Ormrod Quarry Metal/Non-Metal

Laceration to thumb requiring stiches. During LOTOTO, employee stepped into help with project installing v-belts on CV7 conveyor. EE pulled the belt, and it got caught on EE's thumb.

EE was operating a 988K PL0105 wheel loader, digging in the muck shot and sending loads to Primary Crusher. As EE was digging in the muck pile, EE hit a tight spot which caused the loader to jar/jolt, and the EE strained EE's lower back.

EE was installing a right-side, A motor V-Belt guard on a HP400 Crusher. EE hung a 44" X 37", 20lb piece of guard onto the fastener bolts. As EE was lining up the bottom right-side fastener, the guard came unhooked from top left fastener. This caused the guard to swing down and pinch EE's left hand between the guard and angle support, bruising EE's left hand.

Miner was shoveling stone and sand off floor in tunnel and putting it on conveyor belt. After shoveling, EE said had pain in the back of the right shoulder.

EE was washing screen tower walkways with a 1-1/2" rubber water hose. EE finished washing off plant and disconnected hose from water line 1-1/2" camlock couplers. When removing hose fitting from pipe water sprayed out hitting them in the left eye. EE washed the eye but still felt discomfort, was seen by a panel physician and has an abrasion on the cornea and received prescription.

EE was walking down a slight incline along the side of a roadway, EE slipped on loose stones and fell forwards onto EE's knees as EE fell, EE caught self with EE's right arm spraining EE's right shoulder and causing a contusion on both knees

Employee was operating a Volvo A35D Articulated truck when the truck slid in a tire rut. The operator had right hand on the wheel and left hand on the grab rail. The sudden movement jerked employee's body to the right causing pain in left shoulder.

Employee was loading shot rock when the loader hit a tight area causing the loader to bounce back, straining his lumbar area.

Employee was hitting a ware plate on a dozer blade with a sledge hammer when a sliver of steel chipped off and struck him in the right thigh.

Employee was removing a fuel drum from the bed of a pickup truck, when his left upper arm was struck by the drum, causing a tear to the arm muscle.

EMPLOYEE STEPPED OFF A BACKHOE & TWISTED HIS LT. ANKLE WHEN HE PLACED IT ON UNEVEN GROUND.

EE S RIGHT HAND WAS CUT WHEN IT CAME INTO CONTACT WITH SHARP METAL EDGE ON BROKEN EQUIPMENT.

THE EMPLOYEE WAS DESCENDING A LOADER. THE EMPLOYEE SLIPPED OFF AND FELL TO THE GROUND INJURING HIS HEAD, LEFT SHOULDER AND BACK.

WHILE CLEANING OUT PRIMARY CRUSHER, EE HAND SLIPPED OFF ROCK CAUSING HIM TO FALL ON ROCK AND FRACTURE HIS RIBS.

EMPLOYEE WAS CLEANING BIG ROCKS FROM THE CATWALK AFTER A SPILLAGE. A ROCK SLIPPED OUT OF HIS HAND AND LANDED ON HIS FOOT BEHIND HIS SAFETY SHOES.

INJURY OCCURRED WHEN THE OPERATOR OF THE BACKHOE BACKED INTO THE REAR OF THE BIN TRUCK CAUSING THE TRUCK TO SHAKE AND EE FEL FROM THE TRUCK. (HE SLIPPED OFF THE STEPS ONTO LANDING).

EMPLOYEE WAS CUTTING A FACE PLATE IN #5 SCREEN BY-PASS BIN. STEEL PLATE SPRUNG LOOSE AND CAUGHT EMPLOYEE'S HAND AND WRIST, PUSHING IT AGAINST BACK PLATE.

EE WAS FUELING UP CAT TRUCK. WHILE PULLING FUEL HOSE UP ONTO THE TRUCK, HE SLIPPED & FELL ONTO HIS BACK & SKINNED THE BACK OF HIS HEAD.

WHILE CHANGING A LIGHT BULB THE BULB BROKE & PENETRATED THE LEFT FOREFINGER CAUSING EMPLOYEE TO RECEIVE TWO STITCHES TO CLOSE OUT

EMPLOYEE WAS USING A HAMMER AND A PUNCH.HIS HAND SLIPPED OFF PUNCH AND HIT THUMB WITH HAMMER.

PUTTING STEEL IN BUCKET AND STEEL CAME BACK AND HIT L HAND

EMPLOYEE WAS REMOVING SKIRTING ON #2 BELT & WALKED INTO CROSS-BEAM

RELINING CHUTES.

EMPL WAS HOISTING STEEL WHEN STEEL FELL ON FINGERS

CHANGING SCREENS

LOADING BIN TRUCKS UNDER BINS

PULLING BIN HANDLE TO LOAD BIN TRUCKS.

CHANGING GREASE BARREL.

ADJUSTING BRAKES ON QUARRY TRUCK AND BRAKE FLUID SPRAYED IN BOTH EYES.

MOVING OIL DRUMS WITH HAND TRUCK, SLIPPED AND HIT HAND ON ROCK.

PUTTING TWO RUBBER HOSES TOGETHER AND A BAND OF METAL THAT HOLDS THE END OF HOSES TOGETHER CUT HIS INDEX FINGER OF LEFT HAND.

EMPLOYEE WAS REMOVING CLEVIS (SHACKLE) FROM CRUSHER TUB AFTER CRANE SET IT IN PLACE. WHEN CLEVIS WAS RELEASED, EMPLOYEE DID NOT HAVE FIRM GRIP ON CABLE AND IT RECOILED AND CLEVIS STRUCK UPPER LIP AND RIGHT CHEEK BONE.

(NAME) THE YARD3LOADER OPERATOR,WAS PARKED IN THE VICINITY OF THE WASHED SAND PILE.HE WAS GOING TO GREASE HIS CAT 966 LOADER(UNIT #805).AS HE WAS IN THE PROCESS OF COMING DOWN THE METAL LOADER STEPS,HE APPAR9NTLY SLIPPED AND FELL TO THE GROUND ON THE RIGHT SIDE OF THE LOADER TOWARD THE SSTOCKPILE. HE WAS CONSCIOUS AT ALL TIMES AND FELLOW WORKER,(NAME) WHO WAS IN THE PROCESS OF GREA