Belle Center Plant Metal/Non-Metal

EE came to work on 3/30/09 and told his supervisor he was hurt. At that time, he was told to go to the doctor. He did not report any injury to Ohil Stone, Inc on 3/26/09. His Dr report says that was the injury date.

Was tearing 3' crusher apart, had to remove overflow chute. When pulling on it to dislodge the chute, rocked back onto little finger, cutting finger.

Employee was getting silo unplugged with a pry bar when the material let loose and smashed and cut his finger between the pry bar and metal on side of conveyor.

Employee broke left thumb.

Greasing loader dropped screwdriver and it rolled under front axle. Retrieved screwdriver and hit back of head on bolt on front axel.

PULLING CROSS SHAFT OUT OF SCREEN HOUSING. LOWERING SHAFT FROM ONE CATWALK TO ANOTHER USING SLINGS TO LOWER SHAFT. WHEN SHAFT WAS ABOUT 2' FROM CATWALK, EE HAD HOLD OF SLING TO STEADY IT. SLIN G SLIPPED OFF OF SHAFT & LANDED ON HIS LEFT FOOT. SAID HE WAS FINE & DID NOT NEED A DOCTOR. BUT WENT LATER TO ER FOR XRAYS. NOTHING WAS BROKE.

WAS PUTTING NEW SCREENS ON DECK, SLIDING SCREEN DOWN INTO THE DECK HAND HIT TOP DECK SHARP EDGE WHERE STONE FALLS THRU SCREEN DECK, CUT RIGHT MIDDLE FINGER WAS WEARING COTTON GLOVES WENT TO EMERGENCY ROOM GOT 8 STITCHES WENT BACK TO WORK

WHILE STOCKING STONE IN VOLVO HAUL TRUCK, EE STEPPED OUT OF TRUCK AND SLIPPED ON STONE THAT WAS ON THE GROUND. HE LOST BALANCE AND FELL, HITTING KNEECAP AGAINST STEEL I BEAM THAT SUPPORTS THE PLANT.

AFTER REMOVING WELDING HOOD TO HIT SLAG WITH SLAG HAMMER, EE DID NOT PUT ON SAFETY GLASSES.

SHAFT FELL FROM FORKLIFT WHILE PUTTING IT IN PRESS.

PRIMARY CRUSHER CONTROL BUILDING AND CONTENTS ENTIREY DESTROYED BY FIRE DURING NON-WORKING HOURS. PER SUBSEQUENT INVESTIGATION. IT APPEARS FIR EMAY BE THE RESULT OF A LIGHTENING STRIKE. NO INJURIES REPORTED.

MOVING AND CUTTING TREES. ONE FELL WHILE MOVING IT AND DROVE A THORN INTO KNEE.

LOST CONTROL OF PRY BAR RESULTING HITTING LEFT HAND ON BOLTS DOING DAMAGE TO LEFT HAND RING FINGER.

WELDING FRAME, WELDING WAS STARTED BEFORE EE HADA CHANCE TO PUT HIS SHIELD DOWN. WELDING BURNS TO BOTH EYES, CAUSES ILRRITATION.

CHAIN CAUGHT IN TAILGATE OF DUMP TRUCK. FINGER WAS CUT WHILE TRYING TO RELEASE CHAIN.

ADJUSTING CRUSHER, TOOK A BREAK, LEANED AGAINST CAT WALK. RAIL GAVE WAY AND FELL.

LOADING BARRIER WALL ON TRAILER. STEPPED OFF BACK OF TRAILER & FELL.

INSTALLING METAL OVERHEAD, PARTICAL OF DUST LODGED IN RIGHT EYE.

REPAIRING CONVEYOR ON MAIN PROCESSING PLANT. SMASHED MIDDLE FINGER ON RIGHT HAND. REPORTED TO OFFICE ON 12/20/93. SENT TO DR. ART COSTIN AT BELLOFONTAINE, OHIO ON 12/20/93.

EMPLOYEE WENT TO CLIMB UP IN BODY SECTION OF RRK #187, HE PLACED HIS FOOT IN THE STEP & THE OTHER FOOT ON TRK BODY FLOOR-WHEN HE WENT TO FULLY STAND UP HIS FOOT SLIPPED & HE FELL LANDING ON LE FT LOWER LEG. THERE IMMEDIATELY APPEARED A LARGE KNOT UNDER SKIN. THE KNOT WAS APPROX SIZE OF ORANGE. HAD X-RAY & RETURNED TO WORK.

THEY WERE PICKING UP A MOTOR WEIGHING BETWEEN 450-500 POUNDS. DID NOT REALIZE MOTOR WAS THAT HEAVY. WILL USE MORE CAUTION. LOWER BACK STRAIN RESULTED.

MOVING A STEEL SHELF TO WELD STEEL REPAIR OVER WINDOW IN SHOP.TOO HEAVY FOR ONE PERSON.NOTICED RPAIN IN LOWER ABDOMEN.HERNIA-RIGHT SIDE OF NAVEL.