Lincoln Park Stone Stinesville Quarry: 138 MSHA citations Metal/Non-Metal

Employee was changing the skirting on the 53 x conveyor when EE's hand slipped and hit the tail pulley guard causing a 1" cut to EE's right palmar surface. Fabricated tail pulley guard.

Confirming audiogram on 8/9/19 showed a standard threshold shift.

Confirming audiogram on 8/9/19 showed a standard threshold shift.

Pulled on a hose and it cut the arm had to get 5 stitches.

Employee was ascending the catwalk to reach the #2 conveyor when their foot slipped. Employee swung their arm out to stabilize themselves and in doing so struck the 53X chute with a flat head on blow. (No cut, laceration or puncture). Employee said they thought they were fine but condition worsened.

Aggravation of injury reported on 5/1/13. Employee twisted knee while installing silt fence aggravating his knee injury. Went to Dr on 7/17/13 who told him to take 2 days off work, then report to work with no restrictions. This report is submitted to add 2 missed days to the accident.

Employee was fueling his excavator and while waiting for it to fill the wind blew dust into his right eye.

EE was stepping off of a mini excavator and twisted his knee.No real pain or discomfort at time so he didn't call the accident in. Called 2 days later to say he had pain. Sent him to clinic and the diagnosed a strain. He returned for a follow up exam and they requested a MRI. MRI revealed he had a torn meniscus so today he was scheduled for surgery on 5/9/13.

Employee was stooping over to go under the #6 conveyor (en-route to repair a flashing on the # 2 conveyor hopper) when his hard hat fell off. He picked the hard hat up then stood to replace it and struck his head on the conveyor framework.

Employee was removing rocks from a plugged cone crusher when a rock became dislodged and struck his finger. Employee suffered a fractured distal phalange on his left ring finger.

EE was cutting a hole in belting when the knife went through the belting while being drawn over the belting and cut the EE's right thigh.

EE was walking behind his haul truck in the parking lot to retrieve a grease gun and said his knee just gave out. The surface was smooth with no obstructions.

EE was placing a roll of belting (to be used on a conveyor) onto the fork lift and when he removed his pry bar it pinched his finger. (Pry bar did the pinching). The fork lift was not in motion, cut caused by the pry bar.

Employee was using a cutting torch to cut a piece of steel(on his back beneath the work) and a piece of hot metal entered his ear canal.

Employee was cleaning rock spillage in the screen room with another employee (shoveling rocks back onto the screen surface). The other employee threw a rock toward the screen and struck the employee on top of the head. Employee states hard hat had fallen off as he was coninually reaching down.

Employee was in a jaw crushers hammering a piece of steel to flatten it out when he missed and struck the side his foot. fractured the most distal phalanpe of his r. pinky toe.

EE was digging soil from a footing he was forming. When he rotated to throw the dirt from his shovel, his foot did not pivot causing him to twist his knee. The injury did not bother him for over a week before the pain began to intensify. Became reportable today 11/2/06.

Employee was winding a garden hose up and when swinging his hand back to retreive more hose it struck the corner of an electrical box that had a bent area on it. The bent corner cut his hand.

A U-belt had jumped a pulley and EE was pulling on the belt while another employee was prying the belt over to the next pulley when the shaft went over center catching EE's hand between the belt and the pulley.