PLANT #4 Metal/Non-Metal

Holding onto the door frame when the second employee shut the door and cut EE's finger.

Taking brace off of plant, bolt was stuck and the brace smashed left hand

Changing drill steel on drill.

Removing a bolt with air gun, bolt spun in the other hand causing the injury.

Miner dropped an electric drill on his hand Thursday 5/24/2012. Results of his injury was a break to his hand. He did not tell his supervisor or seek treatment until he returned to work on 5/25/2012. Office was notified on 5/29/2012 that he will be off work until the hand is healed.

Employee rolled a rock off haul road to remove from travel area, strained a muscle, did not seek treatment at that time. That night he went to the dr. for pain & was released with instructions to use ice and Tylenol as needed. He went to the dr. night of 6/21, referred to Des Moines for further treatment, diagnosed torn bicep muscle 6/22 first missed day Scheduled for surgery 6/28

Loader/scale operator running loader experienced pain in lower back. Did not report to office untill 3/30/2009. Went to doctor on 3/31/09, was released back to work with a 25 lb weight restriction.

Employee was lifting drive shaft from loader with chain hoist. Weight shifted and caught finger between shaft and loader.

Running levers five years ago lead to carpal tunnel. *Please see attachment* EE had surgery on 7/24/07 & returned to work on 8/3/07.

Employee was dismounting his truck and caught his arm in the hand rail and twisted his left shoulder.

Employees' were lifting an 8'brace up to position it to be chained to loader bucket. Ground was wet & muddy, brace slipped & fell on EE's arm.

EMPLOYEE'S WERE IN THE PROCESS OF CHANGING SCREENS IN THE SCREEN PLANT AND EMPLOYEE CUT HIS RIGHT LITTLE FINGER ON A STEEL FLANGE. THIS CUT REQUIRED 10 STITCHES.

EE WAS REMOVING BREAKING BAR IN BREAKER AND HIT HIS RIGHT FOREARM ON A PIECE OF ANGLE IRON CUTTING IT. HE WENT TO DR. AND RECEIVE ONE STAPLE TO CLOSE CUT.

EMPLOYEE AND OTHER EMPLOYEE WERE DRIVING OUT RACES ON A GD ROCK DRILL. EMPLOYEE HAD A HOLD OF PUNCH. AS EMPLOYEE HIT THE PUNCH A SMALL PIECE OF STEEL CAME OFF AND HIT EMPLOYEE IN THE INDEX FIN GER. EMPLOYEE HAD GLOVES ON BUT STEEL WENT THROUGH. BY THE TIME THE DOCTOR PULLED THE STEEL OUT EMPLOYEE NEEDED 2 STITCHES. PUNCH WAS APPROXIMATELY 7" LONG (SNAP ON).

WAITING TO LOAD UNDER A SMALL CONVEYOR.

HAULING ROCK.

EE WAS PREPARING TO REPLACE A SHEAVE ON A CATAPILLAR IMPACT BREAKER MOTOR. THE MOTOR WAS ON THE GROUND & SET OFF TO THE SIDE WELL OUT OF THE WAYOF ANY EQUIPMENT.AS EE WAS FINISHING UP THE SHEA VE REPLACEMENT HE STEPPED BACK A COUPLE OF STEPSAT THIS TIME HE WAS FACING THE MOTOR, NEXT THINGEE KNEW HE HAD TRIPPED OVER SOMETHING LYING ON THE GROUND. AS EE FELL TO THE GROUND HIS HARD HA

DISMANTNLING RI1-RAP SCREENING PLANT.INJ LIFTING ONE END OF 12'' X 12'' X 5'.TO MOVE IT OUT OF THE WAY OF FRONT LOADER WHICHWAS GOING TO LIFT PIECE OF EQUIP.LOADER STOPPED AT THE TIME.OPERATY OR MIS-INTERPRE7ED HANDSIGNAL AND MOVED LOADER HAHEAD HITTING BLOCK OF WOOD AND PUSHING T INTO CONVEYOR PINNING INJ PERSONS HAND BETWEEN BLOCK AND WOOD AND CONVEYOR.