THE VICTIM WAS OPERATING AN AERIAL BOOM TRUCK INSIDE THE BUCKET TO DISMANTLE A SHOP BUILDING. THE VICTIM & TWO OTHER EMPLOYEES WERE USING THE BOOM OF THE BUCKET TRUCK TO LIFT UP WOODEN 4X6 POST. THE POST WAS BURIED IN THE GROUND WITH CONCRETE. WHILE LIFTING THE POST, THE VICTIM WAS THROWN OUT OF THE BUCKET WHEN THE POST SUDDENLY RELEASED FROM THE GROUND.
THE VICTIM WAS OPERATING A BOOM TRUCK, ASSISTING IN THE TAKING DOWN OF A LINE DROP TOWER FROM AN ELECTIRCAL SUBSTATION. THE WINCH ROPE BROKE CAUSING HIM TO BE THROWN FROM THE BUCKET OF THE BOO M TRUCK. HE FELL APPROXIMATELY 25 FEET. (THIS WAS NOT AN ELECTRICAL ACCIDENT. THE SUBSTATION WAS NOT IN SERVICE.)
THE ELECTRICIAN WAS WORKING ON A GROUNDED SHUTTLE CAR CABLE AND RECEIVED FLASH BURNS WHEN A SHORT CIRCUIT OCCURED AT THE FEMALE RECEPLACLE ON THE ELECTRICAL POWER CENTER.
Employee was attempting to square up a piece of bolt with a utility knife and knife slipped cutting his left hand between the thumb and index finger. EE received 7 sutures.
THE EE WAS OPERATING HIS SHUTTLE CAR THROUGH THE CROSS-CUT BETWEEN #3 & #4 ENTRY. HE RAN INTO A CHUG-HOLE & SAID THAT HE BEGAN HAVING PAIN IN HIS LOWER BACK AND RT. LEG.
EE WAS REPAIRING THE BOOM ON THE ROOF BOLTER. HEWAS USING A LIFTING JACK TO PUT THE BOOM IN PLACE THE JACK BAR BROKE, STRIKING HIM OVER THE LEFTEYE. (STITCHES)
THE EE WAS OPERATING HIS SHUTTLE CAR TOWARD THE BELT FEEDER WHEN HE CAME INTO CONTACT WITH THE SCOOP THAT WAS CLEANING THE FEEDER. HE COMPLAINED OF BACK & NECK PAIN. THE ACCIDENT OCCURED ON 9/4/03 HOWEVER HE DIDN'T LOSE ANY TIME OR GO TO THE DR UNTIL 9/10/03
THE EE SAID THAT HE SLIPPED AND FELL, STRIKING A ROCK WITH HIS KNEE.
EMPLOYEE WAS PULLING A 2/0 MINER CABLE WHEN HE FELT PAIN IN HIS BACK.
THE SECTION WAS ON RETREAT MINING. THE ROOF FALL OCCURRED SHORTLY AFTER THE FINAL PUSH OUT WAS MADE IN THE #3 PILLAR. CATCHING THE BOOM OF THE MINER WHILE IT WAS BEING BACKED OUT FROM THE PILL AR. THE FALL WAS APPROX. 42"" X 10' X 20'.L
THE EE WAS ATTEMPTING TO MOVE THE CONTINUOUS MINER CABLE OUT OF THE ROADWAY TO HANG IT. HE SAID HE HURT HIS BACK WHEN HE PULLED ON THE CABLE.
EMPLOYEE WAS REPLACING BELT ROLLERS ON #2 BELT, WHEN HE BEGAN HAVING BACK PAIN. THIS WASN'T REPORTABLE ACCIDENT FROM THE BEGINNING. HOWEVER AS OF 1-2-03 THE EE WAS UNABLE TO PERFORM HIS REGULA R JOB DUTIES AND IS NOW BEING EVALUATED.
ON 12-17-02 THE MINE EXAMINER WAS CONCLUDING HIS WEEKLY VENTILATION CHECKS. HE ENCOUNTERED THE ROOF FALL. IN THE #3 BLEEDER AREA. #3 MAINS. IN #2 ENTRY 1 +CUT INBY SPAD #2687. THE FALL WAS APP ROX 70' LONG X 18' WIDE X 4' THICK.
EE WAS CHANGING A TRACTION MOTORE ON A SHUTTLE CAR. THE MOTORE WAS BLOCKED UP WITH A 4"" X 6"" CRIB BLOCK. HIS HAND WAS LYING ON HTE CRIB BLOCK WHEN A PIECE OF DRAW ROCK (10"" X 12"" X 1"") FELL FR OM THE ROOF STRIKING HIS RIGHT HAND. (3 FINGERS.MIDDLE FING CUT, FRACTURED REQUIRED PINS & STITCHES).
EE WAS MOVING THE CONTINUOUS MINER CABLE OUT OF THE ROADWAY. WHEN A SHUTTLE CAR CAME OUT OF HEADING. THE CAR CABLE CAUGHT HIS LEFT LEG., PULLING HIM INTO THE COAL RIB.
THE EMPLOYEE WAS ASSISTING A FELLOW WORKER HANG THE CONTINUOUS MINER CABLE. HE LATER BEGAN TO EXPERIENCE BACK PAIN.
A ROCKFALL WAS FOUND ON THE DATE AND TIME STATED IN ITEMS 6 & 7 ON THE #2 MAIN, IN THE #4 BELT ENTRY TWO XCUTS OUTBY SPAD #2565. THE ROCKFAL WAS APPROXIMATELY 70' LONG, 18' WIDE AND 3' THICK. THE ONLY EQUIPMENT INVOLVED WAS THE #2 MAIN LINE BELT.
EE PICKED UP A 5 GALLON CAN OF ANTI FREESE AND FELT A PAIN IN THE BACK. INCIDENT OCCURRED IN JAN BUT EE CONTINUED TO WORK UNTIL 5-8-02.
EE WAS BOLTING TOP DRILL STEEL GOT HUNG UP. HE WAS GETTING IT LOOSE WHEN A PIECE HIT HIS LEFT HAND WHILE HE HAD HIS HAND ON HEAD OF MACHINE.
DURING PILLAR RECOVERY IN THE FINAL PUSH A ROCK FELL CATCHING THE MINER (1410-A)
DROPPED PIECE OF BELT STRUCTURE AGAINST SCOOP BUCKET, CATCHING HIS RING FINGER OF RIGHT HAND.
CREW WAS CHANGING SPLASH GUARD ON BELT HEAD. GUARD SLIPPED & HIT EMPLOYEE JUST ABOVE RIGHT KNEE CAUSING BRUISE & ABRASION.
EE WAS TAKING WOODEN PALLET OFF OF FLAT CAR, HITHIS RIGHT LEG JUST ABOVE ANKLE.
EE WAS WALKING AROUND BOLT MACHINE. HE STEPPED ON PIECE OF COAL AND TWISTED RIGHT KNEE.
REPEATED MOTION FROM OPERATING ROOF BOLTER.
EMPLOYEE GOT A SMALL FINGER CAUGHT ON BOOM OF BOLT MACHINE, REQUIRED 3 STITCHES.
A ROCKFALL WAS FOUND BY THE EXAMINER ON THE DATE AND TIME STATED IN ITEM 6 & 7. THE FALLS LOCATION WAS 2 BRKS. INBY SPAD #2543 ON THE #2 NAIN IN THE #6 ENTRY. THE SIZE OF THE FALL WAS 60' LONG , 20' WIDE, AND 3' THICK.
EE'S KNEE PAIN WORSEN ON THE DATE STATED IN ITEM 6. EE STARTED TAKING OFF ON 8-16-00.
EE WAS PLACING A GEAR ONTO A ROLLER WHEN IT FELL, HITTING EE ON THE RIGHT HAND. THIS INJURY REQUIRED STITCHES.
EE'S KNEE PAIN WORSEN ON THE DATE AND TIME STATED IN ITEM 6 & 7. SAID HE MUST HAVE TWISTED HIS KNEE.
A ROCK FALL WAS FOUND IN THE BLEEDER ONE BREAK FROM SPAD 3338 ON LEFT PANEL OFF THE #4 SUBMAIN. THE FALL WAS FOUND DURING THE WEEKLY EXAMINATION OF THE BLEEDER ON THE DATE STATED IN I TEM 6.
A ROCK FALL WAS FOUND ON THE DATE AND TIME STATED IN ITEM 6 AND 7 ON THE FIRST RIGHT SUBMAIN, IN THE NUMBER 6 ENTRY. THE FALL WAS 50 FT LONG, 16 FT WIDE AND 5 FEET THICK.
A ROCK FALL WAS FOUND ON THE DATE AND TIME STATED IN ITEM 6 AND 7. THE FALL WAS 30' X 30' X 4' IN THE #1 PANEL 30 BRKS FROM THE PORTAL IN THE NO. 4 ENTRY.