DBA: Greer Lime Company Metal/Non-Metal

Maintenance crew was working to free up an outrigger pad on the UV 11 blasting truck that had seized to the shaft. The crew was using a strap hooked to the maintenance truck to pull on the seized pad. When the pad broke free, it spun approximately 180 degrees on the shaft and mashed the employee's fingers.

Employee was trying to help install a rotary airlock on the primary separator at kiln 1 baghouse when the airlock shifted on the forklift and pinched EE's right index finger between the flange of the airlock and the chute it was being attached to.

Employee was moving the basket of a powder rig from the face and swinging it towards the rib. EE let go of the controls, lost balance, grabbed the basket guardrail instead of the basket handrail and pinched right hand fingers between the rib and rail. This smashed EE's right hand middle finger and caused a laceration.

Employee climbed onto 850 Exc to speak with superintendent. Upon leaving 850, employee moved to change 3pt contact. Lifted wrong foot, slipped and fell approx 5'-6' to the ground. Incurred injury to right heel. No life threatening injury. No foreign material on platform.

Employee was performing work under a platform, caught EE's hard hat on the corner of the platform which caused EE's hard hat to fall off. At that time the employee struck EE's head leaving a gash on the top of EE's head in EE's hairline.

While attempting to place and weld a metal bracket for support a Porta Power slipped and caught hand.

The guard was removed from the ring gear and the cause of the fire was determined to be from oil leaking onto the hot kiln causing the oil to reach flash point and catch fire. The fire was discovered at approx. 5:50 AM during shift change and fire extinguishers were used to control and put out the fire.

Oil that lubricates the ring gear leaked onto the kiln which was determined to cause the ignition of the oil. The ring gear was fully guarded and the fire was under the guard. 911 was called immediately along with both Federal and State regulatory agencies. There was minimal damage found. There were no injuries.

Employee was unplugging spout #2 on the hydrate bin with a metal rod when the slide gate somehow closed and caused the rod to kick back into employee's hand. This caused a laceration that was handled with first aid before employee went to the doctor to get 3 stitches.

EE was cutting plastic shrink wrap off of a pallet of gear guard parts. EE cut the plastic with a pocket knife using right hand. EE reached down to pull the plastic from the pallet with left hand. There was a piece of the plastic that had not been cut. EE pulled the plastic with left hand, and when the plastic broke free left thumb contacted the knife blade.

loading a shot, lifted a wooden loading pole out of the hole, strain to right elbow

While cleaning out a duct pipe, the plugged lime "puffed" up. Heat and lime surrounded the employee and lime went around the glasses into eyes.

Employee was dismounting truck and when foot hit the ground, EE felt knee pop.

Employee's glove was caught by clips on stacking conveyor and pulled into the pinch point between conveyor belt and stacking platform.

A hydrate bag fell off the end of the hydrate bag conveyor belt and busted when the bag hit a corner of a wood pallet. The bag busted causing hydrate lime to go into the employee's eyes. It went into the right eye more than the left eye. It caused eye irritation for which the employee was prescribed ointment and eye drops.

Employee received steam burns to both hands while opening sampling door on the hydrator.

Driving up the lime dump road the operator of the articulated truck noticed an orange glow coming from the right back corner of the truck cab. The driver then got out, discharged EE's fire extinguisher, and called on the radio for help. Two other employees brought up 5 fire extinguishers, emptied them, and called the fire department. The fire department extinguished the fire.

When the spout at the Hydrate Bagging Machine was plugged the employee went to open it while under pressure and lime released from the spout getting into the employee's eyes.

While cleaning frozen mud off of the gate of the diverter at the secondary screen the employee struck left hand against the door of the diverter.

While filling up hydrate lime bags, the machine malfunctioned and had to be reset. While going to reset the machine, the bag being filled burst causing hydrate lime to get into the employee's right eye causing irritation. The employee was wearing safety glasses at the time of the incident.

Employee was cleaning ash rings in the kiln when a piece of lime got into the employee's eye causing irritation. The employee was wearing safety glasses at the time of the incident.

Employee was walking back to his truck when he slipped on wet lime. The employee landed on his forearm and shoulder. No first aid or medical treatment was administered at the time of the accident. Later a torn muscle in the shoulder was diagnosed.

Driver became dizzy while strapping down a load of bagged rockdust. She then passed out as another employee was helping her.

After taking a drink of soda from the refrigerator the employee felt like the drink was caught in her throat and passed out hitting her head on the window sill. She received two staple stitches at the ER.

Employee was installing conduit and brackets for conduit onto a block wall. He was using a hammer drill to drill pilot holes for the conduit brackets. Lime dust on the ceiling fell on top of him. Some of the dust entered his right eye causing a burn to his cornea and conjunctival sac

Employee was walking from portable plant to break room by quarry shop for lunch. He slipped in snow and fell backwards and hit his head on the ground. His hard hat fell off as he was falling.

The employee got his left index finger caught between the bag conveyor platform and the bag conveyor head pulley while reaching for a empty bag that came across the conveyor.

Walking down a small incline and slipped in wet lime. Tore muscle in the upper left leg.

Employee standing on platform of D10 dozer putting hydraulic oil into dozer. Fell from position to ground, approximately 7 feet. Lacerated right leg below knee. Cut to back of head. Bruises/contusions to right arm and elbow. No life threatening injuries. No foreign material on platform.

Driver was walking from truck to loading facility when he stepped on rock twisting left ankle.

While attempting to open a plugged air line by taking a quick connect fitting off the pressure on the air line pushed dust into the operator's eye.

The operator dropped the white belt conveyor tray interrupting the proximity switch to remove a bag that was jammed. When he reached in to remove the bag the valvomat dropped down onto the operators wrist/hand pinning his hand between the valvomat and the white belt conveyor tray.

EE fell to the floor and struck his head on concrete. EE does not remember any details of the accident.

EE was tightening a bolt when wrench slipped off bolt. Hand hit flight of screw.

Subject had built a fire to get warm. He turned his back toward the fire and got too close and a spark caught his clothing on fire.

EMPLOYEE WAS CUTTING A BELT WITH A KNIFE AND THE KNIFE SLIPPED AND CUT HIS LEFT LEG.

HYDRATED LINE WAS STUCK IN THE LIME CHUTE. EE TRIED TO LOOSEN THE LIME BY SHAKING THE CHUTE. THE LIME RELEASED ALL OF ONCE AND SPRAYED EE IN RIGHT EYE. RESULT CHEMICAL EYE BURN.

EE WAS ATTEMPTING TO SERVICE THE WATER TRUCK AT END OF HIS SHIFT. HE HAD CLIMBED ON THE FRONT BUMPER, HAD RAISED THE HOOD & HIS RIGHT HAND SLIPPED OFF THE HAND HOLDS CAUSING HIM TO FALL BACKWA RDS. HE ATTEMPTED TO CATCH HIMSELF WITH HIS HAND

EE HAD PULLED UNDER THE ROCK DUST TANK AND WAS PREPARING TO LOAD AND HE PUT ON HIS SAFETY HORNESS AND WAS ON HIS TANK GOING TO HOOK UP HIS HARNESS TO THE CABLE. HE SLIPPED AND FELL OFF OF HIS TANK STRIKING THE CONCRETE PIER CLOSE TO THE GROUND HE FRACTURED HIS RIGHT WRIST, RIGHT KNEE AND RECIEVED FACIAL FRACTURES OF HIS LEFT SIDE.

LIFTING A STEEL PLATE AND PINCHED 5TH DIGIT FINGER.

EE BUMPED HIS NOSE WHILE CLIMBING A STEP LADDER.HE WALKED INTO SAFETY HAND RAILING. THE LADDER WAS PERMANENTLLY FIXED AT THIS LOCATION.

EMPLOYEE FELL ON CAT WALK INTO THE HAND RAILING STRIKING HIS RIBS ON THE RAILING. ICE AND HEAVY SNOW CONDITIONS.

EMPLOYEE WAS FILLING DIESEL TANK AT THE KILN WHEN A PIECE OF ICE FELL FROM THE ROOF OF THE BUILDING AND STRUCK HIM ON THE SHOULDER.

THE COAL DIVERTER GATE WAS STUCK AT TAHE KILN. THE EE PINCHED HIS FINGER IN ATHE ARM MECHANISM OF THE CYLINDER & DIVERTER GATE. THIS OCCURRED WHEN THE EE GRABBED THE GATE ARM WHILE AIR WAS STI LL APPLIED TO THE CYLINDER.

WHILE SCALING COAL ASH DOWN FROM KILN PIECE FELL OUT & FOOT .

EMPLOYEE WAS REPAIRING SKIRT RUBBER ON A CONVEYOR WHILE WORKING OUT OF A HIGHLIFT BUCKET HIGHLIFT MOVED FORWARD & PINNED THE EMPLOYEE AGAINST THE CONVEYOR

EMPLOYEE WAS REPAIRING SKIRT RUBBER ON A CONVEYOR WHILE WORKING OU T OF A HIGHLIFT BUCKET HIGHLIF T MOVED FORWARD PINNING THE EMPLOYEE AGAINST THE CONVEYOR

EMPLOYEE WAS STRUCK BY A 3/8IN 4X8 METAL PLATE WHILE ATTEMPTING TO TURN IT OVER

EMPLOYEE WAS CUTTING PLATING FOR A CHUTE WHEN HE SLIPPED DOWN FROM THE CHUTE TRANSFER HE BURNED HIS WRIST WITH THE TORCH

DRILLING SHOT HOLES AT GUARRY WHEN THE HAMMER FELL OFF THE ROTARY DRILL AND FELL ON EMPLOYEES HAND.

EMPLOYEE WAS WORKING PUTTING REBAR IN A PIER HE CLIMBED OUT OF A DITCH & THEN RETURNED TO THE WORKING AREA WHEN HE SLIPPED & TWISTED HIS BACK

STEPPED OFF A LADDER AND SLIPPER ON COAL AND FELL ON CONDUIT PIPE INJURYING RT SIDE OF LOWER BACK

WHILE SHOVELING A PALLET LOAD OF KILN BRICKS OFF THE FORKS, WHICH WERE ATTACHED TO A PAYLOADER BUCKET, THE BRICKS TILTED BACKWARDS AND CAUGHT THE BAR WHICH SHOVED HIS HAND AGAINST THE PAYLOADE R AND TOOK THE SKIN OFF OF HIS THUMB.

EMPLOYEE TRIPPED AND CAUGHT HIMSELF WITH LEFT ARM CAUSING A MUSCLE STRAIN

THE VICTIM WAS 6AGGING HYDRATE LIME & THE BAG BRUSTED. THE LIME THEN SPRAYED INTO VICTIM'S EYES. THE VICTIM HAD A SHIELD ON BUT IT STILL WENT UP UNDERNEATH THE SHIELD.

SLIPPED ON A WA7ER SPILL.AS HE WENT DOWN HE HIT HIS RIGHT HAND ON THE RAILING.LIME AND WATER TOGETHER IS VERY SLICK.

FINGER GOT CAUG2T BETWEEN BELT AND SHOUT.WHERE YHYPLORTED BAGS ARE LOADED.

HYDRATED LIME S1RAYED INTO EYE

PUTTING LOCK PI3 DOWN TO LOCK TURN-TABLE ON POWER SHOVEL WHEN IT JUMPED BACK OUT OF SLOT AND PUSH HAND UP AGAINST FRAME OF CAB.

VICTIM WAS PROC9EDING TO CUT THE TOP OUT OF A 55GAL.OIL DRUM WITH A TORCH AND IT EXPLODED.UPON INVESTING THE DRUM HAD BEEN LABELED GAS IN BLACK LETTER'S.

THE VICTUM HAD BURNT LIME TO SPRAY INTO EYES.

WAS CUTTING WITH A TORCH AND A PIECE OF SLAG SLIPPED IN ALONG SIDE OF TONGUE AND BURNT FOOT.

THE VICITM WAS RUNNING UP A FLIGHT OF STEPS AND MISSED A STEP AND CAME DOWN ON HIS HEEL AND PULLED THE MUSCLES IN HIS LEG

THE VICTUM WAS SHOVING ON A CONBYOR BELT WHICH IS ON WHEELS AND SPRAINED HIS WRIST.

MASHED FINGER BETWEEN CONVEYOR BELT AND RAMP WHILE TRYING TO REMOVE A LODGED BAG OF ROCK DUST.

THE VICTIM STARTED DOWN THE LADDER WHEN HE SLIPPED & FELL. THIS WAS WHAT THE VICTIM SAID. THERE WERE NO WITNESS. HE STARTED THAT AFTER HE SLIPPED HE COULDN\T REMEMBER ANYTHING. BACKING IS PROV IDED ON THE LADDER.

THE MINER WAS BAGGING HYDRATE LIME WHERE AT BUG BURSTED AND LIME WAS BLOWN INTO EYES GOGGLES WERE BEING WORN BUT THE MINER HAD LIFTED HIS GOGGLES OF TO SEE THE GUYS ON THE FLAT WHEN BAG BURSTED AND LIME WENT INTO EYES

THE TRUCKER STEPPED OFF OF THE END OF A FLAT TRILER. HE LANDED ON HIS HEAD AND SHOULDER. HE WAS NOT LOOKING WHERE HE WAS STEPPING.

STARTED TO STEP ON BACK OF END OF A FLAT TRAILER AND JUST AS THE VICTIM STEPPED THE TRAILER PULLED OUT FROM UNDER HIM ND HE FELL ON BACK

THE VICTIM TRIPPED OVER A PIECE OF ANGLE IRON AND SPRAINED HIS ANKLE.

THE EE GOT DUST IN HIS EYE WHILE BAGGING HYDRATE LIME.