South Weber Pit Metal/Non-Metal

Tripped over boards which had tipped over into walkway causing him to stumble and hit ribs on a metal table. Did not seek medical attention for several days. Condition did not improve.

Lab technician got out of his pickup to speak with operator at mine and slipped on the ice and strained right shoulder. Initially treated as first aid injury and technician returned to work without restrictions. Pain continued and work restrictions were put in place for technician restricting use of arm.

Clearing rocks from crusher frame under jaw, he lost footing and fell into rocks and shovel.

STEPPED OFF A CEMENT BLOCK ONTO A LARGE ELECTRICAL CORD AND TURNED ANKLE.

STEPPED ONTO TRACK OF DOZER TO CLEAN SILT OFF TRACK AND SLIPPED.

JACK HAMMERING

SLIPPED WHILE WALKING

WIND BLEW DUST PARTICLE INTO EYE.

CLEANING OUT MATERIAL WEDGED IN V BELT ON MOTOR, MOTOR WAS SHUT DOWN, PULLED ON BELT FINGERS GOT BRIDGED BETWEEN PULLEY AND BELT.

CLEANING OUT FROM UNDER CRUSHER WIND BLEW DIRT IN EYES

EMPLOYEE SHUT PLANT DOWN TO REMOVE ROCK FROM CONVEYOR. AFTER REMOVING ROCK, JUMPED DOWN AND TWISTED HIS KNEE (LEFT KNEE).

GROUND WAS SNOW COVERED AND ICE UNDERNEATH EMPLOYEE STEPPED OFF LOADER AND FELL, INJURING LEFT SHOULDER.

WAS MOVING TAIL3PULLEY TO LOOSEN BELT FINGER GOT CAUGHT BETWEEN PULLEY AND BELT FRACTURING IT

WAS LIFTING CUT7ING EDGES TO REPLACE ON 950 LOADER HURT LOWER ABDOMEN CAUSING HERNIA.

WAS SPLICING BE5T ON CONVEYOR AND SLIPPED INJURING LEFT SHOULDER AND LEFT HIP

EMPLOYEE WAS CH5NGING CHUTES ON CRUSHER THE CHUTE SLIPPED CATCHING HAND BETWEEN PIECES OF METAL

EMPLOYEE WAS UN1LUGGING FEEDER ON CRUHSER HE INJURED THE LIGAMENTS ON HIS LEFT KNEE

EE EBNT DOWN & PICKED UP A PIECE OF STEEL & PULLED SOMETHING IN H IS NECK.

EE WAS CLEANING GRIZZ BAR WITH A PRY BAR BAR GOT CAUGHT & FLIPPED SMASHING EES 2 MIDDLE FINGERS.

EMPLOYEE WAS CLEANING UNDER A CONVEYOR BUMP HIS HEAD ON A FRAME OF THE CONVEYOR CUT ON HEAD HARD HAT FELL OFF.

EMPLOYEE WAS ADJUSTING THE CONE CRUSHER AND THE JACK SLIPPED AND HIT HIM ON THE SIDE OF HIS FACE.

EMPLOYEE WAS STRIPPING A PIECE OF WIRE THE KNIFE SLIPPED AND CUT HIS HAND BETWEEN THE THUMB AND FOREFINGER

EMPLOYEE WAS REPAIRING A TAIL PULLEY HE HIT HIS LEFT THUMB WITH THE HAMMER

WHILE EMPLOYEE WAS BACKING LOADER HE EXPERIENCED VERTIGO WHILE EXITING THE LOADER HE FELL AND INJURED HIS RIGHT THUMB

EMP WAS DIGGING A DITCH USING A D8 CAT, WENT OVER A PILE OF DIRT AND WAS THROWN AGAINST THE CAB. HIS NOSE WAS INJURED BUT HE DIDNT SEE A PHYSICIAN AT THAT TIME, HAS DECIDED AS OF PRESENT DATE HE NEEDS TO SEE A PHYSICIAN

A PIECE OF METAL FELL IN THE CONE CRUSHER CAUSING IT TO STOP OPPERATION EMP WAS USING A WRENCH IN PROCESS OF REMOVING THE METAL FROM THE CONE THE WRENCH SLIPPED AND MASHED HIS FINGER BETWEEN T HE WRENCH AND THE BELT GUARD ON THE EQUIPMENT

MAN WENT UNDERNEATH FEEDER TO CLEAN OUT ROCKS HIT HIS HEAD ON A STEEL BEAM AND CUT IT HARD HAT FELL OFF

EMPLOYEE WAS ON CONE CRUSHER AND JUMPED OFF. HE TURNED HIS ANKLE WHEN HE HIT THE GROUND CAUSING A HAIRLINE FRACTURE OF THE LEFT TIBIA AND TORN LIGAMENTS IN LEFT ANKLE. THE PLANT WAS NOT RUNNIN G AND NO SAFETY DEVICES WERE INVOLVED. EMPLOYEE CONSULTED DOCTOR ON APRIL 24, 1983.