PLANT #2 PORTABLE CRUSHERMetal/Nonmetal

Employee was welding a nut to a bolt and did not wear welding helmet for about 2 minutes. Employee experienced welder's flash to both eyes and eye pain/burning occurred about 12 hours later.

Employee was placing metal screens onto a screener box. While placing the 3rd screen of 4, EE caught EE's left thumb between the screen and the screener wall. This resulted in a broken left thumb.

Miner was walking down the stairs of a tool trailer carrying tools. The first step of the stairs had been repaired with grating but when the miner stepped on the step the repair came loose causing the miner to lose footing. The miner dropped what EE was carrying and grabbed the railing with right hand. As EE caught self on the railing, EE's weight twisted right wrist.

Employee was heating up bolts with an acetaline torch. Employee had the torch in their left hand and crossed their right arm over the flame burning their right forearm from elbow to wrist.

Employee sliced right thumb while doing repairs. Employee is still working.

Employee notified management on 2/21/13 that he had went to doctor on 1/25/13. Diagnosis was possible carpal tunnel in both hands. No treatment plan as of 2/21/13. No lost time as of 2/21/13. Will update 7000-1 as needed.

Swinging a sledge hammer to repair cone crusher, strained right shoulder outside of shop.

carrying & moving a toggle block for crushing plant. Lifting & then twisted to set it down, injuring low back.

TRYING TO GET A RAM ON CRUSHING PLANT, CHAIN SLIPPED & PULLED EMPLOYEE'S ARM, STRAINING ARM.

EE WAS WORKING OFF THE LADDER 8-10 FT IN THE AIRHE WAS FIXING A CLEANING THE BELT OFF THE SCREENER PLANT, WHERE THE PRIMARY CRUSHING CONVEYOR FEEDS THE SCREENER CONVEYOR. THE LADDER KICKED OUT CAUSING DENNIS TO FALL 8-10 FT.

LOW BACK PAIN IN THE AFTERNOON, COULD BARELY STAND UP STRAIGHT. HAPPENED AFTER PERFORMING NORMAL DUTIES.

PULLING ON A PRY BAR TO TIGHTEN UP A JACK ON THE PRIMARY BREAKER & FELT A POP IN ABDOMENAL AREA.