Nason Plant #1 Metal/Non-Metal

Slipped on dragline hurt back. But didn't report it until Tuesday May 30th 2017.

Truck driver crawled in trailer to clean access material from trailer.

EE was working on the dragline... slipped and fell on the catwalk landing on his left elbow.

EE was breaking Flexco lacings off the conveyor belt with a Flexco chisel and a hammer. A piece of the hammer shattered as he was striking the chisel and a piece went into his abdomen.

EE was replacing some lacings on his conveyor belt. He was using a hammer and chisel to split the lacings, when a small piece of the hammer broke off and struck EE in the left chest.

EE slipped when exiting the conveyor ladder, causing skin to be taken from his lower left leg. Initial first aid/wound care was given at time of reporting to his supervisor. EE refused to go to te doctor at that time.

EE fell off ladder while working on plant. EE fractured right wrist.

EE turned to get wrench and hit his elbow on the door latch.

EE slipped on a conveyor catwalk and hurt knee.

while driving out a pin, a piece of steel came off and stuck into left hand

EE WAS INJURED WHILE WORKING ON A CONVEYOR. WE WERE ADJUSTING ROLLERS BECAUSE WE HAD JUST PUT A NEW CONVEYOR BELT ON. EE SAW SOME MUD ON THE BOARD ROLLER ON THE TENSIONER & HE REACHED INSIDE THE GUARD TO CLEAN IT & THE BELT GRABBED HIS ARM & PULLED IT BETWEEN THE ROLLER & THE BELT. I HAD JUST TAKEN THE LOCK-0UT OFF SO WE COULD TURN THE BELT ON TO ADJUST ROLLERS.

FEET WERE SOAKED FROM DAYS PRIOR AND THIS DAY WHILE WORKING IN AND AROUND RECENT FLOOR WATERS. POSSIBLE CONTAMINATION CAUSED CELLULITIS.

WALKING DOWN CONVEYOR-FOOT SLIPPED AND KNEE POPPED.

ACCESSING DRAGLINE HE STRAINED A MUSCLE.

REMOVING MOTOR FROM OLD CONVEYER TO INSTALL NEW ONE, CONVEYER FELL WITH EMPLOYEE ON IT. ALL SAFETY PROCEDURES WERE BEING FOLLOWED.

CHANGING SCREENS ON SHAKER. FRACTURED ONE LEFT RIB.

EE WAS LIFTING PVC PIPE, COMPLAINED ABOUT PAIN IN LOWER RIGHT SIDE.

EMPLOYEE SLIPPED AND HURT HIS RIGT HIP WHILE DEGREASING PLANT.

STEPPED ON PIN WHILE GETTING OFF BED OF TRUCK.

CLEARING BRUSH WITH BULLDOZER-BEGAN FEELING BAD.

GREASING UNIT D-421 TRIPPED ON TIRE RUT. STRUCK RIGHT JAW ON DRAGLINE TRACK.

CUTTING CONVEYOR BELT WITH KNIFE. KNIFE SLIPPED & CUT LEFT WRIST. 4 STITCHES WERE TAKEN.

WIND BLEW OBJECT IN LEFT EYE HE WAS GETTING IKN WATER WAGON TO WATER AREA

TRYING TO PUT TIRE AND HUB ON R-25 EUC. ROLLING TIRE AROUND, TIRE FELL PINNING LEFT FOOT UNDER TIRE.

WALKING TO FEEDER BELT TO CLEAN HE STUMBLED AND FELL.

DETTING OFF 945-LOADER-MISSED STEP AND BROKE LEFT ANKLE.

SLIPPED ON WET FLOOR OF DRAGLINE HITTING COMPRESSOR BRUISING LEG.

OPERATING DRAGLINE WHEN RIGHT KNEE TWISTED.

KICKED BACK OF MOWER TO KICK OFF GRASS. FOOT SLID UNDER MOWER.

MOVING DIRT WITH LOADER-STOPPED TO TALK TO BOSS-GOT OFF LOADER STEPPED IN HOLE. FELL BACKWARD AND HUR TLEFT ANKLE.

HELPING PUT STARTER ON 945-B FRONT END LOADER. AHD COMPLETED JOB WHEN HE STARTED TO COMPLAIN THAT HE COULD NOT TURN HIS HEAD.

GETTING ON HIGHLIFT,FOOT SLIPPED.HE FELL AND HIT RIGHT SIDE ON CORNER OF DOOR.CRACKED RIB ON RIGHT SIDE.

HANDING METAL PLATE TO WELDER.PLATE SLIPPED & CUT RIGHT INDEX FINGER IN KNUCKLE JOINT.

MOVING RAILCARS FOR LOADING WHEN HIS EUCLID TRUCK HE WAS DRIVING WAS HIT BY THE RAILCARS. HE DID NOT STOP TO CHECK IF RAILCARS WERE MOVING.

CHANGING HOIST BRAKE BAND ON 190-D HE WAS LIFTING BAND ON 10-21-89 KNOT FORMED IN LOWER GROIN AREA REPORTED PAIN ON 10-24-89 TAKEN TO DR

CUTTING BRACE ON CONCRETE STACKER LEG. BRACE HAD PRESSURE WHEN HE CUT IT, IT FLEW UPWARDS AND STRUCK HIM ABOVE LEFT EYE.

PULLING TRAVEL GEAR ON 190-D DRAGLINE. WAS LOOSENING SEAL ON GEAR WHEN WRENCH SLIPPED AND CAUGHT CORNER OF GEAR. CUTTING RIGHT HAND.

WORKING ON DRAGLINE WHEN THE WIND BLEW SOMETHING IN HIS EYE

HELPING REMOVE TRACK FROM 155-KOMATSU DOZER WHEN HIS BACK STARTED TO HURT.

STANDING ON BACK OF EUC WORKING ON BIN WHEN HE SLIPPED AND FELL TO THE GROUND.