Schildberg ShopsMetal/Nonmetal

Replacing cylinder on loader. Strap on cylinder slipped mashing hand between cylinder and loader frame.

Employee was using a pry bar to pry a tire off a rim.

While using a die grinder, the grinding disk broke shooting a piece of the grinding disk into the employees arm.

Employee scooping snow, twisted and hurt left knee. Went to doc 1/8/10, no treatment. On 1/21/10 he went in for physical therapy. On 1/27/10 he went in for surgery. He missed part of day 1/27/10, and is expected to be off until 2/1/10.

Employee was working on a truck and pulled lower back. Went to chiropractor, released with no restrictions. Received report in office 4/27/2009.

Burning pallets and got a flash burn on arms, face and neck. Went to dr and was treated and released back to work.

EE was unloading parts from truck, a trunion and shaft, when the shaft slipped . He reached out to hold it and pulled a muscle in his upper back.

Employee was welding on catwalk of control booth, when a piece of angle iron fell from above and hit him in the head. Employee was not wearing hard hat due to welding helmet.

Employee was entering NE door of shop when coming in for work. He reported he tripped on a bag next to walkway, landing on right hip.

Years of lifting & standing on concrete.

While using a power washer to clean an oil cooler, employee slipped and the washing nozzle came in contact with the top of his left foot causing a burn & torn skin.

EE WAS WORKING ON TIRES. TIRES WERE SPARES FOR TEREX 3305B. EE WAS ASSEMBLING A TIRE AND HOLDING LOCK RING UP WITH BAR. WITH HIS LEFT THUMB HE WAS PUSHING ""O"" RING INTO PLACE AND THE BAR SLIPP ED AND LOCK SNAPPED DOWN ON THUMB.

EE WAS WORKING ON QUARRY DRILL. THE BOOM WAS OUT AND HE WAS MANUALLY PUSHING BOOM BACK INTO PLACE. HE WAS STANDING ON SOME CAT TRACK NEXT TO DRILL AND WHEN HE STEPPED DOWN HE TWISTED ANKLE CAU SING HIM TO FALL INTO DRILL FRAME.

EMPLOYEES WERE WORKING ON THE ROLLER FRAME OF A QUARRY DRILL AND USED HEAT TO REMOVE A BOLT. THE INJURED EE CAME ALONG TO HELP AND SAW A LARGE NUT LAYING ON THE FLOOR AND PROCEEDED TO PICK IT UP BURNING HIS RIGHT PALM & FINGERS.

EE WAS WORKING ON THE FRONT SPRING OF A MACK TRUCK AND SWINGING A SLEDGE HAMMER. HE TWISTED HIS BACK RESULTING IN A PINCHED NERVE.

EE WAS REMOVING A GASKET FROM THE REAR END PLATE OF AXLE. THE GASKET SCRAPER HE WAS USING SLIPPED, CUTTING HIM ON THE LEFT HAND BETWEEN THE THUMB & FOREFINGER. REQUIRED 2 STITCHES.

EE WAS ATTEMPTING TO SLIDE A TRANSMISSION ONTO THE LIFT GATE OF A SHOP TRUCK AND THRU OUT HIS BACK. INJURY OCCURRED IN TRUCK SHOP.

EE WAS LIFTING THE TAILGATE OF A DUMP TRUCK AND HURT HIS BACK.

EMPLOYEE WAS USING AN AIR CHISEL TO REMOVE BOLTS AND A PIECE OF SLAG BOUNCED BACK AND HIT HIM IN THE LEFT CHEEK. EMPLOYEE WAS WEARING PROPER EYEPROTECTION.

EMPLOYEE WAS STEPPING OUT OF PICKUP & TWISTED HIS BACK CAUSING MUSCLE SPASMS IN UPPER MIDDLE BACK.