Hayden Quarry Metal/Non-Metal

While placing screen deck in position it slipped & pinched employee's ankle.

Employee was helping co-worker after a screen deck pinched coworker's ankle and EE slipped falling on knee.

A loader operator was closing the door on Volvo Front End Loader. When ee shut the door, ee pinched the tip of right middle finger between the loader door and the door frame. This resulted in a laceration that required sutures.

While dumping a load of rock in the primary crusher, a rock fell over the side of the haul truck dump bed in front of the left rear tire. The employee attempted to manually slide the rock out of the way when he stated his right elbow popped. Employee reported the incident immediately on 6/9/14, but did not want medical treatment until 6/12/14.

Employee walking out of break room rolled ankle, fell, and bruised right shoulder and elbow. Restricted duty.

Employee changing oil in Volvo A25C haul truck. Belly pan got wedged by a jack. Employee attempted to manually lift the belly pan and felt a sharp pain and burning sensation in lower right side. Incident occurred on 5/15/13, first treatment on 6/5/13.

Employee was connecting a water line for the dust suppression system to the water truck. A gust of wind blew dust into the employee's left eye resulting in a scratch. Employee was wearing prescription safety glasses with side shields. Prescription eye drops were issued.

Employee was preparing to clean an area of ground near a screen. While standing approximately 10 feet away and to the side of the screen and chute, a rock struck the employee's hard hat resulting in a neck strain and chipped teeth.

The injured miner bent down to pick up a belt splicing tool (approx.30lbs) and states he felt something pop in his left hip. The diagnosis was a strain to the left hip.

employee was lifting a battery cover on a front end loader, the cover slipped out if his right hand and fell on his left thumb

Employee was preparing to repair a belt splice. The conveyor belt was in a bind so to relieve the tension on the belt, he and a co-worker used utility knives to cut the "Dirthog" belt scraper. The utility knife slipped and cut employee's hand between his left index finger and thumb.

EE USING HAND GRINDER, DEBRIS FLEW INTO RIGHT EYE.

EMPLOYEE WAS LIFTING A PIECE OF METAL AND STRAINED HIS LOWER BACK.

EE WAS HELPING TO PUT A BEARRING ON SHAFT (6X20 SCREEN). EE WAS HOLDING A BLOCK OF WOOD AND EE WAS SWINGING A SLEDGE HAMMER AND MISSED THE BLOCK OF WOOD AND STRIKING EE IN LEFT HAND.

29625N INDEX FINGER ON LEFT HAND.HIT FINGER WITH CLAW HAMMER WHILE OPENING FLOP GATES ON SCALPER SCREEN.

CUTTING METAL AND RUST & STEEL FLEW IN HIS EYES. HE WAS WEARING SAFETY GLASSES-DOCTOR WASHED EYE OUT-GOT OUT FOREIGN OBJECTS.

TRIED TO LIFT A FRAME OUT OF A SCREEN PLANT AND PULLED MUSCLE IN UPPER BACK.

REBUILDING A GAS TANK WENT TO FLIP IT OVER AND LAID FINGERS ON WELD-EXTREMELY HOT.BURNT 2ND AND 3RD FINGERS ON LEFT HAND.

PULLED LEVER ON OVERHEAD BIN AND IT WAS STUCK AND WHEN IT CAME LOOSE IT CAME ALL AT ONCE PUTTING HIS LOWER BACK IN A TWIST.

BURN ON LEFT RING FINGER SLAG FROM WELDER FELL ON WEDDING BAND CAUSING IT TO STICK REPAIRING CHUTE ON CONVEYOR

EMPLOYEE TRIED TO PICK UP A LARE ROCK & THROW IT OFF OF A CONVEYOR BELT WHEN HIS FINGER WAS SMASHED BETWEEN ROCK & CONVEYOR HOPPER

REMOVING BRAKES FROM DUMP TRUCK. BRAKE SHOE SLIPPED - CAUGHT HAND ON BACKING PLATE. REQUIRED 3 STITCHES ON PALM OF LEFT HAND.

I,NAME WAS TAKING SHORT CUT THROUGH FEEDER HOOPER TO GET BACK TO CONTROL HOUSE WHEN HE SLIPPED AND FELL INTO JAW CRUSHER-FEEDER WAS SHUT OFF BUT THE JAW WAS RUNNING SO NO MATERIAL WAS BEING FE ED AT THE TIME. HE MANAGE TO CLIMB OUT WITH, HE HELP. NO SERIOUS INJURIES WAS FOUND BUT HE WAS TAKEN TO HOSPITAL AND RETURNED TO WORK THE FOLLOWING DAY.

SWINGING SLEDGE HAMMER TIGHTING BOLTS ON 3FT SYMONS CRUSHER HURT VERTEBRATE OUT OF PLACE IN BACK EMPLOYEE GOT HURT ON 1-19-90 CAME BACK TO WORK 1-22 THRU 1-25-90 THINKING HIS BACK WOULD QUIT H URTING PAIN CONTINUED DOC TOLD HIM TO STAY OFF WORK UNTIL 2-5-90

I,NAME WAS GOING TO GET HIS LUNCH WHEN HE TRIPPED OVER A ROCK. HE FELL AND HIT HIS FINGER ON A ROCK.

ROCK FELL OFF SIDE OF LOADER BUCKET HIST TIRE & THEN HIT EMPL ON LEFT ARM.

LATCH ON TAIL GATE JAMMED. GOT HIS FINGER CAUGHT BETWEEN CYLINDER ROD AND TAIL GATE ARM

WAS CUTTING OLD3ROLLERS OFF & TRYING TO REMOVE THEM WHEN THE ROLLER SLIPPED & FELL ON HAND

A WRENCH FELL. 4ENT DOWN CONVEYOR BELT TO GET WRENCH. SLIPPED ON CONVEYOR BELT LEFT FOOT. PULLED LIGIMENTS.

LAYING DRILL STEEL DOWN.SLIPPED IN MUD STEEL ROLLED OVER ON FINGER.

EMPLOYEE WAS SHOVELING STONE FROM UNDER CONE CRUSHER.

THE ROCK WAS LAYING ON SIDE OF CONVEYOR HALF WAY UP AS HE REACHED UP TO GET ROCK IT WENT ON BELT AND CAUGHT FINGER ON ANGLE IRON THAT GOES ACROSS CONVEYOR