BE STITCHED.

EMPLOYEE WAS HOLDING A PIECE OF METAL WHILE ANOTEHR WORKER WELDED IT. A PIECE OF SLAG FELL INTO THE EMPLOYEES GLOVE AND BURNED THE BACK OF HIS HAND.

EMPLOYEE WAS GETTING OUT OF A HAUL TRUCK & TWISTED HIS BACK.

EMPLOYEE WAS MOVING CRANE INTO QUARRY ON 10-12 DEGREE OF SLOPE HAULAGE RD. HE ATTEMPTED TO DOWNSHIFT FROM HIGH GEAR TO LOW GEAR AND DID NOT COME TO A STOP BEFORE SHIFTING. THE VEHICLE SHIFTED INTO NEUTRAL AND THE BRAKES WOULD NOT HOLD THE MACHINE DUE TO FORWARD MOMENTUM. THE EMPLOYEE JUMPED OFF THE MACHINE AND INJURED HIS FOOT.

EMPLOYEE WAS REPLACING THE MIDDLE DECK OF A TRIPLE DECK SCREEN. HE WAS CRAWLING OUT AND FELT A STOMACH MUSCLE TIGHTEN AND BEGIN TO HURT. HE STRAINED A STOMACH MUSCLE.

EMPL AGGRAVATED PREEXISTING BACK INJURY WHILE OPERATING FRONT END LOADER. HE WAS USING LOADER D\HE DID NOT NORMALLY RUN. HE RUPTURED DISC IN BACK & HAD SURGERY ON 11/1.

EMPL HOLDING CARRIAGE BOLT WITH HAND WHILE IT WAS BEING TIGHTENED.EMPL HAND SLIPPED,BOLT THREADS CUT LEFT FINGER.REQ 6 STITCHES TO CLOSE WOUND.

EMPL WAS USING UTILITY KNIFE TO CUT SOME RUBBER BRELTING. KNIFE SLIPPED & CUT LEFT THUMB. THUMB WAS STITCHED.

STEPPON CP OF PIPE ON FLOOR OF SHOP, SPRAINED HIS L ANKLE

EMPL WAS PULLING ELECTRICAL LINE TO QUARRY PUMP OUT OF WAY IN PREPARATION FOR BLAST. HE STRAINED BACK & WAS GIVEN MEDICATION.

EMPLOYEE WAS REMOVING A FAN BLADE FROM A HAULAGE TRUCK. THE WRENCH HE WAS USING TO REMOVE THE BOLT HOLDING THE BALDE SLIPPED AND THE EMPLOYEE'S HAND STRUCK THE FAN BLADE. HE CUT HIS INDEX AND SECOND FINGER ON HIS LEFT HAND. THE FINGERS WERESUTURES.

EMPLOYEE WAS HELPING CHANGE SCREENS. THE TIE DOWN BAR SLIPPED DOWN THE SCREEN AND STRUCK THE EMPLOYEE IN THE BACK OF HIS RIGHT CALF AND BRUISED IT. HE WAS GIVEN A PRESCIPTION.

EMPLOYEE WAS CLIMBING DOWN FROM A FRONT END LOADER HE CAUGHT HIS WEDDING RING ON THE STEP OF THE LOADER AND CUT HIS FINGER HE HAD 8 STITCHES APPLIED TO REPAIR THE WOUND

EMPLOYEE WAS PULLING ON A WRENCH THE WRENCH SLIPPED AND THE EMPLOYEE SUFFERED AN ABRASION TO HIS RT HAND

EMPL INJURED WHEN CABLE ON 20 TON CRANE BROKE.BLOCK ON CABLE STRUCK MAN ON RIGHT REAR SIDE.

EMPL OPERATING CRANE AND WIND BLEW DUST AND TRASH INTO HIS EYE.