MSHA record for Kings Mountain Flotation Mill (mine ID 3101122). Fatalities, non-fatal incidents grouped by year, current operator and controller, and mine context.
Email me when a new MSHA incident is filed at Kings Mountain Flotation Mill.
EMPLOYEE APPARENTLY HAD HIS BELT AND CLOTHING TO BECOME ENTANGLED ON SHAFT CAUSING CONSTRUCTION TO CENTER OF BODY RESULTING IN DEATGH
EMPLOYEE WAS HE5PING TO INSTALL A NEW DRISCO PIPE LINE AT THE KREBS CYCLONE TOWER BEHIND THE MILL. HE WAS SUPPORTING THE PIPE ON HIS SHOULDER SO HE COULD LINE THE FLANGES WHEN HE FELT PAIN IN HIS RIGHT SHOU5DER. HE REPORTED TO FOREMAN IMMEDIATELY BUT DID NOT GO TO THE DOCTOR UNTIL LATER.
EMP WAS GREASING #3 ROD MILL BY POURING HEAVY OIL FROM A CUP THROUGH A GUARD OVER THE MAIN DRIVE GEAR WHILE STANDING ON A HANDRAILED STEPPED PLATFORM HE LOST HIS BALANCE AND FELL AGAINST MOTOR HOUSING HE SCRATCHED HIS LEFT LEG AND LATER ON 5 16 85 STATED THAT HE HAD HURT HIS BACK ALSO WHEN HE FELL
EMP HAD COMPLETED INSTALLING INJUECTOR IN EUCLID WHEN HE SLIPPD ON LADDER AND HIT HIS LEFT INDEX FINGER ON THE SHARP EDGE OF FAN
EE WAS MOVING OXYGEN BOTTLE INTO WROK AREA TO REPLACE EMPTY CYLINDER. WHILE WALKING BACKWARDS EE TRIPPED OVER BROKEN CONCRETE LOST HIS BALANCE & WAS STRUCK IN T HE GROIN BY THE END OF THE B OTTLE
EMPLOYEE WAS IN THE PROCESS OFINSTALLING AN ELECTRIC HOIST TO REMOVE MOTOR FROM #2 SALA PUMP. HE ATTEMPTED TO LIFT HOIST AND STRAINED HIS LOWER BACK.
EE WAS WORKING ON FEED SCREW FOR CHEM SPOD DRYER WHEN PANEL HOLDER FELL DOWN CHUTE STRIKING HIM ON RT FOREARM LACERATION REQUIRED 7 STITCHES.
EMPLOYEE WAS REMOVING A BLOCKAGE IN THE ORE TUNNEL CHUTE, HE WAS PULLING ON THE GATE TO ALLOW SOME LARGE ROCKS TO PASS WHEN HE FELT A POP AND A STINGING PAIN
EMPLOYEE WAS REMOVING BLOCKAGE IN ORE TUNNEL CHUTE. HE FELL AND SCRATCHED THE TOP OF HIS LEFT HAND REINJURED HIS BACK
EMPLOYEE WAS WORKING ON CELLS #3 WHEN HE SLIPPED OFF PADDLE SHAFT INTO CELLS, HITTING HIS RIGHT KNEE, HIP AND SHOULDER.
EMP WAS SHARPENING HIS KNIFE TO SKIN SOME WIRE WHEN THE KNIFE SLIPPED AND CUT HIS MIDDLE FINGER ON LEFT HAND LACERATION REQUIRED 5 STITCHES
EMPLOYEE WAS ASSISTING WITH LOADING A TRUCK WITH GABBED MATERIAL AT DRY GRIND. HE ATTEMPTED TO EMP. WAS ASSISTING WITH LOADING A TRUCK AWITH BAGGED MATERIAL AT DRY GRIND. HE ATTEMPTED TO PIC K UP ONE SIDE OF A DOCK PLATE AS CO-WORKER WAS DRIVING THE FORKLIFT UNDER IT. HE SPRAINED HIS LOWER BACK.
REPLACING FUSE INSIDE SUB-STATION WHERE LIGHTNING HAD BLOWN OUT FUSE AND LIGHTNING PROBABLY RAN IN AGAIN WHILE EMPL WAS CHANGING FUSE.
EMPLOYEE WAS WORKING ON DIAPHRAM PUMP REPLACEMENT. AS HE WAS MOVING PUMP INTO POSITION FOR SETTING, HE SPRAINED HIS LOWER BACK.
EMPLOYEE WAS REMOVING AND REINSTALLING LIFTER BARS INSIDE 3 ROD MILL IT WAS A SMALL AREA WHERE EMPLOYEE HAD TO BEND OVER IN AN AWKWARD POSITION TO WORK
A dated report covering the 26-year penalty trail, line-item violation pattern, contest and docket posture, rate-normalized peer benchmark, and full fatality history. Delivered as a PDF with the underlying data as CSV.