Amrize Utica Stone Plant Metal/Non-Metal

DESCENDING LADDER EE FELL. FAILURE TO MAINTAIN 3 POINT CONTACT.

WHILE SETTING CONCRETE BLOCKS FOR THE RAMP TO THE WEST SIDE OF THE JAW, THE HOOK BEING USED TO LIFT THE BLOCKS SLIPPED. THE BLOCK LANDED ON THE BOTTOM ROW OF BLOCKS AND ROLLED OFF, PINNING EE TO THE GROUND AND BREAKING HIS RIGHT LEG BELOW THE KNEE.

EMPLOYEE WAS IN THE FEEDER ON THE LOWER HOLE CRUSHING PLANT CLEANING THE GRIZZLY AND SLIPPED AND FELL. HIS KNEE LANDED ON A ROCK INJURING IT.

PERSONAL POSTURE.

WHEN USING A HAMMER AND PUNCH A PIECE OF STEEL FROM HAMMER FACE CHIPPED OFF AND WENT INTO MY KNEE.

UTILITY KNIFE SLIPPED WHILE CUTTING RUBBER BELTING FOR A CONVEYOR RESULTING IN DEEP CUT ON LITTLE FINGER OF LEFT HAND. THE CUT REQUIRED STUTCHES TO STOP THE BLEEDING.

STEAM CLEANING ENDLOADER AND GRABBED THE LADDER ON THE MACHINE AND A SHARP PIECE OF METAL ON THE LADDER CUT HIS HAND.

WHEN REMOVING CRUSHER WEAR PARTS FROM CRUSHER, EE HURT HIS BACK.

MOVING TRACK DRILL FELT PAIN IN MIDDLE BACK AND NECK AREA

INSPECTING EQUIPMENT. THOUGHT LEFT EYE HAD DUST PARTICLE IN IT, UNTIL THAT EVENING. THEN NOTICED RUSTY OBJECT STUCK TO FRONT OF EYE.

ADDING FLUID TO MACHINE AND SLIPPED OFF LADDER WENT TO DOCTOR ON 04-09-92.

WENT UP A CONVEYOR TO REMOVE A BROKEN PIECE OF STEEL.ON RETURN I STEPPED OVER A MOTOR MOUNTING STAND AND PROCEEDING DOWN,I STEPPED ON AN ANGLE IRON SUPPORT,SLIPPED AND HIT MY LEG JUST BELOW MY KNEE CAP.

EMPLOYEE TIGHTENING BOLTS IN SCREEN WHEN IRON RAIL FELL AND HIT EMPLOYEE'S BACK. THE CLAMP BARS NOT PROPERLY PLACED WHILE WORKING ON SCREEN PLANT.

RECONNECTING DIFFERENTIAL MAIN BEARING.DRIVE SHAFT SWUNG TO THE LEFT AND CAUGHT LEFT HAND BETWEEN FRAME AND DRIVE SHAFT.HAND SWOLLEN AND BRUISED.X-RAYS SHOW NO BROKEN BONES.

WRENCH SLIPPED ON BOLT AND HIT HIS ELBOW.

RUNNING BULLDOZER PUSHING DIRT.

WHILE CLEANING IN AN AREA APPROXIMATELY 12 FT BY 18 FET AND APPROXIMATELY 6 FT HIGH THERE WAS A SHEET OF STEEL 4 FT ABOVE AND IT FELL ONTO HIS THIGH WITH OUT ANY WARNING.

WHILE REMOVING TOOTHPOINT ON LOADER BUCKET HE WAS HITTING PUNCH WITH HAMMER TRYING TO REMOVE PIN THAT HOLDS THE TOOTH ON BUCKET.

LOST GRIP ON PIPE CAME TO REST ON HAND CAUSING INJ

POUNDING TOOTH CAPS PINS OUT OF TOOTH CAP PIECES OF STEEL AND CUT LEFT SIDE OF FACE NEAR CHIN.

DURING COUGHING SPASM BUMPED R RIBS ON CORNER OF COUNTER

REMOVING CRUSHER WEAR PARTS BUMPING THEM WITH SLEDGE IN ORDER TO GET THEM OUT.SMALL SPLINTER BROKE OFF AND ENTERED INTO LEG.

FLOOR OF QUARRY WAS MUDDY. PERSON SLIPPED WHEN HE WAS ENTERING MACHINE & BUMPED LEG ON EDGE OF BUCKET OF SKID LOADER. RESULTEDIN CUT ON LEG APPROX 2 1/2" LONG.

HIT A BUMP WHILE DRIVING A ROCKER

REMOVING GUARD RAIL AND FELL- INJURED ELBOW.

I WAS LIFTING ONE END OF AN IRON BAR, WHILE THE OTHER END WAS STILL ON THE EDGE OF THE PLANT WHILE HOLDING ON THE ONE END, I PULLED THE BAR SO THE OTHER END WOULD SLIDE OFF OF THE PLANT WHEN T HE END ON THE PLANT LANDED ON THE GROUND I KEPT HOLD OF MY END THAT IS WHEN I PULLED THE MUSCLES IN MY BACK THE IRON BAR WEIGHS APP 200 TO 300 LBS.

WORKING ON A MO7OR IN A SEMI TRAILER AND WAS COMING DOWN THE LADDER. TURNED ON THE BOTTOM STEP, ANKLE WAS TWISTED AND HE FELL TO THE GROUND.

ROLLING ROCKS O0F GRIZZLY; STRAINED BACK. CLEANING ROCKS FROM TOP OF HOLDING BIN. FALL ON GRIZZLY.

ROLLING ROCKS O0F GRIZZLY STRAINED BACK CLEANING ROKKS FROM TOP OF HOLDING BIN

BREAKING LARGE 9OCK WITH SLEDGE HAMMER AND PIECE OF ROCK BROKE OFF AND STRUCK LEFT LEG. HE WAS GETTING ROCK THROUGH JAW.

DEGENERATIVE DI8C TO BACK LIFTING HEAVY ITEMS IN LINE OF DAILY WORK.

475 MICHIGAN LO5DER AND 621 CAT S/ATHEY REAR DUMP BACKED INTO EACH OTHER THEY NEVER SAW EACH OTHER