I WAS CUTTING SCRAP WHEN MY CLOTHES CAUGHT ON FIRE. FIRST AND SECOND DEGREE BURNS OF LEFT SIDE OF BACK.
Commercial Mine Coal
MSHA sampling at Commercial Mine shows respirable coal dust averaging 0.01 mg/m3 (100% compliant) across 1 samples, plus the mine's fatality, citation, and penalty record.
Watch this mine
Email me when a new MSHA incident is filed at Commercial Mine.
- Fatalities
- 0
- Total incidents
- 8
- Years on record
- 1983–1997
- Latest incident
- Jun 1997
ⓘ
This rate is recorded citations divided by MSHA inspection hours, per 100 hours. It reflects inspection effort, not mine size or production.MSHA sampling at Commercial Mine shows respirable coal dust averaging 0.01 mg/m3 (100% compliant) across 1 samples.
ⓘ
A sample is a point in time compliance measurement, not an individual exposure history. These figures describe MSHA sampling records and do not establish causation or personal dose.ⓘ
Respirable coal dust and silica figures cover coal facilities. Dust compliance is measured against the current 1.5 mg/m3 standard; samples predating the 2014 standard are included, so compliance rates are a coarse historical signal.ⓘ
Citations per million reported employee-hours. Rates begin in 2000, when MSHA's quarterly employment data starts; earlier incidents are counted but cannot be rate-adjusted. Quarters under 100,000 reported hours are greyed: too few hours for a stable rate.| Quarter | Hours worked | Citations | S&S | Per 1M hrs |
|---|---|---|---|---|
| 2000 Q2 | 2,540 | 0 | 0 | 0.0 |
| 2000 Q1 | 3,089 | 0 | 0 | 0.0 |
Reportable incidents
8 on file1997 · 1 incident
1993 · 1 incident
EMPLOYEE CHANGING DRAGLINE DUMP CABLE, USING SLEDGE. A CHUNK OF STEEL CAME OFF AND WEDGED IN HIS LEG.
1991 · 3 incidents
GREASE CAN WITH SHARP LID STRIKING OUT. EMPLOYEE WAS WALKING BY IT. HIS RIGHT ARM RAN AGAINST THE SHARP LID AND MADE A 1 1/2" DEEP CUT OUTSIDE OF RIGHT HAND.
EMPLOYEE WAS HOLDING A TOOTH ON A DRAGLINE BUCKET. ANOTHER EMPLOYEE WENT TO TAP THE TOOTH UP A LITTLE BIT HIGHER WITH A 16PD SLEGE HAMMER. 1ST EMPLOYEE'S FINGER SLIPPED OVER THE EDGE OF THE TOOTH CAUSING THE SLEDGE HAMMER TO SMASH HIS FINGER INTO THE TOOTH.
WHILE SLEDGING TRACK PIN ON 4600, BAR MISSED HOLE & EMPLOYEE HIT FINGER ON DRAGLINE TRACK.
1989 · 1 incident
ROCK FELL OFF HIGHWALL & HIT EMPLOYEE'S HARD HAT WHILE HE WAS OPERATING A HOIST.
1983 · 2 incidents
FELL ON WET SNOW BRUISING RIGHT ARM & SHOULDER.
WHILE CLIMBING OFF DOZER EMPLOYEE SLIPPED ON GROUSERS AND MISSED STEPPING ON PUSHARM AND STRAINED HIMSELF AS HE LANDED ON GROUND THERE WAS A DELAY IN REPORTING THE INCIDENT AS EMPLOYEE ORIGINA LLY THOUGHT INJURY WAS A COMPLICATION FROM A RECENT VASECTOMY
The full compliance file on Commercial Mine
A dated report covering the 26-year penalty trail, line-item violation pattern, contest and docket posture, rate-normalized peer benchmark, and full fatality history. Delivered as a PDF with the underlying data as CSV.