Employee was helping remove a panel from a screen when the screen panel jerked their arm down and over extending upper arm causing pain in shoulder. The incident occurred on 6/11/2025 but the employee's shoulder became worse over time and they had to receive surgery on 6/23/2025.
TRIANGLE QUARRYMetal/Nonmetal
- Fatalities
- 0
- Total incidents
- 24
- Years on record
- 2000–2025
- Latest incident
- Jun 2025
Reportable incidents
24 on file2025 · 1 incident
2019 · 1 incident
The mechanic was removing the driver side platform from a haul truck. The platform was secured to the shop overhead crane. When the last bolt was removed the platform rotated and the edge of the platform cut the top of the mechanic's head.
2018 · 1 incident
While lifting a worn screen panel the employee strained the lower right side of back.
2017 · 2 incidents
After completing work with an excavator, the employee was dismounting the parked machine. As employee stepped from the step to the ground employee felt a pain in right shoulder with which employee was holding the hand rail. The employee did not see a doctor until 02/18. Employee submitted to an MRI and results were read on 02/19/18. Employee has surgery planned for 02/22/2018.
The Pit Foreman, was discovered in the restroom unresponsive and without a pulse.
2014 · 2 incidents
Employee cutting wire mesh with shears when shears slipped and employee cut his finger on exposed wire mesh.
When turned on, the air bubble in the washdown hose caused the hose to twist in the hand of the employee and the nozzle attachment band cut the employee's right hand at the base of his thumb.
2013 · 1 incident
Employee was tightening the main shaft nut when the tightening device bounced off of the knocker wrench and his right hand ring and little finger were pinched against the main shaft nut, requiring stitches to both, and a break on the tip of the little finger.
2010 · 3 incidents
Welder cutting drill steel was struck on the top of his foot when the cut piece of drill steel fell on his foot.
Employee was clearing a rock slab from a chute when the slab rolled over and pinched his right hand against the side of the chute, injuring his right middle and ring fingers.
While changing screen cloth injured employee's left hand was struck by a hammer being used by another employee.
2006 · 1 incident
Supervisor was cutting a plastic tie-down which was securing an electrical shutoff line to a pit pump hose when the knife cut through the tie-down and punctured the left forearm of the employee. 3 sutures were required to close the wound.
2004 · 4 incidents
Employee stepped down from the ladder of the water truck and turned his ankle, resulting in a severe sprain of the right ankle.
Employee has involved in a physical altercation with another employee who pushed the injured employee against a wall and wrestled him to the ground injurying his left shoulder and right knee (muscle strain and bone bruise).
Employee was climbing into the cab of a Hitachi shovel when his left foot slipped and his left hand gave way, causing his entire weight to pull against his right shoulder.
While preparing a cutting torch to cut bolts on a gravity take-up pulley in the plant, the employee attempted to clear a clog from the tip of the torch with his gloved hand. The torch ignited while the tip was still in contact with his hand, causing 2nd degree burns to his left hand at the base of his middle finger.
2003 · 2 incidents
WHILE EE WAS UNLOADING A TRACTED MANLIFT FROMHIS TRACTOR/TRAILER LOWBOY TO THE GROUND, THE SUDDEN SHIFT INT HE CENTER OF GRAVITY OF THE TRACTED MANLIFT CAUSED HIM TO FALL FROM THE MANLIFT CONT ROL BASKET TO THE GROUND. THE EE SUFFERED LACERATIONS TO HIS ARMS AND THE BACK OF HIS HEAD REQUIRING STITCHES AND A FRACTURE TO HIS LOWER BACK L-6 AREA REQUIRING THE USE OF A BACK BRACE AND B
WHILE USING A PRY BAR TO REPOSITION EX1100 SHOVEL TRACKS FOR LOADING, THE TRACK SHIFTED AND PULLED THE PRY BAR FROM THE EMPLOYEE'S HAND AND STRUCK HIS LEG ABOVE THE RIGHT KNEE. THE SUDDEN MOVE MENT CAUSED A MUSCLE STRAIN TO HIS LOWER BACK.
2001 · 4 incidents
AN ENCLOSED CAB DRILLER STEPPED OUT OF HIS CAB TO THE ADJUSTING WORK PLATFORM TO LOOSEN THE PIPE JOINT ON HIS DRILL STEEL. WHEN HE STEPPED BACK TOWARD THE CAB CONTROLS HE STEPPED IN THE OPENIN G BETWEEN THE CAB AND THE WORK PLATFORM. HE BRUISED HIS RIGHT WRIST AFTER SLIPPED DOWN.
EMPLOYEE WAS STANDING IN FRONT OF 2 FT HIGH CONCRETE BLOCKS. WHEN HE TURNED TO WLAK AWAY FROM JOB, HE TRIPPED OVER THE CONCRETE BLOCK, FALLING ON HIS RIGHT ARM. HE BROKE HIS ARM ABOVE THE ELBO W, BUT RETURNED TO WORK WITH RESTRICTED DUTY.
EMPLOYEE STRAINED HIS BACK WHILE USING A CHAINSAW AND LIFTING LOGS. THE IRRITATION OF THE BACK INJURY WAS REPORTED THE FOLLOWING DAY. THE EMPLOYEE WAS PLACED ON RESTRICTED DUTY ON 3-20-01. HE WAS NOT CERTAIN HOW OR WHEN HE HURT HIMSELF.
A ROCK FALLING FROM THE SHOVEL BUCKET STRUCK THE BED OF THE HAUL TRUCK IN SHICH THE EE WAS SITTING WHILE BEING LOADED. THE MOVEMENT OF THE TRUCK CAUSED THE EE TO STRAIN MUSCLES IN HIS NECK.
2000 · 2 incidents
WHILE USING A PRY BAR TO LINE UP A PIECE OF SCREEN CLOTH, THE EE PULLED ON THE BAR AND THE BAR SLIPPED STRIKING EE ON THE FOREHEAD WITH THE ENDOF THE BAR. 5 STITCHES WERE REQUIRED TO CLOSE TH E LACERATION
EE LOST HIS FOOTING STEPPING DOWN FROM REAR LOADING DOOR OF A FREIGHT TRUCK. HE FELL TO THE GROUND LANDING ON HIS LEFT ELBOW AND CAUSING A CONTUSION TO HIS LEFT SHOULDER. RESTRICTED LIFTING WI TH HIS LEFT ARM.