FERRIS PLANT: 48 reportable incidents Metal/Non-Metal

HAUL UNIT BELLY DUM EUCLID B-70.

SLIPPED OR MISSED LAST STEP ON LOADER WHEN GETTING OFF MACHINE.

EE WAS USING A BAR TO MOVE APRON FROM SHAKER, SHAKER HIT THE APRON AND JERKED HIS RIGHT ARM AND SHOULDER.

EE WAS 1 OF 4 PEOPLE HELPING TO INSTALL A NEW HOIST CABLE ON THE 480-W DRAGLINE EE WAS ATTEMPTING TO SLIP THE END OF THE CABLE INTO A RETAINER WHEN SOMEONE LET GO OF THEIR HOLD THIS WAS A 21/4 IN CABLE EE LETE THE CABLE MASH HIS FINGER AGAIN ST THE CABLE DRUM

IT RAINED LAST NIGHT,IT WAS MUDDY AT THE PIT AREA. INJURED GOT DOWN OFF MACHINE,THEN BACKUP ON TRACKS THAT WERE MUDDY AND SLICK,HIS FOOT SLIPPED AND HE FELL ON HIS BACK.

SLIPPED DOWN ON STEPS WHILE ARM OVER HANDRAIL TRYING TO CATCH SELF, HURTING LEFT ARM AND SHOULDER.

EMPLOYEE LOST HIS FOOTING & FELL 15FT TO GROUND

PUTTING ON NEW DRAG CABLE AND PULLED MUSCLE IN BACK.

HE WAS PUTTING ON A HOIST CABLE ON DRAGLINE. HE HAD HELPER TO SWING SLEDGE HAMMER AGAINST WEDGE KNOCKER. HE MISSED KNOCKER, HIT ON SIDE OF IT CAUSING A SLIVER OF METAL TO COME OFF HITTING HIM IN THE LEFT CHEEK.

EMPLOYEE WAS USING A SHOVEL TO FILL UP HOLES ON THE HAUL ROAD. HE PULLED SOME MUSCLES IN HIS BACK.

INJURED CLIMBED ON 4600 MAINTOWAC, WHILE GETTING DOWN, HE STEPPED ON TRACKS, S LIPPED AND FELL ON LEFT ARM AND HAND. INJURED COULD MOVE HAND AND FINGERS AND DID NOT APPEAR HURT TOO BAD.

INJURED HAD ASSEMBLED HUB AND BRAKE FOR 16G GRADER, HE THEN PUT AIR PRESSURE TO IT TO CHECK IT OUT. THERE ARE SIX SPRINGS AND KEEPERS THAT FLEW APART WHEN AIR PRESSURE WAS APPLIED. THE MECHA NIC PUT TOO MUCH AIR PRESSURE TO THE PARTS.

EE CUT CHANNEL IRON FOR BRACE HE WAS ABOUT TO TRIM IT A LITTLE. HE STOOD CHANNEL IRON ON THE END PARELL OF THE PIPE TO TRIM OFF A LITTLE WHEN IT FELL ACROSS HISHAND THE CHANNEL CUT BRUISED AND BROKE ONE FINGER AND CUT FINGER.

EE WAS CLIMBING OVER SOME PIPES TO LEAVE HIS DOZER AND HELP SOME PEOPLE WITH SOME EQUIPMENT WHEN HE SLIPPED AND FELL STRIKING HIS RIGHT KNEE DIRECTLY ONTO A PIPE.

THIRD MEMBER JAMMED ON FRAME AT THIRD MEMBER HOUSING, NOT ENOUGH ROOM TO INSTALL STRAIGHT IN, HAVE TO TAKE AT ANGLE, LET HOIST DOWN A LITTLE TO GET OUT OF JAM, THIRD MEMBER ROLLED ON GEAR CAUS ING EMPLOYEE PUTTING IN TO GET CAUGHT BETWEEN FRAME AND THIRD MEMBER. EMPLOYEE HAD CUTS ON CHIN, REQUIRING STITCHES, SCRATCHED CHEST.

EMPLOYEE WAS ADJUSTING DRAG FRICTION AND BLOWER FAN BLEW FOREIGN BODY IN LEFT EYE.

FOREIGN OBJECT IN LEFT EYE.

UNKNOWN

PUMP WOULD NOT START EMPLOYEE WAS CHECKING BATTERY WHEN A WRENCH CAME IN CONTACT WITH BATTERY TERMINAL CAUSING BATTERY TO EXPLODE

UNIT OPERATOR W5S TRAVELING TO PIT AREA TO GET ANOTHER LOAD OF PIT RUN, WHEN HAUL UNIT HIT A CHUG HOLE IN HAUL ROAD SHAKING OPERATOR LOOSE FROM SEAT

EMPLOYEE WAS WE5DING ON DRAGLINE USING A LIGHT COLORED LENS CAUSING FLASH BURN TO EYES

DRIVING EUCLID 7RACTOR WHEN STEERING WHEEL SLIPPED FROM HANDS CAUSING STEERING WHEEL TO HIT RIGHT FOREARM.

EMPLOYEE WAS GR9ASING HIS EUCLID AND WHEN HE RELEASED THE RECOIL SPRING, GREASE GUN SLIPPED FROM HIS HAND HITTING EMPLOYEE IN THE MOUTH.

EMP WAS GETTING3OFF TRUCK WHEN HE FELL TO GROUND LANDING ON HIS FEET

EMPLOYEE WAS TA5ING RADIATOR CAP OFF AND HOT STEAM AND WATER CAME OUT OF RADIATOR.

HYD. HOSE TAKE 6P REEL ON BOOM WAS JAMMED. HE WAS TRYING TO TURN THE REEL, THE REEL IS SPRING LOADED AND WHILE HE WAS TRYING TO TURN THE REEL IT CAUGHT HIS THUMB

EMPLOYEE WAS CL9ANING OUT BOLT HOLES ON REDUCER.

IMPACTING BOLTS3WHEN STEEL SLIVER WAS PROJECTED INTO EYE.

HURT BACK WHILE3LIFTING BOOM SPLICE PLATE.

EMPLOYEE WAS ST9AM CLEANING RADIATOR ON DRAGLINE AND FELL FROM TRACK TO THE GROUND.

EMPLOYEE WAS HE5PING WELDER AND GOT FLASH BURNS TO EYES.

EMPLOYEE WAS CU7TING A PIECE OF METAL AND MOVED ACROSS ARM AND BURNED SELF.

EMPLOYEE WAS OP9RATING FRONT END LOADER WHEN DOOR CLOSED ON EMPLOYEE S HAND DOOR WAS NOT CLOSED PROPERTLY.

EMPLOYEE WAS RE4OVING BRAKE BLOCKS FROM BRAKE BAND,ANOTHER EMPLOYEE WAS WORKING WITH A BAR WHEN BAR SLIPPED FROM HIS HAND STRIKING HIM ABOVE LEFT EYE.

EMPLOYEE WAS CH3PPING WELDING SLAG FROM BUCKET WELD

EMP WAS USING H3S KNIFE TO CLENA GASKET MATERIAL FROM PLATE, KNIFE SLIPPED CUTTING RT LEG

EMPLOYEE WAS PU5LING ON DISCHARGE HOSE & PULLED LOWER BACK MUSCLE.

EE CHANGING DRA1 CABLE GOT FOREIGN OBJECT IN LEFT EYE.

EMPLOYEE WAS DI8MOUNTING FROM MACHINE, FOOT SLIPPED AND HE CAUGHT HANDRAIL STRAINED RIGHT SHOULDER MUSCLE

EE WS CHECKING 9NGINE OIL WHEN GETTING OFF MACHINE SLIPPED & LEG HIT TRACK.

EMPLOYEE WAS PR9PARING CRACK ON DRAGLINE BOOM IN PREPARATION FOR WELDING EMPLOYEE WAS USING A DISC GRINDER AND LOST CONTROL OF GRINDER CUTTING A TENDON IN LEFT ARM

WAS CUTTING A PIECE OF BOARD TO REPAIR WINDOW,PLACED LEFT HAND TO CLOSE TO THE CUTTING BLADE.

WALKING OUT FROM SHOP AREA AND TRIPPED OVER STEAM CLEANER HOSE CAUSING INJURY TO KNEE.

HOLDING PIPE WITH WRENCH HELPER WAS STRIKING PIPE WITH SLEDGE HAMMER - BREAKING LOOSE A JAM NUT - WHEN STRUCK PIPE - SLIPPED STRIKING HAND

EMPLOYEE WAS IN BACK OF COMPANY PICKUP GETTING A TOOL OUT OF TOOLBOX & EMPLOYEE STEPPED ONE FOOT OUT ON BUMPER & BRACED HAND ON TAILGATE, WHICH WAS NOT LOCKED IN POSITION & EMPLOYEE FELL TO GR OUND.

STUCK A PIECE OF DRAG CABLE IN LEFT FOOT

EMPLOYEE WAS LEAVING JOBSITE-STEPPED OFF CONCRETE SLAB IN SHOP AREA-TURNED ANKLE.