Hamilton Gravel: 18 MSHA citations Metal/Non-Metal

EE HAD A SERIES OF PULLING MOTION OVERHEAD PULLING 10 AND 6 ARMOUR CABLE ON A SPOOL UNDERNEQATH CATWALK WHILE STANDING ON CONCRETE FELT SOMETHING POP IN SHOULDER.

EE WAS INSTALLING A PLATE 24"X10" ON 5 X10 DIESTER SCREEN WHILE GETTING INTO SCREEN TO INSTALL PLATE EE PULLED MUSCLE IN LEFT SHOULDER WHILE PULLING SELF INTO SCREEN

EE SAID HE WAS PUSHING CONCRETE COUNTERWEIGHTS THAT ARE FASTENED TO CONVEYOR BELT TO THE RIGHT TO LINE THE BOLT UP FOR GUIDE PIPE WHEN HE SAID HIS RIGHT KNEE POPPED.

EE SAID HE WAS LIFTING UP A 1 1/2" DRAG CABLE TO INSTALL ON THE DRAGLINE WHEN HE NOTICED HIS RIGHT SHOULDER STARTED HURTING.

INJURED FINGERS ON RT HAND WHILE REPLACING V-BELT. (NOTE: DRIVE WAS NOT IN OPERATION AT TIME OF ACCIDENT).

EMPLOYEE WAS ASSISTING THE UTILITY MAN TO REPLACE A RETURN ROLLER ON A CONVEYOR. HE WAS USING A BAR TO HOLD UP THE BELT AND STRAINED A MUSCLE IN HIS LOWER BACK.

EMP WAS WALKING ACROSS PIT ROAD AND RIGHT ANKLE TWISTED CAUSING SPRAIN.

EE CLIMBED THREE FLIGHTS OF STAIRS & WHEN HE REACHED THE TOP HE COLLAPSED & WENT UNCONSCIOUS. PLANT EE CALLED 911 WHILE ANOTHER PLANT EE STARTED FIRST AID. EE WAS THEN TANSPORTED TO THE HOSPIT AL.

EE WAS GOING TO NEXT FLOOR DOWN TO GET SCREEN PANEL & HAMMER OUT OF GRIT CHUTE. AS HE STARTED AROUND STEPS HE TRIPPED ON A PIECE OF 3" X 7" X 8' MC CHANNEL WHICH WAS LAYING ON FLOOR BESIDE STE PS & BUMPED LEFT ELBOW ON SAFETY HAND RAIL FOR STEP.

LARGE ROCK WAS BLOCKING CHUTE & OPERATOR WAS ATT EMPTING TO REMOVE IT & HIS FINGER BECAME TRAPPED BETWEEN THE ROCK & THE SIDE OF THE CHUTE RESULTING IN HIS MIDDLE RT FINGER BEING SMASHED & CUT

EE WAS WORKING ON THE SCREEN BEARINGS ON THE 8' X 16' DEISTER. WIPED HIS EYES WITH HIS ARMS MUST HAVE HAD METAL SHAVINGS ON HIS ARMS. WIPED IT INTO HIS EYE.

RATCHET SLIPPED OFF BOLT HEAD BUMPING CHIN ON HANDRAIL CAUSING JAW TO SHUT & CHIPPED TEETH VERY SMALL CHIPS FROM THREE TEETH

OPENING CHUTE COVER EMPLOYEE WAS STRUCK IN THE NOSE BY A ROCK.

WORKING IN HOPPER UNDER 41/2CONE CRUSHER CLEANING OUT BUILT UP MATERIAL FROM AROUND CRUSHER HOUSING THAT WAS WHEN I NAME FIRST NOTICED HIS BACK HURTING THIS WAS BEFORE NOON ON 5TH OF DEC 1989 SOMETIME IN THE AFTERNOON I NAME CLIMBED FROM A CONCRETE LEDGE AROUND THE CONE CRUSHER TO A KNEE BRACE TO GET DOWN FROM THE KNEE BRACE

EMPL WAS USING LADDER TRUCK TO GAIN ACCESS TO SMALL HOPPER THE BASE BOLTS PULLED OUT THREW THE TFLLOR AND LET THE LADDER PIVOT FORWAR AND DOWN

WHILE IN A SITT3NG POSITION EMPLOYEE PULLED ON GATE LEVER TO OPEN GATE TO ALLOW MATERIAL TO FLOW INTO TRUCK.THE GATE STUCK AND EMPLOYEE JERKED HANDLE WITH BOTH HANDS TO FREE GATE PULLING MUSCL E IN RIGHT SIDE3OF LOWER BACK.

EMP WAS STANDIN1 ON ENGINE HOOD USING WATER HOSE TO FILL RADIATOR - SLIPPED ON F ROST AND TWISTED LEFT SIDE AND LOWER BACK

EMPLOYEE WAS AT7EMPTING TO DRIVE RUBBER SLEEVE TO A PIPE HE HIT A GLANCING BLOW AND SLEDGE HAMMER BOUNCED BACK AND STRUCK RT SHIN BETWEEN ANKLE AND KNEE CAUSING BRUISE

EMP WAS GREASIN1 BEARING ON MAIN CONVEYOR IN SAND PLANT. THE BOLT BROKE ON ANGLE IRON THAT HE WAS USING AS A HAND HOLD. VIBRATION HAD REDUCED SIZE OF BOLT

EMP WAS UNPLUGG3NG CRUSHER TUNNEL HOPPER USING 3 FT CROWBAR HE WAS HIT WITH CROWBAR WHICH HE WAS USING TO PRY ROCKS LOOSE IN F EEDER ROCKS BROKE LOOSE LETTING CROWBAR FLY BACK STRIKING HARD H HAT AND EYEBROW3

CUTTING LOADER 6UCKET POINT FROM SHORT HEAD C RUSHER USING TORCH, WEARING CUTTING GOGGLES, RESPIRATOR. HOT STEEL DROPPED ON LEFT WRIST ON OUTSIDE OF ARM APPROX 2" FROM HAND