Pit supervisor was pushing dirt, when backing up the operator lost track of where operator was at and backed over a berm causing the Caterpillar D6H Dozer to roll backwards 270 degrees landing vertical on it's blade. The operator was able to exit the machine without any injuries. The dozer caught on fire, the fire department was call and the fire was extinguished.
In work boat tied off to the dredge, pulling on 3/4"" ratchet wrench to tighten 7/8"" diameter bolt. On 9/30/15 went to clinic because of low back pain.
Miner walked down the walkway ramp to the boat dock and stepped from ramp to dock (an 8"" tall riser ht.)Felt back pain. Did not slip or fall . We took him to E.R. Diagnosis was muscle spasms or sprain. Adm. and injection, 2 Rx's , told to stay home today and apply ice. Can repot to work on 7/21/11 if feeling ok.
Removed 1 section of dredge pipe (mounted on a pontoon) and pushed it to the bank of the lake with motorized work boat. The pipe ran into the bank causing pipe to slip over edge of work boat and pin miner's left leg between the pipe and bench seat of the work boat.
UNLOADING JUNK IRON AND A PIECE FELL ON EE'S FOOT. NO BROKEN BONES, BUT FOOT WAS BRUISED. PHYSICIAN INSTRUCTED EE TO STAY OFF FOOT 2 DAYS THEN REPORT BACK TO WORK.
Affected miner & two other miners were lifting a cable block from the rear of a mobile crane. Before the block was completely lowered to the ground, the other two miners let go of the block, which caused the affected miner to feel a jolt. After feeling discomfort for 1 week, the affected miner went to a chiropractor and received one treatment on 10-28-05.
EE WAS HELPING REMOVE A COLLECTOR CHUTE FROM THE SCREENING PLANT AND WHILE IT WAS BEING LOWERED IT SWANG AND STRUCK THE EE ON THE RIGHT SIDE OF HIS HEAD. LACERATION REQUIRED 7 SUTURES.