Perry Quarry Metal/Non-Metal

EE was transferring drill bits from the truck bed to the drill deck. EE isn't sure how it happened, but the drill bit ended up smashing EE's left thumb between the drill bit and the drill deck.

Employee was dislodging cheek plates from a crusher. A porta power was requested to assist. The employee placed the porta power on a ledge for preparation. The porta power fell off the ledge approximately 16" striking the employee in the right arm.

Employee was carrying a 3-ton jack from the maintenance truck to a conveyor. Employee states that he stepped in a hole and twisted his right knee. On 8/28/2015 he was seen by an orthopedic doctor who recommended surgery. Surgery occurred on 9/24/2015.

Worker was changing the bit on the drill. He cut his thumb on a barb on the surface of the bit.

An employee and a contractor were welding inside a crusher. After the shift, the employee noticed that his eyes were stinging. His eyes were flash burned by the exposure to the other welder' s arc.

Employee was helping unroll spool of wire rope for the dragline. As they neared the end of the rope, it slipped out of the attaching staple, and struck the employee in the mouth.

After a repair on the dragline, the employee complained of pain in his shoulder. He was examined by a doctor, and diagnosed with a strain. He was allowed to return to normal work duties. On May 23, 2007, he complained of more pain, and returned to the doctor. At that time he was excused from work pending further medical tests.

WHILE GAINING ACCESS TO MACHINE, EE WAS ON STAIRS PULLING HIMSELF UP BY HANDRAILS. HIS FEET CAME OUT FROM UNDER HIM DUE TO OIL COVERED WITH DIRT ON TRACKPADS. BODY WEIGHT WAS HELD UP BY ARMS. HE FELT A PAIN FROM HIS RIGHT SHOULDER. THIS CASE WAS TREATED AS A FIRST AID CASE UNTIL 1/13/05. AT THAT TIME AN MRI SHOWED A TORN ROTATOR CUP. PHYSICIANS ARE RECOMMENDING SURGERY.

EE WAS STANDING ON 2" WATER LINE. PRESSURE BUILT UP CAUSING THE HOSE CLAMP COUPLING TO COME LOOSE. THE CLAMP FLEW OFF AND STRUCK THE EE ON THE LEFT ARM.

EE WAS STEAM CLEANING DRAGLINE MACHINE./ HE DROPPED THE WAND, AND IT STRUCK HIS FOOT WITH THE STEAM STILL ON. HIS FOOT WAS BURNED.

EE WAS ON CATWALK OF CONVEYOR WORKING. BOLTS SHEARED IN THE MIDDLE OF CONVEYOR, DROPPING IT AND THE EE APPROX 6 TO 8 FT TO THE GROUND.

EMPLOYEE WAS WORKING ON CRUSHER, SLIPPED AND FELL. HE TRIED TO CATCH HIMSELF WITH ONE HAND AND PULLED SHOULDER.

DRAGLINE ROCKED AND HE FELL DOWN.

EMKPLOYEE WAS CARRYING A ROLLER UP THE STAIRS TO TOP OF PLANT. HE GO TO THE TOP AND MADE A 90 DEGREE TURN, AND FELT HIS BACK HURT.

EE WAS HOOKING THE WATER WAGON TO LOADER. HIS HAND GOT CAUGHT IN BETWEEN THE LOADER & THE HITCH.

LIFTING RAILROAD TIES & TORE RIGHT GROIN MUSCLE.

EE WENT TO PULL A PIECE OF METAL OFF OF CONVEYOR BELT AND CUT HIS FINGER.

WELDING SLAG IN EYE. DONT KNOW WHEN IT HAPPENED OR WHAT HE WAS DOING.

EMPLOYEE WAS REPLACING BELT ON PULLEY. MOTOR WAS STILL GOING AND PULLEY CAUGHT HIS FINGERS.

54736YEE WAS SHOVELING UNDER THE BARGE AND HIT HIS BACK ON THE BEAM UNDER THE BARGE.

EMPLOYEE WAS TIGHTENING BOLTS ON ROCK BOX. THE WRENCH SLIPPED OFF THE BOLT AND EMPLOYEE HIT THE SIDE OF THE ROCK BOX WITH HIS ELBOW.

UNLOADING BLOCKS FROM LOWBOY STEPPED THROUGH CENTER OF TRAILER AND FELL ON L SIDE BRUSHING L SIDE AND BACK

EMPLOYEE WAS CUTTING A PIECE OF METAL WITH ACETYLENE TORCH. THE HOSE BLEW OFF THE TORCH, AND SPARKS IGNITED THE HOSE CAUSING THE EMPLOYEE TO GET BURNED.

INSTALLING FRICTION BANDS ON DRAGLINE PLACE DHAND ON BAND OTHER EMP HIT BAND WITH HAMMER

EMPLOYEE STARTED FUEL PUMP ON FUEL WAGON, PLUG ON TOP OF PUMP BLEW OUT, SPRAYING DIESEL FUEL IN HIS FACE AND EYES.

EMPLOYEE WAS TIGHTENING JAW BOLTS ON JAW CRUSHER HE HAD TO PUT PRESSURE ON LEFT ARM IN ORDER TO WELD ARM WENT TO SLEEP & IS STILL NUMB EMPLOYEE DID NOT GO TO THE DOC UNTIL THE 21ST HE WAS WAIT ING TO SEE IF THE NUMBNESS WOULD GO AWAY

A ROLL OF 30" CONVEYOR BELTING (APPROX. 3,000 LBS) WITH A ROD THROUGH THE HUB WAS RESTING ON THE CONVEYOR FRAME. EMPLOYEE WAS REPOSTIONING THE ROD, WHEN THE ROLL SLIPPED FROM THE FRAME, PINNIN G EMPLOYEE'S LEFT FOOT BETWEEN THE ROD AND THE FAME OF CONVEYOR.

EMPLOYEE WAS GETTING OFF THE 988B LOADER AND HE LOST HIS FOOTING, AND FELL BACKWARD ON HIS BACK.

EMPLOYEE WAS GETTING INTO HIS EUCLID TRUCK. HIS FOOT SLIPPED AND HE STRAINED A BACK MUSCLE, AS HE REGAINED HIS FOOTING.

EMPL WASHING OUT UNDER NORTH SCREEN,ROCK CAME OFF BELT AND HIT HIM IN RIGHT SIDE OF FACE.

EMPLOYEE WAS CLEANING UNDER THE BARGE. A ROCK FELL APPROX. 20 FT, STRIKING HIM ON THE BACK OF THE RIGHT SHOULDER.

EMPL WAS HELPING TO CHANGE A SCREEN MOTOR AT THE TOP OF THE PLANT AND WAS BITTEN BY A SPIDER

EMPLOYEE WAS PICKING ROOTS OFF OF #7 BELT AND A ROCK JUMPED OFF OF THE SCREEN AND HIT HIM IN THE HAND.

EMPLOYEE WAS HOLDING A WIRE BACK, FOR ANOTHER EMPLOYEE TO DO SOME DRILLING. THE DRILL CAUGHT THE WIRE AND PULLED THE EMPLOYEES HAND UP IN THE DRIL.

EMPL WAS REPAIRTING A HOSE ON THE 489 CRUSHER HE HAD REPAIRED THE HOSE AND WAS GETTING DOWN WHEN HIS FOOT SLIPPED AND HE FEL 2 OR 3 FEET

EMPL WAS RELING CHUTE TO #57 BIN, WHILE HOLDING PIECE OF METAL TO BE WELDED.

EMPLOYEE WAS WELDING WITH WIRE. IT SPLATTERED AND FLUX GOT IN HIS EYE.

EMPL WAS CLEANING OUT UNDER BARGE & TWISTED HIS FOOT.

EMP. WAS GETTING OFF OF THE CAB OF THE DRAGLINE. HE SLIPPED OFF THE TRACK AND FELL ON HOS LEFT LEG.

EMPLOYEE WAS WORKING ON CRUSHER. HE WAS PULLING ON A WRENCH AND STRAINED HIS BACK.