AA Limestone Metal/Non-Metal

Employee was working on repair of a loader when EE fell off, hitting the ground and breaking the wrist.

Employee was operating a CAT 740B Haul Truck and hit a rut in the road, causing back pain. The injury was not reported to management until 9/9/19.

Employee was walking across a parking lot towards his haul truck when he slipped on a patch of ice and fell, resulting in sprains to his left knee and shoulder and abrasion to his left knee. Employee was placed on three days restricted duty, operator accommodated restrictions - no lost workdays were incurred as a result of this injury.

Injured employee was kneeling in area between the cab and engine compartment on a Cat 988B Loader while performing maintenance to the loader. When employee stood up he heard a snapping noise in his left knee and felt that his left knee had popped out of socket. Initial medical review of this injury resulted in restricted duty with no lost time.

Employee was on scales. He got out of his truck and stepped on the guardrail they have for them to step on to get his load ticket. He turned to get back in his truck when his foot slipped on guardrail and he fell hitting his left side on guardrail and fracturing a rib.

Employee was using 12 volt tester. The tester slipped off temp switch and came in contact with fan blade. The fan blade struck tester and drove blunt end into palm of right hand requiring 16 stitches.

Employee was operating a 2003 model 226 cat skid steer cleaning out between beltlines. He backed skidsteer upon existing stockpile with bucket raised cousin skid steer for overturn. He substained scretches and lacerations requires medical attention.

wHILE PECKING ON A AXLE GEAR WITH HAMMER A SLIVER CAME OFF AND STRUCK MACHINC IN UPPER LIP EMBEDDING INSELF IN LIP.

EMPLOYEES BACK WAS HURTING WHEN HE GOT UP THE NEXT MORNING AFTER WORKING NIGHT BEFORE. EMPLOYEE DID NOTHING OUT OF ORDINARY ON HIS NORMAL SHIFT.

LOADED DOZER TRACKS ON FLATBED TRACK FOR TRANSPORT. TRACKS WERE IN SPIRAL ROLLS, ONE END OF ROLL OPENED. EE WENT TO PULL OPEN END BACK TO ROLL, LOADER MOVED TRACK TO ADJUST HOLD. EE PINCHED TH UMB CAUSING LACERATION.

EE WAS ASSISTING IN INSTALLING A RETURN ROLLER GUARD. WHILE HE WAS HOLDING THE GUARD IN PLACE, HIS FOOTING SLIPPED. RESULTED IN A STRAINED BACK. HAD RESTRICTED WORK DUTIES.

EMPLOYEE WAS USING A SLEDGE HAMMER TO DRIVE A PIN INTO THE TRACK OF A 235 CAT EXCAVATOR WHEN A PIECE OF THE PIN BROKE OFF STRIKING AND LODGING IN THE EMPLOYEE'S LEFT LEG.

EE WAS REPAIRING A HOE ON THE CAT 235 EXCAVATOR THE HOSE SLIPPED CAUSING A FLANGE O RING TO CUT THE MIDDLE FINGER ON HIS RIGHT HAND

EMPLOYEE WAS HELPING TO INSTALL A SET OF ROLLERS ON THE IMPACTOR CONVEYER. HE TURNED TO GET A PRY BAR, AFTER DOING SO HE BEGAN TO COMPLAIN OF PAIN IN HIS BACK. HE CONTINUED TO WORK HIS SHIFT T HAT DAY. WENT TO THE DOCTOR 1-7-2000, AND WAS DIAGNOSED WITH A STRAINED BACK MUSCLE. TOLD TO STAY OFF WORK A FEW DAYS AND GIVEN PAIN MEDICATION.

EMPLOYEE WAS WORKING ON 980C LOADER BUCKET WHEN HE HIT HIS LEG ON THE BUCKET CUTTING EDGE. THIS CAUSED A SEVERE BRUISE TO HIS LOWER RIGHT LEG. HE WAITED UNTIL 11/30/99 BEFORE HAVING IT EXAMINE D. THE LOWER RIGHT LEG AND ANKLE WERE X-RAYED AND A DIAGNOSIS OF A SUPERFICIAL HEMATOMA WAS IDENTIFIED.

EE WAS OPERATING CAT 988B LOADER. HE WENT TO REMOVE A STRAP FROM THE CROSS BAR ON THE LOADER WHEN THE STRAP FLEW LOOSE STRIKING HIS LOWER LIP. THE METAL END OF THE STRAP PUNCTURED HIS LOWER LI P AND LOOSENED HIS 2 FRONT LOWER TEETH.

EE WAS OPERATING A AIR CHUCK AIR BLOWER BLOWING OUT THE AIR FILTERS ON THE IMPACT CRUSHER WHILE DOING SO A SMALL PIECE OF METAL BLEW INTO HIS RIGHT EYE. THIS WAS ON FRIDAY WHEN EE WOKE UP ON M ON AM HIS EYE WAS SWOLLEN. HE WENT TO THE LOCAL CLINIC IN GRAYSON & WAS SENT TO AN EYE SPECIALIST IN ASHLAND WHERE THE METAL PARTICLE WAS REMOVED

EE WAS TIGHTENING IMPACT CRUSHER LOCK DOWN USINGA 2" WRENCH. THE WRENCH SLIPPED MASHING FINGER (RIGHT INDEX) BETWEEN IT & THE BELT COVER. EE WAS TAKEN TO ER WHERE HE RECD 2 STITCHES & THE FIN GER WAS CLEANED & BANDAGED. IT WAS ALSO X-RAYED & FOUND TO A SMALL BONE CHI[

EMPLOYEE WAS PERFORMING HIS PRE-SHIFT EQUIPMENT CHECK ON THE HITACHI 550 EXCAVATOR. WHILE WALKING ON THE CATWALK, HE SLIPPED AND HIS FOOT LODGEDIN THE HAND HOLDER. HE LOST HIS BALANCE AND FELL BACKWARDS ONTO THE TRACK, BREAKING HIS RIGHT LEGIN TWO (2) PLACES.

EMPLOYEE WAS USING A HAMMER AND DRIFT PIN TO REMOVE OLD BUSHINGS OUT OF THE LIFT CYLINDER. THE HAMMER GLANCED OFF THE DRIFT PIN STRIKING THE SMALL FINGER ON HIS LEFT HAND.

EMPLOYEE WAS WALKING DOWN A RAMP AT SCALEHOUSE OFFICE WHEN HE STEPPED ON A SMALL ROCK. THIS CAUSED HIS FOOT TO GO OUT FROM UNDER HIM. WHEN THISHAPPENED IT CAUSED HIM TO SPRAIN HIS LEFT KNEE.

A COMBINATION OF A BROKEM STEP AND MUDDY BOOTS CAUSED THE EMPLOYEE TO SLIP AND FALL, INJURING HIS LEFT ELBOW AS IT STRUCK THE STEP.

FOOT SLIPPED OFF ROCK TRUCKS STEP. FELL AGAINST BUMPER. OFF 2 DAYS

LABORER STEPPED OFF PIPE ONTO GROUND - STEPPED DOWN 17 TO 18 INCHES - TWISTED OR BROKEN ANKLE.

DROPPED A TRACK PAD ON HIS FINGER.

LOADER HIT THE ROCK TRUCK AND INJURED JUMPED OFF OF IT.

MOVING ROCK OFF OF TAILGATE AND TAILGATE SLAMMED SHUT.

TRIPPED OVER RUG ON FLOOR.

GOT THE CABLE PULLER ON HAND.

FORIEGN OBJECT IN EYE.

OLD FOOTBALL INJURY TO HIS BACK.